Panasonic Kx Tgl430 Operating Instructions Manual

Voicemail serviceIn addition to your unit’s answering system
you may also have voicemail service from
your phone service provider.  Voicemail is
an answering service that may be offered by
your phone service provider. This service can
also record calls when you are unavailable to
answer the phone or when your line is busy.
Messages are recorded on the phone
company system and not on the unit’s
answering system.
R To use the voicemail service rather than the
unit’s answering system, turn off the...

2Follow the pre-recorded instructions.
3 When finished, hang up.
Note:
R You can also use the  MACCESS N soft key,
if displayed, to play new voicemail
messages.
R If the handset still indicates there are new
messages even after you have listened to
all new messages, turn it off by pressing
and holding  # until the handset beeps.
Wall mounting
Note:
R Make sure that the wall and the fixing
method are strong enough to support the
weight of the unit.
Base unit
1 Lead the AC adaptor cord and telephone
line...

4Adjust the adaptor to hold the base unit,
then push it in the direction of the arrow
until it clicks into place.5Mount the unit on a wall then slide down
to secure in place.
 AC adaptor cord
R This product is compliant with the
following wall phone plate sizes (2
types).
 83 mm (3  1
/4  inches) 102 mm (4 inches)
Fit the slots of the unit onto the
corresponding wall phone plate tabs
for (
) and () respectively.
For assistance, please visit http://shop.panasonic.com/support43
Useful Information...

To remove the wall mounting adaptor
While pushing down the release levers (A),
remove the adaptor ( B).
Charger
Drive the screws (
) (not supplied) into the
wall.
 27.2 mm (1  1
/16  inches)
44For assistance, please visit http://shop.panasonic.com/support
Useful Information

TGL43x(en)_1117_ver041.pdf   442015/11/17   16:08:04B
AA 1 2 1
2  

Error messages
Display messageCause/solution
Ask phone
company for
VM access #RYou have not stored the voicemail access number. Store the
number (page 41).
Base no power
or
No link. Re-
connect base
AC adaptor.RConfirm the base unit’s AC adaptor is connected to the unit
and the power outlet correctly.
R The handset has lost communication with the base unit. Move
closer to the base unit and try again.
R Unplug the base unit’s AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R The...

TroubleshootingIf you still have difficulties after following the instructions in this section, disconnect the base unit’s
AC adaptor, then reconnect the base unit’s AC adaptor. Remove the batteries from the handset,
and then insert them into the handset again.
General use
ProblemCause/solution
The handset does not turn on
even after installing charged
batteries.R Place the handset on the base unit or charger to turn on
the handset.
The unit does not work.RMake sure the batteries are installed correctly...

ProblemCause/solution
I fully charged the batteries, but
– still flashes,
– is displayed, or
– the operating time seems to be shorter.
RClean the battery ends (, ) and the charge contacts
with a dry cloth and charge again.
R It is time to replace the batteries (page 9).
Making/answering calls, intercom
ProblemCause/solution
 is displayed.RThe handset is too far from the base unit. Move closer.
R The base unit’s AC adaptor is not properly connected.
Reconnect AC adaptor to the base unit.
R The handset is...

Caller ID/Talking Caller ID
ProblemCause/solution
Caller information is not
displayed.RYou must subscribe to Caller ID service. Contact your
phone service provider for details.
R If your unit is connected to any additional telephone
equipment such as a Caller ID box or cordless telephone
line jack, plug the unit directly into the wall jack.
R If you use a DSL/ADSL service, we recommend
connecting a DSL/ADSL filter between the base unit and
the telephone line jack. Contact your DSL/ADSL provider
for...

Answering system
ProblemCause/solution
The unit does not record new
messages.RThe answering system is turned off. Turn it on (page 35).
R The message memory is full. Erase unnecessary
messages (page 36).
R The recording time is set to  “Greeting only ”. Change
the setting (page 40).
R Your phone service provider’s voicemail service may be
answering your calls before the unit’s answering system
can answer your calls. Change the unit’s number of rings
setting (page 40) to a lower value, or contact your...

Liquid damage
ProblemCause/solution
Liquid or other form of moisture
has entered the handset/base
unit.RDisconnect the AC adaptor and telephone line cord from
the base unit. Remove the batteries from the handset and
leave to dry for at least 3 days. After the handset/base
unit are completely dry, reconnect the AC adaptor and
telephone line cord. Insert the batteries and charge fully
before use. If the unit does not work properly, contact an
authorized service center.
Caution:
RTo avoid permanent damage,...