Panasonic Kx Taw848 Feature Manual

4.2 System [2]
Feature Guide 261
Lunch
Specifies the number (extension number or floating extension number of incoming call 
distribution group) to be designated as the PBX operator in the lunch mode.
Break
Specifies the number (extension number or floating extension number of incoming call 
distribution group) to be designated as the PBX operator in the break mode.
Night
Specifies the number (extension number or floating extension number of incoming call 
distribution group) to be designated as the PBX...

4.2 System [2]
262 Feature Guide
4.2.4 BGM / Music on Hold [2-3]
The audio source of the music to be played when a party is placed on hold or transferred can 
be selected.
Music Source of BGM
Selects the audio source of BGM.
Music on Hold
Selects the audio source for Music on Hold.
Sound on Transfer
Selects the audio source for Sound on Transfer (either the same music source chosen for the 
Music on Hold, or ringback tone).Programming References
4.2.8 Time Service—Week Table [2-5-1]
4.2.10 Numbering...

4.2 System [2]
Feature Guide 263
4.2.5 Timers & Counters—CO / Extension [2-4-1]
Various system timers and counters can be programmed.
Intercept Timer (Day/Lunch/Break/Night)
Specifies the length of time until a CO line call is redirected to the intercept routing destination 
in each time mode.
Hold Recall Timer
Specifies the length of time until the holding extension receives a Hold Recall ring when a held 
call remains unretrieved.
Transfer Recall Timer
Specifies the length of time a transferred call...

4.2 System [2]
264 Feature Guide
Forced CO Line Disconnect Timer for Hold Recall
Specifies the length of time until a held CO line call is disconnected after the holding extension 
receives the Hold Recall.
Hot Line (Pickup Dial) Start Timer
Specifies the length of time until automatic dialing star ts after going off-hook.
Extension First Digit Timer
Specifies the length of time within which the first digit of a feature number (e.g., extension 
number) must be dialed before reorder tone is heard....

4.2 System [2]
Feature Guide 265
Extension Inter Digit Timer
Specifies the length of time within which subsequent digits must be dialed before the PBX 
sends reorder tone.
Analog CO First Digit Timer to Mute Caller’s Voice during Dialing
Specifies the length of time within which the first digit of a telephone number must be sent to 
an analog CO line before the PBX recognizes end of dialing and cancels muting caller’s voice 
sent to the analog CO line.
Analog CO Inter Digit Timer to Mute Caller’s Voice...

4.2 System [2]
266 Feature Guide
Extension PIN Lock Counter
Specifies the number of successive incorrect PIN entries before the extension PIN is locked. 
(Specifying 0 disables the counter.)
On hook Waiting Time for call from VM to CO
Specifies the length of time from when the VPS seizes a CO line (for example, to transfer a call) 
until the VPS goes on hook. If the time specified here is too short, the VPS will be unable to 
dial the number and make a connection.
4.2.6 Timers & Counters—DISA/DPH/CONF/T....

4.2 System [2]
Feature Guide 267
DISA First Digit Timer for Routing to Operator when No Dial
Specifies the length of time after the OGM in which the caller must begin dialing before the call 
is redirected to the operator.
DISA Second Digit Timer for Automated Attendant
Specifies the length of time after the OGM in which the caller must dial the second digit before 
the DISA AA Service activates.
DISA Intercept Timer (Day/Lunch/Break/Night)
Specifies the length of time until a DISA call is intercepted...

4.2 System [2]
268 Feature Guide
DISA Disconnect Timer after Intercept 
Specifies the length of time until an intercepted DISA call is disconnected after the DISA 
Intercept time expires.
DISA CO-to-CO Line Call Prolong Counter 
Specifies the number of times the caller can prolong a CO-to-CO line call on the DISA line. 
(Specifying 0 enables the caller to prolong the CO-to-CO line call without restriction.)
DISA CO-to-CO Line Call Prolong Time 
Specifies the length of time a CO-to-CO line call on the...

4.2 System [2]
Feature Guide 269
Progress Tone Continuation Time before Recording Message
Specifies the length of time a progress tone is sent to the manager extension before recording 
an OGM.
DISA Reorder Tone Duration Time
Specifies the length of time a reorder tone is sent to the caller before the call is disconnected.
Doorphone Call Duration Time
Specifies the length of time until the ringing stops and the call is canceled when there is no 
answer.
Doorphone Call Duration Limitation Time
Specifies...

4.2 System [2]
270 Feature Guide
Door Open Duration Time
Specifies the length of time the door stays unlocked.
Timed Reminder : Repeat Counter
Specifies the number of times the alarm is repeated.
Timed Reminder : Interval Time
Specifies the length of time between the repeated alarms.
Timed Reminder : Alarm Ringing Duration Time
Specifies the length of time the alarm rings.Programming References
4.5.1 Doorphone [5-1]
Default5 s
Va lu e  Ra n g e2–7 s
Feature Guide References
Feature References
1.15.2...