Panasonic LCD Projector Pt Lw330 Operating Instructions

ENGLISH - 21
Attention
 
f Do not block the ventilation ports (intake and exhaust) of the projector .
Control panel and Indicators
1
2
3
45
6
7
1 
Power indicator  
Displays the status of the power.
2  Power  button
Turns the projector on/off.
3  asqw  buttons
Used to select the menu items in the menu operation.
4  / q button
Displays the menu screen. 5 
Warning indicator 
Indicates the abnormal conditions of the projector.
6   button
Used to correct the keystone. (
Æ page 39)
7   /  w button
Displays...

22 - ENGLISH
Attention
 
f When a LAN cable is directly connected to the projector, the network connection must be made indoors.
 
r Only for PT-LB300 and PT-LB280
1 2
3
4
5 6
7 9
8
1 
 terminal
This is the terminal to output audio signal input to the 
projector.
2   terminal
This is the terminal to input video signals.
3   terminal
This is the terminal to input RGB, YP
BPR/YCBCR or  
S-video signals.
4   terminal
This is the terminal to output the RGB
 signals to external 
monitor.
5   terminal
This is...

ENGLISH - 23
Using the remote control
Inserting and Removing batteries
1) Open the cover. (Fig. 1)
2)  Insert batteries and close the cover (Insert the "m" side first.).  (Fig. 2)
 
f When removing the batteries, perform the steps in reverse order.
Setting Remote control ID numbers
When you use the system with multiple projectors, you can operate all the projectors simultaneously or each projector 
individually using single remote control, if unique ID number is assigne\
d to each projector....

24 - ENGLISH
Chapter 2   Getting Started
This chapter describes things you need to do before using the projector \
such as the setup and 
connections.  

ENGLISH - 25
Setting up
Installation mode
There are four ways to set up the projector. Set the [Display] menu → [Project way] (x page 51) depending on the 
installation location. 
Mounting on the ceiling and projecting forwardSetting on a desk/floor and projecting from rear
(Using the translucent screen)
Menu itemMethodMenu item Method
[Project way] [Ceiling/Front] [Project way] [Rear]
Mounting on the ceiling and projecting from rear
(Using the translucent screen)Setting on a desk/floor and projecting...

26 - ENGLISH
Screen size and throw distance
Refer to the screen size and projection distances to install the projector. Image size and image position can be adjusted in 
accordance with the screen size and screen position.
Projected image
SH
SW
SDSHScreen
L (LW/LT)
Screen L (LW/LT)
SW
H
L (LW/LT) *1Projection distance (m)
SH Image height (m)
SW Image width (m)
H Distance from the center of lens to the image lower end (m)
SD Projected image size (m)
*1 LW : Minimum distance 
LT : Maximum distance...

ENGLISH - 27
For PT-LW280
All measurements below are approximate and may differ slightly from the actual measurements. (Unit: m)
Projection size 4:3 aspect ratio
16:9 aspect ratio16:10 aspect ratio
Screen 
diagonal  (SD) Minimum 
distance
(LW) Maximum 
distance
(LT) Height 
position  
(H) Minimum 
distance
(LW) Maximum 
distance
(LT) Height 
position (H) Minimum 
distance
(LW) Maximum 
distance
(LT) Height 
position (H)
0.76 (30") 1.11.30.065 1.01.2 0.008 0.91.1 0.027
1.02 (40") 1.41.70.087...

28 - ENGLISH
Projection size4:3 aspect ratio 16:9 aspect ratio
Screen diagonal (SD) Minimum 
distance
(LW) Maximum 
distance
(LT) Height position (H) Minimum 
distance
(LW) Maximum 
distance
(LT) Height position (H)
0.76 (30") 0.91.1 0.065 1.01.2 0.008
1.02 (40") 1.21.4 0.087 1.31.6 0.011
1.27 (50") 1.51.8 0.109 1.62.0 0.014
1.52 (60") 1.82.2 0.131 2.02.4 0.017
1.78 (70") 2.12.5 0.152 2.32.8 0.019
2.03 (80") 2.42.9 0.174 2.63.1 0.022
2.29 (90") 2.73.3 0.196 3.03.5 0.025
2.54...

ENGLISH - 29
Adjusting adjustable foot
Lift the front of the projector and press the foot lock latch with your finger to adjust the projection angle up and 
down. Release your finger to lock the adjustable foot.
For slight adjustment, rotate the adjustable foot. 
Rotate the adjustable foot to extend it as shown in the figure, and rotate it in the opposite direction to contract it.
Attention
 
f Heated air comes out of the air exhaust port while the lamp is lit. Do not touch the air exhaust port directly...

30 - ENGLISH
Connecting
Before connecting
 
f Before connecting, carefully read the operating instructions for the external device to be connected.
 
f Turn off the power switch of the devices before connecting cables.
 
f Take note of the following points before connecting the cables. Failure to do so may result in malfunctions.
-  When connecting a cable to a device connected to the projector or the projector itself, touch any nearby metallic objects to 
eliminate static electricity from your body...