Roland VersaUV LEC 330 User Manual

139Chapter 7 Specifications
7-2 Printing or Cutting Area
Maximum Area
The  printing  or  cutting  area  along  the  horizontal  plane  (the  direction  in  which  the  carriage  moves)  is  determined  by  the 
position of the pinch rollers. 
*Margin length required by the media take-up and feed systems is approximately 1,100 mm (43 in.) 
Maximum Area When Using Crop Marks
When crop marks are used, the printing or cutting area is reduced from the maximum area by an amount equal to the crop 
marks....

7-2 Printing/Cutting Area
140Chapter 7 Specifications
Media-cutoff Location During Continuous Printing
When a media-cutoff command is sent from the computer, the cutoff location on the media is as shown in the figure be-
low. 
75mm (3 in)
First page Margin 
(setting on the computer)
Second page
Location where 
separated
Downloaded From ManualsPrinter.com Manuals 

141Chapter 7 Specifications
7-3 About the Blade 
The cutting conditions and the service life of the blade change according to the media and the operating environment, even 
when using identical blades. The service life also differs according to the type of blade. A rough guide is shown below. 
When  uncut  areas  remain  even  when  the  blade  force  is  increased  to  a  value  that  is  higher  by  50  to  60  gf  than  the  values 
shown in this chart, then replace the blade. 
*The values for...

142Chapter 7 Specifications
7-4 Locations of the Power Rating and Serial Number Labels
Power RatingUse an electrical outlet that meets the requirements for 
voltage, frequency, and amperage given here.
Serial NumberThis is required when you seek maintenance, servicing, 
or support. Never peel off the label or let it get dirty.
Downloaded From ManualsPrinter.com Manuals 

143Chapter 7 Specifications
LEC-330
Printing/cutting method
Piezo ink-jet method/media-moving method
Acceptable 
media Width182 to 762 mm (7.2 to 30 in.)
ThicknessMaximum 1.0 mm (39 mil) with liner, for printing
Maximum 0.4 mm (16 mil) with liner and 0.22 mm (9 mil) without liner, for cut
-
ting
Roll outer diameterMaximum 180 mm (7.1 in.)
Roll weightMaximum 20 kg (44 lb.)
Core diameter50.8 mm (2 in.) or 76.2 mm (3 in.)
Printing/cutting width (*1)Maximum 736 mm (29 in.)
Ink cartridges TypesECO-UV  220-cc...

7-5 Specifications
144Chapter 7 Specifications
 [PREFEED] menu item must be set to "ENABLE."
 Side margins: 25 mm or more for both the left and right margins
 Front margin: 35 mm or more
 Excluding expansion/contraction of the media
Range for assured repetition accuracy
 Length 3,000 mm
*4
 Provided that media length is under 3,000 mm
 Temperature: 25°C (77°F)
 Excluding possible shift caused by expansion/contraction of the media a\
nd/or by reloading the media.
*5
 Media type : Roland...

145
Downloaded From ManualsPrinter.com Manuals 

146
Downloaded From ManualsPrinter.com Manuals 

Downloaded From ManualsPrinter.com Manuals 

R1-090601
Downloaded From ManualsPrinter.com Manuals