Palm Tungsten T Instruction Manual

Recharging problems
261
Recharging problems
My phone connection drops 
before I finish using it.nYou need to increase the Idle timeout setting on the 
Network Preferences Details screen. See“Adding detailed 
information to a network service profile” in Chapter 17 for 
instructions.
I get an error message when I try 
to dial a phone number using 
my handheld.
nMake sure that the proper phone driver is installed on your 
handheld. See“Updating the phone files on your 
handheld” in Chapter 12 for...

Appendix B Frequently Asked Questions
262
Password problems
Problem Solution
I forgot the password, and my 
handheld is not locked.nFirst, use the password hint to try and remember the 
password. If this doesn’t help or if you do not have a 
password hint, you can use Security to delete the password, 
but your handheld deletes all entries marked as private. 
However, if you perform a HotSync operation before you 
delete the password; the HotSync process backs up all 
entries, whether or not they are...

Technical support
263
Technical support
If, after reviewing the sources listed at the beginning of this appendix, you cannot 
solve your problem, go to 
www.palm.com/support or send an e-mail to your 
regional technical support office. 
Before requesting support, please experiment a bit to reproduce and isolate the 
problem. When you do contact support, please provide the following information:
nThe name and version of the operating system you are using
nThe actual error message or state you are...

Appendix B Frequently Asked Questions
264 

265
Product Regulatory Information
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two 
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any 
interference received, including interference that may cause undesired operation.
NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device, 
pursuant to Part 15 of the FCC rules. These limits are designed to provide...

Product Regulatory Information
266
MPE (Maximum Permissible Exposure) Statement
RF Exposure Compliance:
In order for this device to comply with FCC rules, under the provision of Part 15.247(b)(c), it must 
operate in a manner that ensures that the public is not exposed to radio frequency energy levels in 
excess of the Maximum Permissible Limits (MPE).
It is recommended that the antenna of this device be placed at 20 cm or more from its user and any 
nearby persons, during continuous and extended data...

Product Regulatory Information
267
1. Before using this product, confirm that other wireless transmitters are not in use nearby.
2. In the unlikely event that there is electronic interference between this product and other wireless 
transmitters, quickly change the operating frequency of this product, change the location of 
operation, or stop operating the product (cease transmission of a signal).
3. If other electrical interference or related problems should occur, contact the responsible party.
Europe...

Product Regulatory Information
268
Taiwan Statement
Article 14: Unless approved, for any model accredited low power radio frequency electric machinery, 
any company, trader, or user shall not change the frequency, increase the power, or change the 
features and functions of the original design.
Article 17: Any use of lower power radio frequency electric machinery shall not affect the aviation 
safety and interfere with legal communications. In even that any interference is found, the use of such...

Product Regulatory Information
269
Uwaga 

Product Regulatory Information
270