Panasonic Kx Tg2388 Operating Instructions Manual

Useful Information
For assistance, please visit http://www.panasonic.com/consumersupport61
Troubleshooting
If the handset display shows error messages, see “If the Following Appear on Your 
Display...” (p. 60) for the Cause & Remedy.
ProblemCause & Remedy
“No link to base. 
Move closer to 
base, try again.” is 
displayed and an alarm 
tone sounds.LYou are too far from the base unit. Walk closer to the 
base unit.
LConfirm the base unit’s AC adaptor is plugged in.
LRaise the base unit antenna.
LIf the...

Useful Information
62For assistance, please visit http://www.panasonic.com/consumersupport
You cannot make an 
intercom/outside call.LYour handset is in remote operation mode (page 49). 
Exit by pressing {OFF}.
LThe handset you called is too far from the base unit.
LIf the handset or base unit is in use, you may not be able 
to make a call. Try again later.
LIf you are entering a phone number, or the handset 
enters the caller list, phonebook, redial list or one-touch 
dialer while the Talking Keypad or...

Useful Information
For assistance, please visit http://www.panasonic.com/consumersupport63
The handset cannot 
automatically edit the 
caller list/incoming phone 
numbers.LThe Caller ID number auto edit feature is turned off. 
Turn it on (page 42) and try again.
LYou need to press {C} or {s} after editing the number.
The handset display exits 
the caller list or 
phonebook.LDo not pause for over 60 seconds while searching.
The Ringer/Message 
Alert indicator flashes 
slowly when the handset 
is not...

Useful Information
64For assistance, please visit http://www.panasonic.com/consumersupport
When Name 
Announcement is turned 
on, the handset does not 
announce names 
properly.LIf the name has more than 10 syllables, it will not be 
announced correctly. Maximum syllables that can be 
announced is 10. One digit of the number is counted as 
one syllable.
LIf the name has been abbreviated or an acronym is 
used, it may not be announced correctly. We 
recommend inserting a space between each letter 
(page...

Useful Information
For assistance, please visit http://www.panasonic.com/consumersupport65
Answering System
ProblemCause & Remedy
The Answering System is 
on, but incoming 
messages are not 
recorded.LThe recording time is set to “Greeting only”. Select “1 
minute”, “2 minutes” or “3 minutes” (page 54).
LMemory is full. Erase unnecessary messages 
(page 49)
“ E ” flashes and the 
ANSWER ON indicator 
flashes rapidly. No new 
messages are recorded.LMemory is full. Erase unnecessary messages 
(page 49)....

Useful Information
66For assistance, please visit http://www.panasonic.com/consumersupport
General
ProblemCause & Remedy
The unit does not work.LCheck the settings (page 8).
LCheck whether the dialing mode setting is correct 
(page 15).
LFully charge the battery (page 9).
LClean the charge contacts and charge again (page 10).
LCheck battery installation (page 9).
LUnplug the base unit’s AC adaptor to reset it. Plug in, 
and try again.
LRe-install the battery (page 9) and fully charge it.
“Recharge...

Useful Information
For assistance, please visit http://www.panasonic.com/consumersupport67
FCC and other information
This equipment complies with Part 68 of 
the FCC rules and the requirements 
adopted by the ACTA. On the bottom of 
this equipment is a label that contains, 
among other information, a product 
identifier in the format US:ACJ----------.
If requested, this number must be 
provided to the telephone company.
L Registration No
    ............(found on the bottom of the unit)
L Ringer...

Useful Information
68For assistance, please visit http://www.panasonic.com/consumersupport
When you hold the phone to your ear, 
noise might be heard in your Hearing Aid. 
Some Hearing Aids are not adequately 
shielded from external RF (radio 
frequency) energy. If noise occurs, turn 
the Hearing Aid mode to Telecoil. If noise 
is still heard, use an optional accessory 
headset or the speakerphone option (if 
applicable) when using this phone. 
Consult your audiologist or Hearing Aid 
manufacturer about...

Useful Information
For assistance, please visit http://www.panasonic.com/consumersupport69
FCC RF Exposure Warning:
The product complies with FCC radiation 
exposure limits set forth for an 
uncontrolled environment. To comply 
with FCC RF exposure requirements the 
base unit must be installed and operated 
with its antenna located 20 cm or more 
between antenna and all person’s body 
(excluding extremities of hands, wrist 
and feet). The handset may be carried 
and operated with only the specific...

Useful Information
70For assistance, please visit http://www.panasonic.com/consumersupport
Specifications
Base unit
Operating environment:
5 °C – 40 °C (41 °F – 104 °F)
Frequency:
2.4 GHz – 2.48 GHz
Dimensions:
Approx. height 85 mm x width 175 mm x 
depth 200 mm (3 
11/32 x 6 7/8 x 7 7/8)
Mass (Weight):
Approx. 470 g (1.04 lb.)
Power consumption:
Standby: Approx. 2.0 W
Maximum: Approx. 5.4 W
Power supply:
AC adaptor (120 V AC, 60 Hz)
TX power:
125 mW (max.)
Handset
Operating environment:
5 °C – 40 °C (41...