Singer Serger Professional 5 Manual

 
   
   
   
   
    Five-Thread Safety Stitch Wide page 6 
 
  

 
  
  3. Thread the top cover thread guide by pulling the thread towards the left until 
       it slips under the guide.  Then pu ll the thread along the right side of the  
       button as illustrated.  
 
 
 
 
 
 
 
 
 
 
  4. While holding the thread, firmly  pull the thread between the tension disks. 
 
 
  
 
 
 
 
 
 
 
  5. Turn the handwheel toward you unt il the lower looper extends 5-10mm  
       (approximately ½ inch ) from the needle plate edge.  
 
  6. Thread the looper area of the ma...

 
  
 7. Thread the hole in the Upper  Looper from front to back k.  Pull about 4  
                 inches of thread through the loope r and place to the back of the  
                 throat plate. 
  
 
 
 
 
 
 
 
 
 
 
 
 
 

 
   
   
  
 4. While holding the thread, firmly,  pull the thread between the tension disks. 
 
 
  
 
 
 
 
 
 
   
  5. Turn the handwheel toward you unt il the lower looper extends 5-10mm  
       (approximately ½ inch ) from the needle plate edge.  
 
  6. Thread the looper area of the mach ine following the red color coded  
       thread guides 4-10.  
 
 
 
  7. Place the thread slighty from left and  
      to the ri ght of threading guide  f. 
 
 
 
 
  8. Place the thread slightly from the...

 
   
   
 Five-Thread Safety Stitch Wide page 10  
 10. Thread the looper eye (A)  from front to back.  Pull about 4 inches of thread. 
                 Position thread into V cutout (B) on thr eader.  Firmly hold thread tail with left   
                  hand and pull Threader lever (C) up into place (D).  
 
 
 
 
   
 
 
 
 
 
 
 
 
 
 
 
 
 
 
  
 
     
 
 
 
 
 
 
NOTE: Make sure the Upper Looper thread is 
behind the Lower Looper thread. 
Threader Lever 
“V” cutout   

 
  
 
4. Turn the hand wheel toward you until  the Chainstitch Looper extends out   
                10mm (approximately ½ inch)  from the needle plate edge. 
 
  
 
 
 
 
 
 
 
 
 
  5. Thread the looper area of the ma chine following the brown color-coded  
               thread guides 4-11.  Us e the tweezers provided in the accessory case to  
               aid in threading the looper. 
 
  6. Place the thread through threading guides  f and  g. 
 
 
           7. Continue threading guides  h, i ,...

 
   
   
  
 
  5. Continue to thread point s 4-8.  Slip the thread into the foward slot of the  
      thread guide  g.  Go over the take up lever  h.  Continue by slipping the  
               thread into the left sl ot of the thread guides i and j .  
 
  6. Before threading the eye of the needl e, make sure the thread is behind
   
               the thread guide located on the  bottom of the needle clamp. 
 
 
 
 
 
 
 
 
 
 
 
 
 
    
 
 
 
 
  7. Thread the eye of the Left Overedge Needle  k....