Singer Serger Professional 5 Manual

 
   
  
  5. Continue to thread points 4-8.  Slip the thread into the middle slot of the  
      thread guide  g.  Go over the take up lever  h.  Continue by slipping the  
               thread into the middle  slot of the thread guides i and  j.  
 
 
  
 
 
 
 
 
 
 
 
 
 
 
 
  6. Before threading the eye of the needle,  make sure the thread is in front
 of  
               the thread guide located on the bottom  of the needle clamp for the Cover  
                Stitch or Chainstitch. 
 
 
 
  7....

 
 
 
 
 
 
 
 
 
 
 
Five-Thread Safety Stitch Wide page 17 
 
   
  
 

 
   
   
   
   
   
   
  
  
                   
 
                                   
Chapter 10:   
 Five-Thread Safety Stitch Narrow       
  
 
 
 
 
 
 
      
 
                             
 
 
 
 
 
 
 
 
 
                                        

 
  
Five-Thread Safety Stitch Narrow 
 
This stitch is a combination of a Two-Thread Chainstitch and a Three-Thread Overlock 
Stitch.  It is suitable for woven fabrics and provides a durable seam for heavy weight 
fabrics such as denim and terrycloth.  Usi ng this strong and stable safety stitch  
eliminates the need to reinforce the seam  with a conventional sewing machine straight 
stitch.  The Pressure Adjust ing Dial makes it simple to sew on all weights of  
fabrics. The Five-Thread Safety Stitch...

 
 
Set at: 
ATD: 
Auto Tension Dial  
            “A” 
Left Cover Stitch 
Needle “C”      Not Threaded 
Middle Cover Stitch 
Needle “D” (Orange)       Threaded  
Right Cover Stitch 
Needle “E”     Not Threaded  
Overedge Left  
Needle “A”     Not Threaded 
Overedge Right  
Needle “B” (Blue)      Threaded 
Upper Looper 
(Green)   Looper Engaged     
  and Threaded 
Lower Looper 
(Red)       Threaded 
Chain Stitch Looper 
(Brown)       Threaded 
Upper Looper Clutch           “L” 
Upper Knife     Engaged...

 
   
   
 
 
 
 
 
 
        Five-Thread Safety Stitch Narrow page 3 
 
 

 
   
   
   
    Five-Thread Safety Stitch  Narrow page 6        
 
  

 
  3. Thread the top cover thread guide by pulling the thread towards the left until 
       it slips under the guide.  Then pu ll the thread along the right side of the  
       button as illustrated.  
 
 
 
 
 
 
 
 
 
 
  4. While holding the thread firmly,  pull the thread between the tension disks. 
 
 
  
 
 
 
 
 
 
 
  5. Turn the handwheel toward you unt il the lower looper extends 5-10mm  
       (approximately ½ inch ) from the needle plate edge.  
 
  6. Thread the looper area of the ma...