Sega Virtua Striker 2002 Kit Installation Service Manual

6www.seuservice.com7www.seuservice.com
Sega Naomi/Triforce System Switch 
Bracket and Speaker Installation 
Diagrams (Figure 3)
Coin Meter
Test Service
Volume 
JAMMA Pin     R
JAMMA Pin    15
JAMMA Pin      1
Yellow Wire from Extra
Harness  (+5v) JAMMA Pin  8
+_
Pin 1
Pin 5
Pin 4
To CN1 of
Amplifier Board
YEL/RED
WHT/REDGRN/RED
From CN2 of
Amplifier Board
From CN4 of
Amplifier Board
GRY/RED
ORG/RED
ORG/BLUE GRY/BLUE Left
Speaker
Right
Speaker 

8www.seuservice.com9www.seuservice.com
Sega Naomi/Triforce 
System JAMMA Harness 
Wiring (JAMMA I/O BD) 
(Figure 4)
4
1
2
3
5
6
7
8
10
11
12
13
14
15
16
17
18
19
20
21
A
B
C
D
E
F
H
J
K
L
M
N
P
R
S
T
U
V
X
Y
Z
a
22
23
24
4
e
d
26
25
c
b
28f
27
9
W
Ground
GroundGround
Ground
+5v (Not Used) +5v (Not Used)
+5v (Not Used)
+5v (Not Used)
(Not Used)(Not Used)
+12v (Not Used)
+12v (Not Used)
KeyKey
Coin Meter 1
Coin Meter 2
(Not Used)
(Not Used)
(Not Used)(Not Used)
(Not Used)
(Not Used)
Video Red
Video Blue...

8www.seuservice.com9www.seuservice.com
1.  HANDLING PRECAUTIONS
   To prevent electric shock or IC Board malfunctioning, be sure to turn off the 
power for the cabinet when installing or removing the IC Board.
   Extraneous matter such as dust on the IC Board can cause the IC Board 
to generate heat and result in a fire due to short circuit, etc.  Ensure the IC 
Board surfaces are always kept clean.
   Keep the IC board well cooled.
      The TRIFORCE and GD-ROM drive are provided with ventilating...

10www.seuservice.com11www.seuservice.com
 JAMMA VIDEO STANDARD references in this manual
    The JAMMA VIDEO STANDARD used by TRIFORCE is abbreviated as JVS in this manual.
    The previous JAMMA STANDARD that used a 56P Edge Connector is referred to here as the 
OLD JAMMA STANDARD.
    Manuals provided with each game may use the one of the following terms when referring to JVS: 
JV STANDARD, NEW JAMMA STANDARD, JAMMA 2 STANDARD. The following terms 
may also be used when referring to the OLD JAMMA...

10www.seuservice.com11www.seuservice.com
2.  SYSTEM SPECS
2 - 1 PARTS INFORMATION
•  The TRIFORCE MAIN BOARD is located inside the SHIELD CASE.
    The TRIFORCE should be used with the MAIN BOARD inside the SHIELD CASE.
(1)DIMM BOARD CASE (MEDIA BOARD)
(2) CONNECTOR BOARD: Refer to "2-2 CONNECTOR BOARD"
(3)I/O PANEL: Refer to "2-3 I/O PANEL"
(4)VENTILATION OPENING
(5)COOLING FAN OPENING
(6)KEY CHIP SLOT
(7)GD CABLE CONNECTOR
(8)ETHER CABLE CONNECTOR: not used by this game
(9)RS232C CABLE...

12www.seuservice.com13www.seuservice.com
2 - 2 CONNECTOR BOARD
J3-J5:     Not used by this game
               (If a connector is connected  carelessly, the board can emit smoke or catch fire.)
J6:          DC Power Supply Input (JST VL 6P)
               1: (N.C), 2: +3.3V, 3: +5V, 4-6: GND
J7:          DC Power Supply Input (JST VL 8P)
               1: (N.C), 2: +3.3V, 3: +5V, 4: +12V, 5-8: GND
PSW1:    Used as the TEST BUTTON
PSW2:    Used as the SERVICE BUTTON
DIPSW: Used for changing the video...

12www.seuservice.com13www.seuservice.com
2 - 4 DIP SWITCHES (DIPSW)
Be sure to check the DIP SWITCH settings before powering on the cabinet.
Since switches 1-3 are not used, set them to OFF.
 Monitor Direction Setting
    Use DIP SWITCH #4 to set the game screen direction (horizontal or vertical).
    Refer to the manual included with the game and select the appropriate setting.
    Use the HORIZONTAL (#4 OFF) setting for this game.
        DIPSW 4 OFF:            HORIZONTAL
        DIPSW 4 ON:...

14www.seuservice.com15www.seuservice.com
2 - 5 REPAIRS and CARTON BOX
Follow the instructions below when sending the TRIFORCE or GD-ROM DRIVE for repairs.
The  CARTON  BOX  included  with  the  kit  will  be  used  for  repair  requests,  so  keep  it  in  a  safe 
place.
 The following sets should be used when sending units out for repair.
(1)TRIFORCE (with DIMM BOARD CASE attached)
 Do not remove the KEY CHIP before sending the TRIFORCE for repair.
(2)TRIFORCE (without DIMM BOARD CASE)
  Remove the...

14www.seuservice.com15www.seuservice.com
Remove the CD DRIVE bracket.
FIG. 2 . 5 b
CARTON BOX
601-11031 

16www.seuservice.com17www.seuservice.com
(1)Screen Display
Monitor Direction
Horizontal Sync Frequency
15/31 kHz
(2)Control Panel
HORIZONTAL
PLAYER 1PLAYER 2
8WAYS
SW1
SW3
SW2
START SW
1P2P
8WAYS
SW1
SW3SW2
2 - 6 GAME SPECS
When connecting 2 cabinets (2 I/O BOARDS) for versus play, connect the PLAYER 1 
CONTROL PANEL wires to the 1P side of the I/O BOARD closest to the TRIFORCE and 
the PLAYER 2 CONTROL BOARD wires to the 2P side of the I/O BOARD farthest from the 
TRIFORCE.
(3)Required Operating...