Panasonic Small Digital Business System 308/616 Installation Instructions

_. DBS 
FF-2 Trunk mode 
FF2-(1 32)# lO#k:$?  - - - 
Connected phone line type setting 
Asthe dialing decision for TRS and the like is 
affected if the system is connected to a PBX, 
either a PBX line or a CO. line is set for each trunk 
l#: CO. line 
2%: PBX line (Need to access numberto CO line) 
FF2-(l- 32)Pl l#-(0 or l)# 
DISA Ijne setting 
(Automatic DISA answer) 
This setting is each trunk port to receive incoming 
calls using the DISA functionHowever you may 
need to set DISA start and end times...

SECTION 400 (Version 3.0) 
Issue 1 January 1990 DBS 
FF-2 Trunk mode 
FF2-(l- 32)#-16#-(0 
or l)# 
Call Diversion 
(Trunk to trunk connection trunk setting) 
tt is set whether or not an outside line can make a 
trunk to trunk connection. 
This function can be used at an extension where 
trunk to trunk connection has been set in the 
extension mode. 
In addition, if the time set with the call 
monitoring timer is exceeded, the call is 
automatically cut off. 
O#: Trunk to trunk connection not possible...

DBS 
FF-2 Trunk mode 
FF2-(l- 32)#-19#-(Hour - Minute)# 
DISA start time setting 
A CO line can be assigned as a DISA (direct inward 
system access) line for a specific period of time. 
When the outside line is not activated by this timer 
as a DISA line it can be used as a normal outside 
line. This timer specifies the stating time for D&4. 
The time entered is in 24 hour format with no 
spaces between hour and minute. 
JCONFl#: No startina time (DATA reset) 
HHMM#:(OO-23,00-59) Enterthe time 
FF2-(l-...

SECTION 400 (Version 3.0) DBS 
Issue 1 January 1990 FF-3 Extension mode 
3 - 3 Extension mode 
General operating specifications are set for the 
extensions, and these specifications 
are set for 
each port number in the main cabinet with regard 
to each extension. 
FF3-(l -72)#-l#-(loo-699)# . 
Extension number 
Extension numbers are stored for the extension 
portJ. 
The extensi-on numbers set in the system program 
are stored separately according to the number of 
digits (2 or 3 digits). 
If there are...

DBS 
FF-3 Extension mode SECTION 400 (Version 3.0) 
Issue 1 January 1990 
FF3-(1- 72)#-3#-(01- 72)# 
EM/24 user-port number 
Extension ports are stored for operating 
extensions connected to them and for the 
connected EM/24 console and stored. 
ICONFIR: EM/24 not connected 
(01 - 72)#: Operates as EM/24 for stored extension 
Note : As regards EM124, after they have been 
stored, it is necessary either to tom the 
system power off and then turn it on again, 
or to disconnect the module jacks for EM124...

SECTION 400 D/ersion 3.0) 
Issue 1 January 1990 
FF3-( 1 - 72)#-8#-(0 or l)# 
Call waiting accept setting 
When a call is received‘from another extension 
while the extension is busy, the 
busy tone is sent 
to the former. 
However, this sets whether call waiting is to be 
accepted or not when the 131 key has been input 
again and call waiting effected. If set for 
accepting, the incoming call signal is sent from the 
. extension. But call waiting 
cannot be accepted by 
an 
extension which is set for...

DBS 
IT-3 Extension mode 
FF3-(l - 72)#-74#-(0 or l)# 
SMDR printout setting 
This sets whether information from outside calls is 
to be printed out by the SMDR (Station Message 
Dial Recorder) printer. 
cNrEold~ 0#: E&nipll is not printed out 
l#: lncomlns call is printed out 
Note: For SMDR printing it is necessary to set the 
protocol between the system and SMDR 
and the control data beforehand. 
FF3-(1- 72)#-1 S#-(0 or 4)# 
Off-hook signal volume ’ 
The off-hook signal can be set at 4types. 
1#:...

SECTION 400 (Version 3.0) DES 
Issue 1 January 1990 FF-3 Extension mode 
FF3-(l - 72)#-26#-(0 - 13)# 
Large LCD information condition on the 
idle status (Idol) . 
The contents are set for display on a large LCD 
when the extension is in the idle (On hook) status. 
O#: No chancre 
l#: Change to menu information 
28: Change to personal speed 
dial index 
3#: Change to system speed dial index 
48: Change to extension index 
5#: Change to guidance menu 1 
(ABSES, AC-CODE,LKOUT,REMDR,FF-Key) 
6#: Change to...

DBS 
FF-3 Extension mode SECTION 400 (Version 3.0) 
Issue 1 January 1990 
FF3-(1- 72)#-27#- (0 - 13)# 
Large LCD information on the intercom 
dial tone status (IDT) 
The contents are set for display on a large LCD 
when the extension is involved in an intercom dial 
tone (off hook) status. 
08: No chanoe 
l#: Change to menu information 
2%: Change to personal speed dial index 
38: Change to system speed dial index 
4%: Change to extension index 
5#: Change to guidance menu 1 
(ABSES,...

SECTION 400 (Version 3.0) 
Issue 1 January 1990 DBS 
FF-3 Extension mode 
FF3-( 1 - 72)#-28#-(0 - 13)# 
Large LCD information on the intercom 
call status (lNT Talk) 
The contents are set for display on a large LCD 
when the extension is involved in an intercom call 
(Caliing,Receiving call,On the 
conversation,Making the call waiting) status. 
08: No chanae 
l#: Ulange to menu information 
2#: Change to personal speed dial index 
3#: Change to system speed dial index 
4#: Change to extension index 
5#:...