Sanyo Projector Plv 60 User Manual

							41
This symbol on the nameplate means the product is Listed by Underwriters
Laboratories Inc.  It is designed and manufactured to meet rigid U.L. safety standards
against risk of fire, casualty and electrical hazards.
APPENDIX
WARNING :
High voltages are used to operate this projector.  Do not attempt to open the cabinet.
If the problem still persists after following all operating instructions,
contact the sales dealer where you
purchased projector or the service center.Give the model number and explain the difficulty.  We will advise you
how to obtain service.
Remote Control Unit
does not work.Check the batteries.
Make sure nothing is between the Remote Receiver and the Remote Control Unit.
Make sure you are not too far from projector when using the Remote Control Unit.
Maximum operating range is 16.4’ (5m).
Make sure the code of the Remote Control is set to conform to projector.
(See “SETTING” section on page 36, 37.)
Problem:Try these Solution 
						

							42
APPENDIX
1.35 TFT Active Matrix type, 3 panels
TECHNICAL SPECIFICATIONS
Multi-media Projector
20.3 lbs (9.2 kg)
12.44 x 6.46 x 18.9 (316mm x 164mm x 480mm) 
1366 x 768 dots
3,147,264 (1366 x 768 x 3 panels)
PAL, SECAM, NTSC, NTSC4.43, PAL-M and PAL-N
H-sync. 15 ~ 100 KHz, V-sync. 50 ~ 100 Hz
Adjustable from 31” to 400”
800 TV lines
2 speakers, 1.57 x 2.76 (40mm x 70mm) 
41 ˚F ~ 95 ˚F (5 ˚C ~ 35 ˚C)
14 ˚F ~ 140 ˚F (-10 ˚C ~ 60 ˚C)
Owner’s Manual
AC Power Cord
Wired/Wireless Remote Control Transmitter and Batteries
Video Cable (RCA x 1)
Audio Cable (RCA x 2)
S-Video Cable
Remote Control Cable
Dust Cover
Lens Cover 
Projector Type
Net Weight
Dimensions (W x H x D)
Panel Resolution
Number of Pixels
Color System
Scanning Frequency
Projection Image size (Diagonal)
Horizontal Resolution
Built-in Speakers
Operating Temperature
Storage Temperature
Accessories
LCD Panel System
The specifications are subject to change without notice.
F 1.8 ~ 2.1 lens with f 48.4 mm ~ 62.8 mm with motor zoom, focus and shift
4.43’ ~ 45.9’ (1.35 m ~ 14.0 m)
250 W
Projection Lens
Throw Distance
Projection Lamp
RCA Type Jacks (R and L(mono))  x 3Audio Input Jacks (Input 1/2/3)
INPUT 1 : HDB 15 pin Type Terminal
INPUT 2 : BNC Type Jacks (Video/Y, C/Pb(Cb), Pr(Cr)) / (G, B, R, H, V)
Mini DIN 4 pin Type Jack (S-Video)
INPUT 3 : RCA Type Jacks (Video/Y, Pb(Cb), Pr(Cr))
2.0 W RMS (stereo)
Computer / AV Input Jacks
Internal Audio Amp
0˚ to 9.0˚Feet Adjustment
Power Source : AA, UM3 or R06 Type x 2
Operating Range : 16.4’ (5m) / ±30˚
Dimensions : 1.8” x 0.75” x 6.7” (45mm  x 19mm  x 170mm)
Net Weight : 0.20 lbs (92 g) (including batteries)Remote Control Transmitter
480i, 480p, 575i, 575p, 720p, 1035i, 1080i-50 and 1080i-60High Definition TV Signal
AC 100 ~ 120 V (4.4 A  Max. Ampere), 50 / 60 Hz  (The U.S.A and Canada)
AC 200 ~ 240 V (2.2 A  Max. Ampere), 50 / 60 Hz  (Continental Europe and The U.K.)
Voltage and 
Power Consumption
RCA Type Jacks  (R and L)Audio Output Jacks 
35 mm Mini Jack (8 Ω2 W / stereo)External Speaker Jack
HDB 9 pin Type TerminalSerial Port Terminal
R/C JackMini Jack 
						

							43
APPENDIX
CONFIGURATIONS OF TERMINALS
RGB TERMINAL
Terminal : HDB15-PIN 
Connect the display output terminal of computer to this terminal with VGA Cable (not supplied).  When connecting the
Macintosh computer, the MAC Adapter (not supplied) is required.
512341096781514131112
Red Input
Ground (Horiz.sync.)
Green Input
Sense 2
Blue Input
Ground (Red)
Ground (Green)
Ground (Blue)
1
5
2
4
3
6
7
8
No Connect
Horiz. sync.
Ground (Vert.sync.)
Sense 1
Sense 0
Vert. sync.
Reserved
9
13
10
12
11
14
15
Pin Configuration
SERIAL TERMINAL
Terminal : HDB9-PIN 
Connect the serial port of computer to this terminal with Serial Cable (not supplied).
354217986
No Connect
Ground
R x D
No Connect
T x D
1
5
2
4
3
No Connect
RTS
No Connect
CTS
6
7
9
8
Pin Configuration
MAC ADAPTER (NOT SUPPLIED)
Set Slide Switches as shown in the table below depending on RESOLUTION MODE that you want to use before
you turn-on projector and computer.
ON
1DIP
ON
OFF
23456
13” MODE (640 x 480)
16” MODE (832 x 624)
19” MODE (1024 x 768)
21” MODE (1152 x 870)
ON
OFF
OFF
ON
ON
ON
ON
ON
OFF
OFF
ON
ON
OFF
ON
OFF
ON
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
123456
Slide Switches (1 ~ 6) 
						

							Printed in Japan
Part No. 610 289 4110 (1AA6P1P2612-- M4HA)
SANYO Electric Co., Ltd