Panasonic Kx Flm600 Operating Instruction Manual

21
Setup
Initial Preparation
Before installation!
Shipping tape Remove the shipping tape.
Shipping tape
Toner cartridge and drum unit!
Caution:
³If ingestion of toner occurs, drink several glasses of water to dilute stomach contents, and seek immediate
medical treatment. If toner comes into contact with eyes, flush thoroughly with water, and seek medical
treatment. If toner comes into contact with skin, wash thoroughly with soap and water.
³Do not put up the toner cartridge.
³Do not open the protection...

22
Setup
6
Open the protection bag by cutting the end of the
bag, and remove the drum unit.
5
Install the toner cartridge by holding the two tabs
and matching the triangles.
Protection bagToner cartridge
Drum unit
3
Remove the tape and remove the protection cap by
holding the tab.
Caution:
³Do not touch the roller.
³Do not put up the toner cartridge.Protection cap
4
Rock the toner cartridge from side to side several
times carefully.
Triangles Tape
Tape Tab
Tabs
2
Open the protection bag by cutting the...

23
Setup
Initial Preparation
7
Remove the tape and protection cap.
Protection capDrum unit
Green drum
surface
8
Remove the protection sheet.
Caution:
³Do not touch or scratch the green drum
surface as this may damage the drum unit.
³Do not expose the drum unit to light for more
than 5 minutes as this may damage the drum
unit.
Protection
sheetTape
9
Install the drum unit on the toner cartridge by
holding the two tabs and matching the triangles.
Drum unit
Toner
cartridge
Dotted
area Triangles
Tabs
10
Close...

24
Setup
1
Lift the paper cassette up slightly and pull it out of
the unit.
2
Fan the stack of paper to prevent a paper jam and
place the paper into the paper cassette.
³Put the side to be printed face up.
³The height of the stack of paper should not
exceed the upper limit on the paper cassette, or
the paper may jam or multi-feed.
³When using legal size paper, see next page.
Recording paper!
You can load letter or legal size paper in the paper cassette. The paper cassette can hold up to 250 sheets of
75...

25
Setup
Initial Preparation
Using legal size paper
A
B
Button Press and hold the button on the paper cassette to
release the tray (A), and slide the tray so that “LGL” on
the tray aligns with “” on the cassette and lock into
place (B).Tray
Checking the amount of remaining recording paper
You can see the amount of remaining paper without removing the paper cassette.
Types of paper to avoid
³Extremely smooth or shiny paper or paper that is highly textured
³Coated papers
³Letterhead imprinted with low...

26
Setup
2
Open the paper stacker.
Paper stacker
1
Insert the two tabs of the paper tray into the slots
on the paper cassette.
Paper tray!
Tab Paper tray
Slots
2
Open the paper tray extender by pressing “$”
marked area.
Paper tray
extender
Paper stacker!
Paper cassette
1
Press “$” marked area on the paper stacker.
Paper stacker Tab 

27
Setup
Initial Preparation
Connections!
Wall jack
(RJ11C)Power cord
Line surge
protector(         )
120 V, 60 Hz
Power surge
protector(          )
Telephone 
line cord
Handset cord
Connect to “LINE”.
Note:
³For additional equipment protection, we recommend the use of a surge protector. The following types are
available; TELESPIKE BLOK MODEL TSB (TRIPPE MFG. CO.), SPIKE BLOK MODEL SK6-0 (TRIPPE
MFG. CO.), SUPER MAX (PANAMAX) or MP1 (ITW LINX).
The warranty does not cover damage due to power line surges...

28
Setup
1
Press (MENU).
Display:
2
Press (#), then (1)(6).
3
Press (START/SET/COPY).
4
Press  or  to select the size of paper you
load.
5
Press (START/SET/COPY).
6
Press (MENU).
SETUP ITEM [  ]
=LETTERts
PAPER SIZE
1.SYSTEM SET UP
Recording paper size!
Set the size of recording paper you load in the paper cassette.
This setting is used when the unit determines the reduction rate for incoming faxes.
The following choices are available.
LETTER:216 mmk279 mm (8
1⁄2qk11q)
A4:210 mmk297 mm (May not be...

29
Setup
Initial Preparation
Fax Correspondence
Your logoYour facsimile telephone numberDate and time
FROM : Panasonic FaxExample:FAX NO. : 1234567 Feb. 26 1999 04:02PM  P1
Date and time, your logo and facsimile 
telephone number!
You should program the date and time, your logo and facsimile telephone number.This information will be
printed on each page transmitted from your unit, fulfilling the requirements of the Telephone Protection Act of 1991.
Setting the date and time
/MENU
START/SET/COPY
STOPJOG...

30
Setup
Setting your logo
The logo can be your company, division or name.
/MENU
START/SET/COPY
STOP
JOG DIAL
INSERT
HYPHEN
To correct a mistake
³Press (Þ)or (ß)to move the cursor to the
incorrect character, then make the correction.
To delete a character
³Move the cursor to the character you want to
delete and press (STOP).
To insert a character
1.Press (Þ)or (ß)to move the cursor to the right
of where you want to insert the character.
2.Press (INSERT)(One-Touch Dial key 2) to insert
a space and enter...