Ricoh Projector PJ X5580 User Manual

29
Connecting the Projector
Connect to Computer/Notebook
E62405SPR
	Due to the difference in applications for each 
country, some regions may have different accessories.
Note
		To ensure the projector works well with your computer, 
please make sure the timing of the display mode is 
compatible with your projector. (See pages 82~86)
		Use the cables that come with the projector. (*)
1.........................................................................\
.........................................LAN...

30
E62405SPR
	Due to the difference in applications for each country, some regions may have different 
accessories.
Note
1.........................................................................\
..........................HDMI/MHL cable2.........................................................................\
..................Component-RGB Cable 3.........................................................................\
...........................Component...

31
Powering On the Projector
1. Ensure that the power cord and signal cable are securely 
connected. The Power indicator will turn red.
2.   Remove the lens cap. 
3.   Turn on the lamp by pressing the “” button on the control 
panel or the remote control.  The Power indicator will 
flash blue.
 The startup screen will display and the Power indicator will 
turn blue.  
4.   The first time you use the projector, you will be asked 
to select the preferred language. Turn on your source 
(computer,...

32
Powering Off the Projector
1.    Press the “” button and you will see a message as below on 
the on-screen display.
Power Off?
Press power key again.
2.    Press the “” button again to turn off the projector lamp.
3.  The cooling fan continues to operate for about 30 seconds for 
cooling cycle and the Power indicator will flash red. After 
cooling down, the light stops flashing, and then the projector 
will enter the standby mode.
   If you wish to turn the projector back on, you must wait 
until the...

33
Warning Indicator
  When the “Temp” indicator lights red, it indicates the 
projector has overheated. The projector will automatically 
shut itself down.
 
Please:
Warning! TEMPERATURE TOO HIGH
1. Make sure air in and outlets are not blocked.
2. Make sure the environment temperature is under 40 degress C.
  When the “Lamp” indicator lights red, and you see the 
message below displays on-screen, the projector has 
detected that the lamp is approaching its end of life. Please 
change the lamp as soon...

34
Adjusting the Projected Image
Adjusting the Position of Projector Image
The projector is equipped with adjustable feet to raise and lower 
the image to fill the screen.
1.   Locate the adjustable foot you wish to modify on the 
underside of the projector.
2.   Rotate the adjustable ring clockwise to raise the projector 
or counter clockwise to lower it. Repeat with the 
remaining feet as necessary.
Front Adjustable feet
Maximum Length: 52mm 
English
Basic Operations   

35
Adjusting the Projection Position using Lens 
Shift
Lens Shift (Vertical shift range)Maximum_0.1H (PJ X5580)Maximum_0.2H (PJ WU5570)
Lens Shift (Horizontal shift range)Maximum_0.1WLens Shift (Horizontal shift range)Maximum_0.1W
Image width (W)
Image height (H)
Offset (Hd)
This projector is equipped with a lens shift function for 
adjusting the position of the projected image by turning the 
Lens Shift dials clockwise or counterclockwise.
Use the Lens Shift dial on the upper panel to adjust the...

36
Focus Ring
Adjusting the Projector Zoom and Focus
You may turn the zoom lever to zoom in or out. To focus the 
image, rotate the focus ring until the image is clear. 
XGA (PJ X5580): Focus at distances from 3.28 to 44.29 feet 
(1.0 to 13.5 meters).
WUXGA (PJ WU5570): Focus at distances from 3.28 to 45.28 
feet (1.0 to 13.8 meters).
Adjusting Projection Image Size
Zoom Lever
Width
Height
Diagonal
Top View
Side ViewProjection Distance (D) Screen Screen
Screen (H)
Offset (Hd)
Projection Distance (D)...

37
XGA (PJ X5580)
Diagonal length (inch) size of 4:3 Screen
Screen Size W x HProjection Distance (D)Offset (Hd)
(m)(inch)(m)(feet)(cm)(feet)
WidthHeightWidthHeightwidetelewideteleMaxMaxMaxMin
300.610.46 2418/1.3/4.27 2.286 -2.286 0.075 -0.075 
400.810.61 32241.01.83.28 5.91 3.048 -3.048 0.100 -0.100 
501.020.76 40301.32.24.27 7.22 3.810 -3.810 0.125 -0.125 
601.220.91 48361.52.74.92 8.86 4.572 -4.572 0.150 -0.150 
701.421.07 56421.83.15.91 10.17 5.334 -5.334 0.175 -0.175 
801.631.22 64482.03.66.56 11.81...

38
The Projector has a multilingual On Screen Display that 
allows you to make image adjustments and change a variety of 
settings.
How to operate
1.   To open the OSD, press “Menu” on the Control Panel or Remote 
Control.
2.  When OSD is displayed, use      keys to select any item in the 
main menu. While making a selection on a particular page, press   
  or “Enter” key to enter sub menu.
3.  Use      keys to select the desired item in the sub menu and 
press     or “Enter” key to view further...