Panasonic Up/Down Wall Mount Kit, Up/Down Stand Kit UE-608030, UE-608031, UE-608032 Operating Instructions

Wall Mounting Construction31
Installation Manual
6Confirm that the M6 189 bolt and nuts A and B 
are in the correct positions. (The direction of 
rotation in instructions is  relative to the part 
being adjusted as viewed from above.) 
7Holding nut B in place with a 10 mm (13/32in.) 
wrench, use another wrench to loosen nut A 
(counterclockwise), and then move the nut 
about 1 mm (
1/16in.) (1).
8Holding nut B in place with a 10 mm (13/32in.) 
wrench, use another wrench to turn the M6 189 
screw...

Wall Mounting Construction
32 Installation Manual
10Turn the head of the M6 189 screw with a 10 mm 
(13/32in.) wrench (ratchet type) and reposition the 
hold tube assembly to the adjustment position 
for the model to be mounted ( 4
).
(Example: When mounting a UB-T880W, turn the M6 189 
screw clockwise with a 10 mm [13/32in.] wrench [ratchet 
type] and reposition the assembly from adjustment 
position 7 [as shipped] to adjustment position 9.)
Note
•When the hold tube assembly is moved toward 
the “+”...

Wall Mounting Construction33
Installation Manual
Mounting the elite 
Panaboard
1Align the wall mount holes on the bottom of the 
board attachments with the left and right 
positions of the board bottom bracket (loosely 
secured to the up/down unit) and secure them 
tightly using the board mounting screws ( 5
, 
two on each side). 
For UB-T880
2Try drawing the elite Panaboard toward you, 
and check that the elite Panaboard is fastened 
securely to the up/down unit.
•Confirm that the elite Panaboard is...

Wall Mounting Construction
34 Installation Manual
Wiring Connections
1Position the computer which you are going to 
use at the prescribed location, and connect the 
computer, projector and elite Panaboard as 
shown below.
2Connect the power cables of the computer, 
projector and elite Panaboard to the table tap, 
and connect the plug of the table tap to the 
power outlet.
Apply the High-Temperature 
Warning Label
1Turn on the power of the computer, projector 
and elite Panaboard in this order.
2Apply the...

Wall Mounting Construction35
Installation Manual
Projection Adjustments
1Project an image from the projector onto the 
screen of the elite Panaboard.
2Adjust the projected image’s size and 
projection position and eliminate trapezoidal 
distortion.
∫ Adjusting the Image Size
If projected images are too big or small, adjust the 
projector so that the image height is slightly smaller 
than the vertical area on the screen for image 
projection.
If the image size cannot be adjusted using the 
projector’s...

Wall Mounting Construction
36 Installation Manual
Securing the elite 
Panaboard
1Tighten the two-wing bolts used to secure the 
board bottom bracket, and secure the elite 
Panaboard position.
2Mount the lower frame cover of the elite 
Panaboard onto the center bottom part.
Checking the Operations 
of the elite Panaboard
For details of cleaning the screen and checking the 
operations of the elite Panaboard, refer to the 
Operating Instructions of the elite Panaboard.
Two-wing Bolts
Lower Frame Cover...

Assembling the Stands37
Installation Manual
Assembling the Stands
Assembling the Stands
Assembling the Stand Table Unit
1Take the left stand and right stand out of the 
stand unit box, and use the three bolts and 
collars for each stand to secure the stands.
•As shown below, with the bottom of the up/down unit 
taken out of the packing box, remove the up/down unit’s 
three bolts and collars each for the left and for the right.
(Spread cushioning material under the up/down unit to 
adjust the height.)
*...

Assembling the Stands
38 Installation Manual
3Pull up the pipe part of the stand by hand while 
tightening bolts B and C in this order.
Notice
•Take hold of the pipe part of the stand and, with 
the up/down unit pulled up, tighten the bolts.
Right Stand
Left Stand
4Tighten up bolts A, B and C securely.
5After attaching the left and right stands, place 
the assembled parts upright, and check that 
there is no play either at the front or back or at 
the left or right.
•If there is any play in the stand...

Assembling the Stands39
Installation Manual
Preparing to Mount the Projector
→ Refer to “Preparing to Mount the Projector” 
(page 24) under “Wall Mounting Construction”.
Mounting the Projector Arm
→Refer to “Mounting the Projector Arm” 
(page 26) under “Wall Mounting Construction”.
Adjusting the Up/Down Unit
→Refer to “Adjusting the Up/Down Unit” 
(page 28) under “Wall Mounting Construction”.
Mounting the elite Panaboard
→Refer to “Mounting the elite Panaboard” 
(page 33) under “Wall Mounting...

© Panasonic System Networks Co., Ltd. 2010PJQXC0341YA-F  F0710MH2110
Türkiye’deki kullanclar için
EEE Yönetmeliğine Uygundur.
For users in Turkey 
EEE Complies with Directive of Turkey.
UE-608030_EN.book  36 ページ  ２０１０年１０月２８日　木曜日　午後４時２０分