Samsung C460 User Guide

							Regulatory information
1315. Appendix
22 
Ringer Equivalence Number
The Ringer Equivalence Number and FCC Registration Number for this machine 
may be found on the label located on the bo ttom or rear of the machine. In some 
instances you may need to provide th ese numbers to the telephone company.
The Ringer Equivalence Numb er (REN) is a measure of the electrical load placed 
on the telephone line, and is useful  for determining whether you have 
“overloaded” the line. Installing several  s of equipment on the same telephone 
line may result in problems  making and receiving telephone calls, especially 
ringing when your line is  called. The sum of all Ringer Equivalence Numbers of 
the equipment on your telephone line sho uld be less than five in order to assure 
proper service from the telephone company. In some  cases, a sum of five may 
not be usable on your line. If any of  your telephone equipment is not operating 
properly, you should immediately remove it  from your telephone line, as it may 
cause harm to the  telephone network.
The equipment complies with Part 68 of the FCC rules and the requirements 
adopted by the ACTA. On the rear of th is equipment is a label that contains, 
among other information, a product iden tifier in the format US:AAAEQ##TXXXX. 
If requested, this number must be pr ovided to the telephone company.
 
FCC Regulations state that changes or modifications to this equipment not 
expressly approved by the manufacturer  could void the user’s authority to 
operate this equipment. In the event that terminal equipment causes harm 
to the telephone network, the telephone company should notify the 
customer that service may be stoppe d. However, where prior notice is 
impractical, the company may temporar ily cease service, providing that 
they:
a  promptly notify the customer.
b  give the customer an opportunity  to correct the equipment problem.
c  inform the customer of the right to bring a complaint to the Federal 
Communication Commission pursuant  to procedures set out in FCC 
Rules and Regulations Subpart E of Part 68.
 
You should also know that:
• Your machine is not designed to be  connected to a digital PBX system.
• If you intend to use a computer modem or fax modem on  the same phone 
line as your machine, you may expe rience transmission and reception 
problems with all the equipment.  It is recommended that no other 
equipment, except for a regular teleph one, share the line with your 
machine.
• If your area experiences  a high incidence of lightning or power surges, we 
recommend that you install surge pr otectors for both the power and the 
telephone lines. Surge protectors can be purchased  from your dealer or 
telephone and electronic specialty stores. 
						

							Regulatory information
1325. Appendix
• When programming emergency numbers and/or making test calls to 
emergency numbers, use a non-emer gency number to advise the 
emergency service dispatcher of your  intentions. The dispatcher will give 
you further instructions on how to  actually test the emergency number.
• This machine may not be used on  coin service or party lines.
• This machine provides magnetic  coupling to hearing aids.
You may safely connect this equipment to  the telephone network by means of 
a standard modular ja ck, USOC RJ-11C.
23 
Replacing the Fitted Plug (for UK Only)
Important
The mains lead for this ma chine is fitted with a standard (BS 1363) 13 amp plug 
and has a 13 amp fuse. When you change  or examine the fuse, you must re-fit 
the correct 13 amp fuse. You  then need to replace the fuse cover. If you have lost 
the fuse cover, do not  use the plug until you  have another fuse cover. 
Contact the people from  you purchased the machine.
The 13 amp plug is the  most widely used in the UK and should be suitable. 
However, some buildings (main ly old ones) do not have normal 13 amp plug 
sockets. You need to buy  a suitable plug adaptor. Do not remove the moulded 
plug.
 
If you cut off the moulded plug,  get rid of it straight away.
You cannot rewire the plug and you ma y receive an electric shock if you 
plug it into a socket.
 
Important warning: 
If the wires in the mains lead do not matc h the colors marked in your plug, do 
the following:
You must connect the green and yellow wire  to the pin marked by the letter “E” 
or by the safety  ‘Earth symbol’ or colored  green and yellow or green.
You must connect the blue wire  to the pin which is marked with the letter “N” or 
colored black.
You must connect the brown wire to the  pin which is marked with the letter “L” 
or colored red.
You must have a 13 amp f use in the plug, adaptor, or  at the distribution board.
You must earth this machine.
The wires in the mains lead have the following color code:
•Green and Yellow:  Earth
• Blue:  Neutral
• Brown:  Live 
						

							Regulatory information
1335. Appendix
24 
Declaration of conformity (European countries)
Approvals and Certifications
January 1, 1995: Council Directive 2006/95/EC  Approximation of the laws of 
the member states related to  low voltage equipment.
January 1, 1996:  Council Directive 2004/108/EC,  approximation of the laws of 
the Member States related to  electromagnetic compatibility.
March 9, 1999:  Council Directive 1999/5 /EC on radio equipment and 
telecommunications terminal equipment and the mutual recognition of their 
conformity. A full declaration , defining the relevant Directives and referenced 
standards can be obtain ed from your Samsung Electronics Co., Ltd. 
representative.
EC Certification
Certification to 1999/5 /EC Radio Equipment & Telec ommunications Terminal 
Equipment Directive (FAX)
This Samsung product has  been self-certified by Samsung for pan-European 
single terminal connection to the analog ue public switched telephone network 
(PSTN) in accordance with Directive 199 9/5/EC. The product has been designed 
to work with the nat ional PSTNs and compatib le PBXs of the European 
countries:
In the event of problems, you should  contact the Euro QA Lab of Samsung 
Electronics Co., Ltd. in the first instance.
The product has been tested against TBR21.  To assist in the use and application 
of terminal equipment which complies  with this standard, the European 
Telecommunication Standard s Institute (ETSI) has issued an advisory document 
(EG 201 121) which cont ains notes and additional  requirements to ensure 
network compatibility of  TBR21 terminals. The prod uct has been designed 
against, and is fully compliant with, all  of the relevant advisory notes contained 
in this document.
Hereby, Samsung Electronics, de clares that this [ProXpress 
M332xND, ProXpress M382xD, Pr oXpress M382xND, ProXpress 
M402xND] is in compliance with  the essential requirements and 
other relevant provisions of Low  Voltage Directive (2006/95/EC), 
EMC Directive (2004/108/EC).
Hereby, Samsung Electronics, de clares that this [ProXpress 
M382xDW] is in compliance with  the essential requirements and 
other relevant provisions of  R&TTE Directive 1999/5/EC.
The declaration of conformity may be consulted at 
www.samsung.com , go to Support > Download center and enter 
your printer (MFP) name to browse the EuDoC.  
						

							Regulatory information
1345. Appendix
European radio approval information (for products 
fitted with EU-approved radio devices)
Low power, Radio LAN type devices (radio frequency (RF) wireless 
communication devices), operating in the 2.4 GHz/5 GHz band, may be present 
(embedded) in your printer syste m which is intended for home or office use. This 
section is only applicable if  these devices are present. Refer to the system label 
to verify the presen ce of wireless devices.
The power output of the wi reless device or devices that may be embedded in 
you printer is well below the RF exposure limits as  set by the European 
Commission through the R&TTE directive.
European states qualified under wireless approvals:
EU countries
European states with  restrictions on use:
EU
EEA/EFTA countries
No limitations at this time
25 
Israel only
26 
Regulatory compliance statements
Wireless guidance
Low power, Radio LAN devi ces (radio frequency (RF) wireless communication 
devices), operating in th e 2.4 GHz/5 GHz Band, may  be present (embedded) in 
your printer system. The following  section is a general overview of 
considerations while oper ating a wireless device.
Additional limitations, cautions, and concer ns for specific countries are listed in 
the specific country sectio ns (or country group section s). The wireless devices in 
your system are only  qualified for use in the countries identified by the Radio 
Approval Marks on the system rating label.  If the country you will be using the 
wireless device in, is not listed, contac t your local Radio Approval agency for 
requirements. Wireless d evices are closely regulated and use may not be 
allowed.
Wireless devices that may be in your system are only qualified for 
use in the European Union or associated areas if a CE mark is on the 
system label. 
						

							Regulatory information
1355. Appendix
The power output of the wireless device or devices that may be embedded in 
your printer is well below th e RF exposure limits as know n at this time. Because 
the wireless devices (whi ch may be embedded into your printer) emit less 
energy than is allowed in rad io frequency safety standards and 
recommendations, manufacturer beli eves these devices are safe for use. 
Regardless of the po wer levels, care should be ta ken to minimize human contact 
during normal operation.
As a general guideline, a  separation of 20 cm (8 inches) between the wireless 
device and the body, for use of a wirel ess device near the body (this does not 
include extremities) is typi cal. This device should be used more than 20 cm (8 
inches) from the body when wireless  devices are on and transmitting.
This transmitter must not be  collocated or operation in conjunction with any 
other antenna or transmitter.
Some circumstances requir e restrictions on wireless devices. Examples of 
common restrictions are listed below:
Radio frequency wireless comm unication can interfere with 
equipment on commerci al aircraft. Current aviation regulations 
require wireless devices to be turned off while traveling in an airplane. 
IEEE 802.11 (also known as wireless Ethernet) and Bluetooth 
communication devices are examples of devices that provide wireless 
communication.
In environments where the risk of interference to other devices or 
services is harmful or perceived as ha rmful, the option to use a wireless 
device may be restricted or eliminated. Airports, Hospitals, and 
Oxygen or flammable gas laden at mospheres are limited examples 
where use of wireless devices may be restricted or eliminated. When in 
environments where you are uncertain of the sanction to use wireless 
devices, ask the applicable authorit y for authorization prior to use or 
turning on the wireless device.
Every country has different restrictio ns on the use of wireless devices. 
Since your system is equipped with a wireless device, when traveling 
between countries with your system, check with the local Radio 
Approval authorities prior to any move or trip for any restrictions on 
the use of a wireless device in the destination country.
If your system came equipped with an internal embedded wireless 
device, do not operate the wireless device unless all covers and shields 
are in place and the system is fully assembled.
Wireless devices are not user servicea ble. Do not modify them in any 
way. Modification to a wireless devi ce will void the authorization to 
use it. Contact manufacturer for service.
Only use drivers approved for the co untry in which the device will be 
used. See the manufacturer System  Restoration Kit, or contact 
manufacturer Technical Support  for additional information. 
						

							Regulatory information
1365. Appendix
27 
China only
݇(=Bü 
						

							1375. Appendix
Copyright
© 2013 Samsung Electronics Co., Ltd. All rights reserved.
This user’s guide is provided fo r information purposes only. All information includ ed herein is subject to change without notic e.
Samsung Electronics is not respon sible for any direct or indirect damages, arisin g from or related to use of this user’s guide.
• Samsung and the Samsung logo are trad emarks of Samsung Electronics Co., Ltd.
• Microsoft, Windows, Windows Vista, Windows  7, Windows 8 and Windows Server 2008 R2 are either registered trademarks or trademarks of Microsoft 
Corporation.
• Google, Picasa, Google Docs, Android  and Gmail are either registered trademarks or trademarks of Google Inc.
• Google Cloud Print is a  trademark of Google Inc.
•  iPad, iPhone, iPod touch,  Mac and Mac OS are trademarks of  Apple Inc., registered in the U.S and other countries. AirPrint an d the AirPrint logo are trademarks 
of Apple Inc.
• All other brand or prod uct names are trademarks of their respective  companies or organizations.
Refer to the ' LICENSE.txt' file in the provided  CD-ROM for the open source license information.
REV. 9.01 
						

							C46x series
ADVANCED
User’s Guide
ADVANCED
User’s Guide
This guide provides information about installation, advanced configuration, 
operation and troubleshooting on various OS environments. 
Some features may not be available depending on models or countries.
BASIC
This guide provides information concerning installation, basic  operation and troubleshooting 
on windows. 
						

							139
ADVANCED
1. Software Installation
Installation for Mac 142
Reinstallation for Mac  143
Installation for Linux  144
Reinstallation for Linux  145
2. Using a Network-Connected 
Machine
Useful network programs  147
Wired network setup  148
Installing driver over the network  151
IPv6 configuration  156
Wireless network setup  159
Samsung Mobile  Print  192
Using the NFC feature  193
AirPrint  198
Google Cloud Print  200
3. Useful Setting Menus
Before you begin reading a chapter 204
Print  205
Copy  206
Fax  209
Scan  213
System setup  215
Network setup  221
4. Special Features
Altitude adjustment 224
Entering various characters  225
Setting up the fax address book  226
Printing features  229
Scan features  241
Fax features  250 
						

							140
ADVANCED
5. Useful Management Tools
Easy Capture Manager 260
Samsung Easy Color Manager  261
Samsung AnyWeb Print  262
Easy Eco Driver  263
Using SyncThru™ Web Service  264
Using Samsung Easy Printer Manager  267
Using Samsung Easy Document Creator  270
Using Samsung Printer Status  271
Using the Linux Unified Driver Configurator  273
6. Troubleshooting
Paper feeding problems 277
Power and cable connecting problems  278
Printing problems  279
Printing quality problems  283
Copying problems  291
Scanning problems  292
Faxing problems  293
Operating system problems  295