Oce CS2044 User Manual

41
Adjusting the Print Status
27.Select Standard Adj. then press the [ ] button.[112] 
[113] 
28.Press the [ ] or [ ] button to select Ye s, then press the OK button.[114] 
[115] 
The media feed adjustment pattern is printed.[116] 
The printer scans the printout as it is printing and automatically calibrates the media 
feed settings for the currently selected media type. There are separate media feed 
settings for each different media type.
When the calibration is complete, the Online lamp turns on and...

42 Chapter 1 Read this first
Installing for Windows
Installing for Windows
Connecting USB
Attention: Do not connect the cable yet. If you connect the cable now, this may 
prevent the printer driver from installing correctly.
Attention: Make sure that the printer is switched on.
Attention: If your are using Windows Server 2003 or Windows XP, or Windows 
2000, you must log in as a member of the Administrator group.
Attention: Be sure to use a USB 2.0 standard connection cable.
29.Mount the provided User...

43
Installing for Windows
31.Follow the procedure to complete the installation.
When the port connection screen appears, connect the USB cable to the printer and 
the computer.
[119] 
Connecting the LAN Cable
Note: The following operating systems support a TCP/IP network connection: 
Windows Server 2003, Windows XP, Windows 2000, Windows Me, Windows 98, or 
Windows NT 4.0 (Service Pack 6 or later).
Attention: When this printer is connected to and used on a network, switch the 
printer on then check the...

44 Chapter 1 Read this first
Installing for Windows
Installing the Printer Driver
Attention: If you are using Windows Server 2003, Windows XP, Windows 
2000, or Windows NT 4.0, you must log in as a member of the Administrator 
group.
Attention: If you are using Windows NT 4.0, open Network from the Control 
Panel in the Start menu and confirm that Microsoft TCP/IP Printing is 
installed and on the list on the Service sheet.
33.Connecting the Printer to a Network for the First Time
Mount the provided User...

45
Stowing the Output Stacker
Stowing the Output Stacker
1.Grasp the centre of the front output stacker rod (a) and pull it up slightly.[123] 
2.Then simply pull the output stacker rod (a) out towards you.[124] 
a
a
Downloaded From ManualsPrinter.com Manuals 

46 Chapter 1 Read this first
Stowing the Output Stacker
3.Lower the output stacker rod (a).[125] 
Note: To reattach the output stacker, perform the steps above in reverse.
a
Downloaded From ManualsPrinter.com Manuals 

47
If the output stacker arm disengages
If the output stacker arm disengages
Illustration
[126] 
[127] 
1.Turn the output stacker arm (a) in the direction indicated by the arrow.[128] 
d
e
d
f
a
Downloaded From ManualsPrinter.com Manuals 

48 Chapter 1 Read this first
If the output stacker arm disengages
2.Slide the rotated output stacker arm (b) in until it clicks into the 2 holes (c). If the 
rear output stacker rod (d) has dropped down, fit the output stacker arm (b) in place 
before re-attaching the output stacker rod.
[129] 
c
b
d
Downloaded From ManualsPrinter.com Manuals