Panasonic Up/Down Wall Mount Kit, Up/Down Stand Kit UE-608030, UE-608031, UE-608032 Operating Instructions

11
Operating Instructions
Usage
Moving the Stand
Stowing the Projector Assembly
Prepare to move the stand by carrying out the steps below.
1Disconnect the power cable from the power outlet.
2Move the projector.
•While lifting the projector arm slightly, turn it clockwise 
or counterclockwise slowly, and move the arm so that 
it is made parallel with the elite Panaboard unit.
Note
•At the lowest point, the projector may come into 
contact with the unit. Rotate the arm away, so 
that the projector will not...

12 Operating Instructions
Usage
Removing the Foot Reinforcing 
Assemblies
While grasping the release lever on the back side of 
each foot reinforcing assembly, pull the assembly from 
the stand base.
Notice
•Before moving the stand, be absolutely sure to 
remove the foot reinforcing assemblies from the stand 
base. If the stand is moved with these assemblies still 
attached, it may catch on surrounding objects, cause 
somebody to trip over and/or cause injury.
•In case of securing the foot reinforcing...

13
Operating Instructions
Appendix
Appendix
Troubleshooting
Symptom Possible cause and solution
Unusual sounds are heard while 
the elite Panaboard is moving 
up or down or the elite 
Panaboard feels extremely 
heavy when it is raised. Something may be wrong with the up/down unit. Stop using the elite 
Panaboard immediately, and contact your dealer.
Even when the elite Panaboard 
is raised, it drops down under its 
own weight. The adjustment part for raising and lowering the elite Panaboard may be 
out...

For Your Safety
14 Installation Manual
For Your Safety
Installation Manual (for qualified service personnel)
•Request assembly of the units and wall mounting from your dealer.
•Before constructing or installing the units, please read “Installation Manual (for qualified service personnel)” 
carefully. Panasonic System Networks Co., Ltd. cannot be held responsible for accidents or damage to 
property resulting from incorrect installation.
•Please read “For Your Safety” (pages 4–6 and pages 14–15) carefully...

For Your Safety15
Installation Manual
Safety
Do not attach the electronic board to 
mortared walls. Accidental electric 
leakage from the mounting bolts securing 
the up/down unit to metal laths or wire 
laths can cause heat, smoke or fire.
Confirm the bolts of the unit are certainly 
caught by the up/down unit by pulling the 
elite Panaboard after hanging the elite 
Panaboard on the up/down unit if the unit 
is mounted on a wall.
Be sure to put on a glove to avoid injury.
Do not remove the up/down...

Product Configuration
16 Installation Manual
Produc t Configuration
Packing Configuration
The following units are required when using the up/down stand kit or up/down wall mount kit.
Included Accessories
The following items are provided in the packing boxes. Check that they are present and accounted for.
∫Up/Down Unit (UE-608030)
Up/Down Stand Kit
Up/Down Unit UE-608030
Stand Table Unit UE-608031
Short-Throw Arm Unit UE-608032
Up/Down Wall Mount Kit Up/Down Unit UE-608030
Short-Throw Arm Unit UE-608032...

Product Configuration17
Installation Manual
∫ Stand Table Unit (UE-608031)
∫ Short-Throw Arm Unit (UE-608032)
No.Part NameIllustrationQ’tyNo.Part NameIllustrationQ’ty
8Bolt (M6 x 75 mm [215/16in.]) for 
Securing Left and Right Stands6=Collar for Securing 
Table Plate 4
9Collar for Securing Left 
and Right Stands6>Spring Washer for 
Securing Table Plate4
:Screw (M3 x 10 mm [13/32in.]) 
for Securing Protective Cover12?Flat Washer for 
Securing Table Plate 4
;Flat Washer for Securing 
Protective Cover12@Nut...

Wall Mounting Construction
18 Installation Manual
Wall Mounting Construction
Checking the Wall
Which method should be used to mount the up/down wall mount kit depends greatly on the structure of the wall. The 
system to be mounted on the wall is heavy (up to 84 k
g [185.19 lbs] including the elite Panaboard and projector). Before 
proceeding with installation, therefore, consult with the  building manager, maintenance engineer or designer to verify 
that the wall has a structure strong enough to support...

Wall Mounting Construction19
Installation Manual
2Concerning Installation
•The up/down stand kit and up/down wall mount kit are for indoor use. They cannot be used outdoors. 
Neither can they be installed or used in the following kinds of places.
— Places where they will be directly exposed to rain or water (including under the eaves of a house)
— Places where chemicals are used such as swimming pools
— Places with a lot of steam or grease such as manufacturing plants or kitchens, places with special...

Wall Mounting Construction
20 Installation Manual
Wall Types and Installation Procedures
I.When the Wall is a Principal Structural Component (a concrete wall which is at least 120 mm [43/4in.] thick)
Use the M8 bolts to mount the system on the wall. It is also necessary to provide anchors separately. The 
figure below shows the end mounting position of the up/down unit and the elite Panaboard vis-à-vis the hole 
positions. Check that there is enough space around the mounting position. Carefully read the...