Projector Christie Rpmsp D180u User Manual

RPMX/RPMSP-D132U & RPMSP-D180U User Manual6-1020-100245-03 Rev. 1 (11-2010)
6 Troubleshooting
If the projector is not operating properly, note the symptoms and use this guide to assist you. If you cannot 
resolve the problems yourself, contact your dealer for assistance.
NOTE: A qualified service technician is required when opening the projector to diagnose any “probable 
cause”.
6.1 Displays
The projector is on but there is no display
1. Was a lens cover accidentally left on? Remove lens cover.
2. Is...

6-2RPMX/RPMSP-D132U & RPMSP-D180U User Manual020-100245-03 Rev. 1 (11-2010)
Section 6: Troubleshooting
The upper portion of the display is waving, tearing or jittering
This can sometimes occur with video or VCR sources. Check your source.
Portions of the display are cut off or wrap to the opposite edge
Resizing and/or blanking may need adjustment.
The display appears compressed (vertically stretched)
1. The frequency of the pixel sampling clock is incorrect for the current source.
2. Resizing, vertical...

Section 6: Troubleshooting
RPMX/RPMSP-D132U & RPMSP-D180U User Manual6-3020-100245-03 Rev. 1 (11-2010)
3. The input signal and/or signal cables carrying the input signal may be of poor quality.
4. If the distance between the input source device and the projector is greater than 25 feet, signal amplifica-
tion/conditioning may be required.
5. If the source is a VCR or off-air broadcast, detail may be set too high.
6.2 Lamps 
For more information on lamp operation modes and auto-switching, refer to 4.10.1...

RPMX/RPMSP-D132U & RPMSP-D180U User Manual7-1
020-100245-03 Rev. 1 (11-2010)
7 Specifications
Due to continuing research, specifications are subject to change without notice. 
Specifications apply to all models unless otherwise noted. 
7.1  Display 
RPMSP-D132URPMX-D132URPMSP-D180U
RESOLUTION
SXGA+ (1400x1050) XGA (1024 x 768)  SXGA+ (1400x1050)
BRIGHTNESS 
132W White Boost ON 2320 lumens 790 lumens
132W White Boost OFF 1390 lumens 465 lumens
120W White Boost ON 2100 lumens 660 lumens
120W White Boost...

7-2RPMX/RPMSP-D132U & RPMSP-D180U User Manual020-100245-03 Rev. 1 (11-2010)
Section 7: Specifications
7.2 Inputs 
Applies to RPMX/RPMSP-D132U and RPMSP-D180U
NOTES: 1)Value specifies frame rate of non-interlaced sources and field rate for interlaced sources. Frame/
field rates higher than the maximum refresh rate of the panels will be displayed at a lower rate.
2) Does not apply to sync-on-green/luma.
3) As the horizontal frequency increases and/or as the vertical scaling ratio of input lines to output...

Section 7: Specifications
RPMX/RPMSP-D132U & RPMSP-D180U User Manual7-3020-100245-03 Rev. 1 (11-2010)
COMPOSITE VIDEO 
AND S-VIDEO
Signal Formats Composite-video (CVBS)S-video (Y/C) 
Video Standards NTSC, NTSC 4.43, PAL, PAL M, PAL N, PAL60, SECAM
Input Levels  Composite-video 1.0Vp-p ±3db (including sync tip)
S-video luma (Y):1.0Vp-p ±3dB (including sync tip)
S-video chroma (C) 630mV nominal (burst)
DC Offset±2V
Nominal Impedance 75 ohms
DVI-I – ANALOG
Input Characteristics Same as Analog RGB except as...

7-4RPMX/RPMSP-D132U & RPMSP-D180U User Manual020-100245-03 Rev. 1 (11-2010)
Section 7: Specifications
7.3 Power Requirements
 
NETWORK 
CONTROL
Ethernet
1 RJ45 connector
REMOTE CONTROL
TypeLow Frequency IR with wired ability 
Range
30 Meters
Laser PointerIncluded
Battery Type (2 Required)AA, 1.5V Alkaline
WIRED CONTROL
Connector Type3.5mm plug
Input Levels High: 2.2V min.
Low: 0.9V max.
Power: 500mA @ 5V
GENERAL
RPMX-D132URPMSP-D132URPMSP-D180U
Voltage Range 100 – 240 VAC nominal 100 – 240 VAC nominal...

Section 7: Specifications
RPMX/RPMSP-D132U & RPMSP-D180U User Manual7-5020-100245-03 Rev. 1 (11-2010)
7.4 Lamps 
NOTE: The projector uses two identical lamps; however only one lamp operates at any given time.
7.5 Size and Weight
Dimensions with adjuster in nominal position (Depth x Length x Height)
90-degree configuration 15.5” DP x 33.5” LG x 15.6” HT
0-degree configuration 14.9” DP x 33.5” x 17.7” HT
Weight

7-6RPMX/RPMSP-D132U & RPMSP-D180U User Manual020-100245-03 Rev. 1 (11-2010)
Section 7: Specifications
EN61000-4-11 Voltage Dips, Short Interruptions and Voltage Variations Immunity
7.7 Environmental
Operating Environment
Temperature 5°C to 30°C (40°F to 86°F)
Humidity 20% - 80% non-condensing
Altitude 0 - 10,000ft, -5°C to 50°C
Non-Operating Environment
Temperature -25°C to 70°C with relative humidity varying between 0% to 95%
Altitude 30,000ft, -25°C to 70°C
7.8 Standard Components
• Line Cord (rated,...