Sharp MX M363N User Manual

4-80
FACSIMILE
Contents
SENDING TWO PAGES AS A SINGLE PAGE 
(2in1)
Two original pages can be reduced and sent as a single page. This function is convenient when you have a large 
number of original pages and wish to reduce the number of pages sent.
1
Place the original.
When placing the originals, orient them as shown below.
2
Enter the destination fax number.
☞
ENTERING DESTINATIONS (page 4-17)
12
12
12
1
2
Portrait-oriented originals
Landscape-oriented originalsTransmission
Transmission
12
12
1
1
1
1...

4-81
FACSIMILE
Contents
3
Select 2in1.
(1) Touch the [Special Modes] key.
☞SPECIAL MODES (page 4-70)
(2) Touch the [2in1] key so that it is 
highlighted.
(3) Touch the [OK] key.
4
Touch the [Original] key.
5
Specify the orientation in which the 
original is placed.
(1) Touch the appropriate [Image Orientation] 
key.
If this setting is not correct, a suitable image may not be 
transmitted.
(2) Touch the [OK] key.
6
Press the [START] key.
Scanning begins.
 If you inserted the original pages in the document...

4-82
FACSIMILE
Contents
 Transmission is not possible at a size smaller than the original size.
 This function cannot be used in direct transmission mode or when the speaker is used to dial.
 The 2in1 function cannot be used when the original is other than A4, B5 or A5 (8-1/2 x 11 or 5-1/2 x 8-1/2) size.
 When the scan size of the original is specified by numerical values, this function cannot be used.
To cancel 2in1...
Touch the [2in1] key in the screen of step 3 so that it is not highlighted....

4-83
FACSIMILE
Contents
SENDING BOTH SIDES OF A CARD AS A 
SINGLE PAGE (Card Shot)
This function lets you send the front and reverse sides of a card as a single page, without the need to send each side 
separately.
When using card shot, the original must be scanned on the document glass.
1
Place the original face down on the 
document glass.
2
Enter the destination fax number.
☞
ENTERING DESTINATIONS (page 4-17)
3
Select the special modes.
(1) Touch the [Special Modes] key.
(2) Touch the [Card Shot]...

4-84
FACSIMILE
Contents
4
Specify the original size.
(1) Enter the original size.
 Touch the X (width) numeric value display key and 
enter the width.
 Touch the Y (height) numeric value display key and 
enter the height.
(A) To return the original size to the default size, touch 
the [Size Reset] key.
(B) To automatically enlarge or reduce the image size to 
the send size, touch the [Fit to Send Size] key. Do not 
touch this key if you wish to scan the original at the 
original size that you entered....

4-85
FACSIMILE
Contents
7
Touch the [Read-End] key.
If you will continue by scanning the front of the card, you can touch the [Configure] key to change the exposure, 
resolution, scan size, and send size.
 The ratio cannot be specified and Rotation Sending Setting cannot be selected.
 This function cannot be used in direct transmission mode or when the speaker is used to dial.
To cancel Card Shot...
Touch the [Cancel] key in the screen of step 4.
Place next original.       
Press [Start].
When finished,...

4-86
FACSIMILE
Contents
SENDING A LARGE NUMBER OF PAGES
(Job Build)
This function lets you separate an original consisting of numerous pages into sets, scan each set using the automatic 
document feeder, and transmit the pages in a single transmission. Use this function when there are more original pages 
than can be placed at once in the auto document feeder.
When scanning originals that are separated into sets, scan the set that has the first page first. The settings that you 
select for the first set...

4-87
FACSIMILE
Contents
4
Press the [START] key to scan the first set.
To cancel scanning...
Press the [STOP] key ( ).
5
Insert the next set of originals and press the [START] key.
Repeat this step until all originals have been scanned.
To cancel scanning...
Press the [STOP] key ( ). All scanned data will be cleared.
6
Touch the [Read-End] key.
 If no action is taken for one minute after the confirmation screen appears, scanning automatically ends and the 
transmission is reserved.
 The [Configure] key...

4-88
FACSIMILE
Contents
TRANSMITTING ORIGINALS OF DIFFERENT 
SIZES (Mixed Size Original)
This feature lets you scan and transmit originals of different sizes at the same time; for example, B4 (8-1/2 x 14) size 
originals mixed together with A3 (11 x 17) size originals. When scanning the originals, the machine automatically 
detects the size of each original.
This feature can only be used with the following combinations of original sizes:
   
   
 x 17 and 8-1/2 x 14  x 17 and 8-1/2 x 13  x 17 and 5-1/2 x...

4-89
FACSIMILE
Contents
4
Press the [START] key.
Scanning begins. A beep will sound to indicate that scanning is finished.
To cancel scanning...
Press the [STOP] key ( ).
 Once mixed size originals has been selected, an original scan size cannot be specified.
 When mixed size originals are set, automatic duplex scanning cannot be used (When using the MX-M283N.).
 When the mixed size original setting is selected, rotation sending does not operate.
To cancel the mixed size original setting...
Touch the...