Panasonic Kx Tg6311 Operating Instructions Manual

Intercom/Locator
41For assistance, please visit http://www.panasonic.com/help
To establish a conference call:
Press {Conf}.
LTo leave the conference, press 
{OFF}. The other parties can 
continue the conversation.
LTo put the outside call on hold, 
press {HOLD}. To resume the 
conference, press {Conf}.
Answering a transferred call
Press {C} to answer the page.
Note:
LAfter the paging party disconnects, 
you can talk to the outside caller.
Handset locator
You can locate a misplaced handset by 
paging it....

Useful Information
42For assistance, please visit http://www.panasonic.com/help
Wall mounting
Base unit
1
Lead the telephone line cord through 
the hole in the wall mounting adaptor 
in the direction of the arrow.
2Tuck the telephone line cord inside 
the wall mounting adaptor (A). 
Connect the AC adaptor cord and 
telephone line cord (B).
3Insert the hooks on the wall 
mounting adaptor into the holes 1 
and 2 on the base unit.
4Adjust the adaptor to hold the base 
unit, then push it in the direction of...

Useful Information
43For assistance, please visit http://www.panasonic.com/help
5Connect the telephone line cord. 
Mount the unit by inserting the 
mounting pins into the round 
openings on the adaptor (for pin 2, 
use the round cut out at the bottom 
of the adaptor if you are using the 4 
inch phone plate), then slide the unit 
down to secure it. Connect the AC 
adaptor to power outlet (page 12).
LThere are 2 common types of wall 
phone plates. The distance 
between 1 and 2 may vary 
depending on the...

Useful Information
44For assistance, please visit http://www.panasonic.com/help
Error messages
If the unit detects a problem, one of the following messages is shown on the display.
Display messageCause/solution
Busy
or
System is busy. Please 
try again later.LThe called handset or base unit is in use.
LOther units are in use and the system is busy. 
Try again later.
LThe handset you are using is too far from the 
base unit. Move closer and try again.
LThe handset’s registration may have been 
canceled....

Useful Information
45For assistance, please visit http://www.panasonic.com/help
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect 
the base unit’s AC adaptor, then reconnect the base unit’s AC adaptor. Remove the 
batteries from the handset, and then insert the batteries into the handset again.
General use
*1 KX-TG6322/KX-TG6323/KX-TG6324
Programmable settings
ProblemCause/solution
The unit does not work.LMake sure the batteries are installed...

Useful Information
46For assistance, please visit http://www.panasonic.com/help
Battery recharge
Making/answering calls, intercomWhile programming, the 
handset starts to ring.LA call is being received. Answer the call and 
start again after hanging up.
I cannot register a handset to a 
base unit.LThe maximum number of handsets (6) is 
already registered to the base unit. Cancel 
unused handset registrations from the base 
unit (page 28).
LPlace the handset and the base unit away 
from other electrical...

Useful Information
47For assistance, please visit http://www.panasonic.com/help
*1 KX-TG6322/KX-TG6323/KX-TG6324
Caller IDI cannot make long distance 
calls.LMake sure that you have long distance 
service.
ProblemCause/solution
Caller information is not 
displayed.LYou need to subscribe to Caller ID service. 
Contact your service provider/telephone 
company for details.
LIf your unit is connected to any additional 
telephone equipment such as a Caller ID box 
or cordless telephone line jack, plug the...

Useful Information
48For assistance, please visit http://www.panasonic.com/help
Answering system (KX-TG6322/KX-TG6323/KX-TG6324)The 2nd caller’s information is 
not displayed during an outside 
call.LIn order to use Caller ID, call waiting, or Call 
Waiting Caller ID (CWID), you must first 
contact your service provider/telephone 
company and subscribe to the desired 
service.
After subscribing, you may need to contact 
your service provider/telephone company 
again to activate this specific service,...

Useful Information
49For assistance, please visit http://www.panasonic.com/help
Liquid damage
Caution:
LTo avoid permanent damage, do not use a microwave oven to speed up the drying 
process. While recording a greeting 
message or listening to 
messages, the unit rings and 
recording stops.LA call is being received. Answer the call and 
try again later.
ProblemCause/solution
Liquid or other form of moisture 
has entered the handset/base 
unit.LDisconnect the AC adaptor and telephone line 
cord from the...

Useful Information
50For assistance, please visit http://www.panasonic.com/help
FCC and other information
This equipment complies with Part 68 
of the FCC rules and the requirements 
adopted by the ACTA. On the bottom 
of this equipment is a label that 
contains, among other information, a 
product identifier in the format 
US:ACJ----------.
If requested, this number must be 
provided to the telephone company.
L Registration No. ............(found on 
the bottom of the unit)
L Ringer Equivalence No....