Panasonic Vacuum Cleaner Mccg902 Operating Instructions

- 46 -
-11 -
Attachment StorageAlmacenamientopara accesorios Logement des accessoiresCanister HoodTapa del receptàculo Couvercle du chariotHood ReleaseLoquet de
dégagement
du couvercle
Pestillo de la tapa
Bag HolderPorte-sac
Sujetador de
la bolsa
Dust Bag Type C5 (MC-V150M)Bolsa para polvo Sac à poussière
Filter (Behind Dust Bag)Filtre (Derrière
le sac à poussière)
Filtro (Detrás de
la bolsa para polvo)
Power CordCordon
d’alimentation
Cordón eléctrico
CoverCouvercle
Cubierta
Cord Rewind BarBarre...

-12 -
- 45 -
PARTS IDENTIFICATION
Nomenclature
Identificación de piezas
3-Way On/Off Switch (Off/Floor/Carpet)Interruptor de encendido/apagado de tres posiciones
(Apagado/Piso expuesto/Alfombra) Interrupteur à trois positions (Arrêt/Plancher/Moquette)
Hose SwivelPivot du tuyau
Dispositivo giratorio de la manguera
Hose Latch TabLanguette de blocage du tuyau
Pestaña de sujectión de la manguera
Suction ControlRéglage de
la puissance
de laspiration
Control de aspiración
HandlePoignée
Mango
Crevice ToolSuceur...

- 13 -
- 44 -
Overload Tools-
POWER Protector Headlight On-Board Cord Length
120V. AC (60Hz)
Yes Yes Yes 24 Ft. (7.3 m)
12.0 A
Protector
contra Extensión
Voltaje subrecargas Luz Herramientas de cordón
120V. AC (60Hz)
Si
SiSi 7,3 m (24 pi)
12,0 A
Protecteur Dispositif Longueur
Alimentation de surcharge d’éclairage Accessoiresdu cordon
120 V c.a. (60 Hz)
Oui
Oui Oui 7,3 m (24 pi)
12,0 A
FEATURE CHART
Diagrama de característicasTableau des caractéristiques
TO CHECK BRUSHES: ➢
➢
When brushes are worn to the...

ButtonBotón BoutonWand SwivelPivot du tube
Dispositivo giratorio
del mangoCord HolderAttache du cordonSujetador del cordón
- 14 - - 43 -
ASSEMBLY
➢ ➢ 
  
 
Insert wands into POWER NOZZLE
until the wand button snaps into
place.
➢ ➢ Connect POWER NOZZLE plug and
cord as shown.
➢ ➢  
  
 
Do not force.
➢
➢ Raised area of plug must face
toward hand.
➢ ➢ If hard to install, turn the plug over
and try again.
To Remove:
➢ Disconnect POWER NOZZLE plug and cord.
➢ Press wand quick release pedal.
➢ Pull wands out...

- 15 -
- 42 -
Replacing Belt
➢
➢ Install new belt in belt groove on
the agitator assembly, then over
the motor shaft.
➢ ➢ Place agitator assembly back into
POWER NOZZLE.
➢
➢ Replace agitator cover.
➢
➢ Line up front of cover and base.
➢
➢ Rest cover on front edge of base as
shown.
➢
➢ Tilt cover to back.
➢
➢ Press cover firmly until tabs snap
into place.
➢
➢
Replace cover screws.
Agitator AssemblyAssemblage de l’agitateur
Montaje del agitador
Motor ShaftArbre du moteur
Eje del transmissión
del...

➢
➢
Line up the hose latch tab and notch incanister hood and insert hose into
canister until it snaps in place.
To Remove: 
➢ ➢  
  
 
Lift hose latch tab upward and pull up on
hose.
➢
➢ Insert handle into wand until lock
button snaps in place.
➢
➢ Be sure the hose is not twisted.
To Remove: ➢
➢ Press lock button and pull up on
handle.
NotchFente
Ranura
Hose Latch TabLanguette de blocage
du tuyau
Pestaña de sujeción
de la mangueraLock ButtonBouton de blocage
Botón del mango
HandlePoignée
Mango...

- 17 -
➢
➢
Ouvrir le couvercle du chariot.
➢
➢
Vérifier le sac à poussière (Se reporter àla section “Remplacement du sac à
poussière”).
➢ ➢
Vérifier le filtre de sécurité du moteur (Sereporter à la section “Remplacement du
filtre de sécurité du moteur).
➢
Abra la tapa del receptáculo.
➢
Cheque la funda de polvo (Vea
CAMBIAR FUNDA para
instruccíones).
➢
Cheque el filtro (Vea REEMPLAZAR
FILTRO para instruccíones).
➢ ➢
Il est normal que le couvercle du chariot
se détache lorsqu’il est ouvert plus que...

- 18 -
FEATURES
Overload Protector
➢
➢The overload protector stops the
POWER NOZZLE motor when the
brush jams and prevents belt
breakage.
NOTE:  Canister motor will continue to
run. TO CORRECT PROBLEM:➢ ➢ Unplug electrical cord.
➢
➢ Check brush and brush support
areas for excessive lint buildup or
jamming.
➢ ➢ Clean jammed area.
TO RESET:  ➢
➢ Press reset button on top of the
POWER NOZZLE. Plug in and turn
on vacuum cleaner. 
Overload Protector
(Reset Button)Protector contra sobrecargas
(Botón de...

- 19 -
- 38 -
Caractéristiques
Características 
Protecteur de surcharge
Protector contra sobrecargas
➢
El protector contra sobrecargas detiene
el motor del POWER NOZZLE cuando
el cepillo se atasca y previene que la
banda se reviente.
NOTA: El motor de la aspiradora volverá a
funcionar.
Para corregir el problema:➢
Desenchufar Cordón Eléctrico
➢
Cheque cepillo y áreas de apoyo de cepillo
para acumulación  excesivo de hila o
interferencia.
➢
Limpiar el área de interferencia.
Para restablecer: 
➢
Apreta el...

Hose SwivelEdge Cleaner
➢
➢The hose swivel allows the hose to
turn without moving the canister.
This is helpful for cleaning in small
areas.  
➢ ➢ Check hose for twisting before
pulling canister.
➢
➢
Active brush edge cleaners are on both sides of the Power Nozzle.
➢
➢
Guide either side of the Power Nozzlealong baseboards or next to
furniture to help remove dirt trapped
at carpet edges.
- 20 -
Thermal Protector
- 37-
This vacuum cleaner has a thermal protector which automatically trips to protect the...