Snow Blower Stiga DUO LINE Snow Cube 8218-2234-90 Instructions Manual

41
DEUTSCHDE
3.  Abwarten, bis alle rotierenden Teile zum Stillstand ge-
kommen sind.
4.  Alle Fremdkörper, die in der Schneeschraube hängenge-
blieben sind, entfernen.
5.  Die Aussparungen in der Achse und der Schneeschraube 
aufeinander ausrichten.
6. Die Teile des gebrochenen Bolzens entfernen.
7. Einen neuen Original-Brechbolzen montieren.
8 AUFBEWAHRUNG
Die Schneefräse niemals mit Kraftstoff im Tank in 
einem geschlossenen Raum mit schlechter 
Belüftung aufbewahren. Es können sich 
Benzingase...

42
 ENGLISHEN
1 SYMBOLS
The following symbols appear on the machine. They are 
there to remind you of the care and attention required in use. 
This is what the symbols mean:
Warning.
Read and understand the owner’s manual 
before using this machine.
Disconnect the spark plug wire, and 
consult technical literature before 
performing repairs or maintenance.
Danger - rotating fan.
Danger - rotating auger.
Keep hands out of discharge chute.
Keep hands and feet away from rotating 
parts.
Risk of burns.
Keep...

43
 ENGLISHEN
• Never run the engine indoors except when taking it in and 
out of its place of storage. In this case ensure the door to 
the storage place is open. Exhaust fumes are toxic. 
• Never drive across a slope. Move from the top down, and 
from the bottom to the top. Be careful when changing 
direction on a slope. Avoid steep slopes.
• Never operate the machine with insufficient protection or 
without the safety devices in place.
• Existing safety devices must not be disconnected or...

44
 ENGLISHEN
3.2 UNPACKING
1.  Remove all loose items from the carton.
2.  Cut the four corners of the carton and let the sides fall 
down.
3.  Roll the snow thrower from the carton.
3.3 HANDLE
1.  See fig. 3. Place the handle at the floor, behind the snow 
thrower and hook on the wires into their respective 
handle. Note the wire locations through the recess (W) 
and into the recess (X). Fig. 2 shows the wire locations 
when the assembly is finished.
2. See fig. 4. Assemble the upper screw (A) with...

45
 ENGLISHEN
4.10 GEAR LEVER (4)
The machine has 5 forward gears and 2 reverse to regulate 
the speed. 
The gear stick must not be moved if the driving 
clutch lever is depressed.
4.11 CLUTCH LEVER- DRIVING (6)
Engages the wheels when put into gear and the lever 
is pushed towards the handle.
Situated on the right side of the handle.
4.12 CLUTCH LEVER- AUGER (7)
Connects the auger and fan when the lever is pushed 
down towards the handle. 
Situated on the left side of the handle.
4.13 ADJUSTMENT LEVER...

46
 ENGLISHEN
6.  When the engine starts, reset the choke until it is fully 
open.
5.5 STOPPING
1.  Release both clutch levers. Note. If the snow thrower 
continues rotating - see 7.6 below.
2. Close the fuel cock (3).
3.  Set the stop switch (13) in position “OFF”.
5.6 STARTING
1.  Start the engine as above. Let the engine run a few 
minutes to warm before use.
2.  Set the chute deflector.
3.  Turn the adjustment lever and set the deflector to throw 
the snow in the direction of the wind.
The gear stick...

47
 ENGLISHEN
6.6 LUBRICATION
No service must be carried out before: 
- The engine has stopped. 
- The cable has been disconnected from the spark 
plug.
6.6.1 Linkages
See fig. 15. Lubricate the linkages below every 10:th hour of 
use and before long time storage. Use 10W oil.
• Lever bearings
• Drive belt tension arm
• Auger belt tension arm
6.6.2 Gearbox
No parts inside the gearbox are to be lubricated. All bearings 
and bushings are permanently lubricated and require no 
maintenance.
Lubricating these...

48
 ENGLISHEN
When the belts are adjusted or replaced, the control wires 
must also be adjusted (see below).
7.4 REPLACING THE AUGER BELT
The auger drive belt (K) is shown in fig. 16.
1.  Disconnect the starting cable from the spark plug.
2.  Remove the belt protective cover by loosening the two 
screws. See fig. 17.
3. Loosen the six screws and dismantle the bottom plate. 
See fig 18.
4.  Remove the left wheel.
5. See fig. 19. Dismantle the spring (O) and stop screw (N)
6.  See fig. 19. Unscrew the...

49
 ENGLISHEN
Spare parts are available at your retailer and service station.
When ordering spare parts: Specify the model, year of 
purchase, the engine model and type number.
10 PURCHASE TERMS
A full warranty is issued against manufacturing and material 
defects. The user must carefully follow the instructions given 
in the enclosed documentation.
Exceptions:
The warranty does not cover damage due to:
- Neglect by the user to acquaint themselves with 
accompanying documentation
- Carelessness 
-...

50
 FRANÇAISFR
1  SYMBOLES
Les symboles suivants figurent sur la machine. Ils attirent 
votre attention sur les dangers d’utilisation et les mesures à 
respecter. 
Explication des symboles :
Avertissement.
Veuillez lire attentivement le mode 
d’emploi avant d’utiliser l’équipement.
Débrancher le câble de bougie et consulter 
la documentation technique avant toute 
intervention de réparation ou de mainte-
nance.
Danger – ventilateur en rotation.
Danger – fraise en rotation.
Écarter les mains de...