Nortel Compact Ics 6.0 Installer Guide

P0992669 03Compact ICS 6.0 Installer Guide
Upgrading your system         
Only qualified persons should service the system.
The installation and service of this unit is to be 
performed only by service personnel having 
appropriate training and experience necessary to be 
aware of hazards to which they are exposed in 
performing a task and of measures to minimize the 
danger to themselves or other persons.
Electrical shock hazards from the telecommunication 
network and AC mains are possible with this...

62 / Upgrading your system
Compact ICS 6.0 Installer GuideP0992669 03
Upgrading a restricted Feature Cartridge
You can upgrade your restricted feature cartridge by entering a series of 
Software Keys you obtain from Nortel Networks. This will add an 
additional eight ports for Norstar telephones. Refer Software Keys on page 
242 for more information.
Upgrading from 16 telephones to 24 telephones
The third slot in the ICS is used for an 8-port Expansion Cartridge, with or 
without clocking. Installing a...

Upgrading your system / 63
P0992669 03Compact ICS 6.0 Installer Guide
Upgrading to Compact ICS 6.0
When you upgrade from Compact ICS 4.0 or 4.2 to 6.0:
Lines 001 to 025 are renumbered to 001 to 030, and lines numbered 
025 to 048 are renumbered to 031 to 060. Any peripheral devices that 
use these lines must be reprogrammed. Consequently, target lines have 
also been renumbered to 61-86.
The I-RAD password, found under Passwords in programming, resets 
to the default value. 
1. Verify your system...

64 / Upgrading your system
Compact ICS 6.0 Installer GuideP0992669 03
The I-RAD password, found under Passwords in programming, resets 
to the default value. 
If your programming uses a dialing string between 73-89 (for example, 
as destination codes), the programming is overwritten to create the 
DNs for ISDN terminal equipment.
You can upgrade directly from Compact ICS 2.0 to 4.2. 
1. Verify your system programming, and update the Programming 
Record.
2. Disconnect all central office and station line...

Upgrading your system / 65
P0992669 03Compact ICS 6.0 Installer Guide
Note: If you want to upgrade from a configuration that does not support 
programmable prompts for the Auto Attendant, to one that does have 
programmable prompts, you will have to obtain the Compact ICS 6.0 
standard software, I-RAD enabled, Auto Attendant with programmable 
prompts configuration.
Upgrading Expansion Cartridge for BRI Card 
installation
The ICS must be equipped with an Expansion Cartridge with Clocking or 
a Clocking...

66 / Upgrading your system
Compact ICS 6.0 Installer GuideP0992669 03 

P0992669 03Compact ICS 6.0 Installer Guide
Installation
Only qualified persons should service the system.
The installation and service of this unit is to be 
performed only by service personnel having 
appropriate training and experience necessary to be 
aware of hazards to which they are exposed in 
performing a task and of measures to minimize the 
danger to themselves or other persons.
Electrical shock hazards from the telecommunication 
network and AC mains are possible with this 
equipment. To...

68 / Installation
Compact ICS 6.0 Installer GuideP0992669 03
Installation checklist
åtest all ISDN network connections, if any
åmount the Integrated Communications System (ICS) 
åinstall the Feature Cartridge
åinstall the Trunk Cartridge and BRI Cards (as required)
åinstall the appropriate expansion or clocking cartridge
Note: You must use the Expansion Cartridge with Clocking or Clocking 
Cartridge to support BRI Cards)
åcomplete the wiring, but do not connect the central office and station 
line...

Installation / 69
P0992669 03Compact ICS 6.0 Installer Guide
 
Avoid electrical shock.
To avoid electrical shock hazard to personnel, or 
equipment damage, observe the following precautions 
when installing telephone equipment:
Always disconnect telecommunication network 
connections before disconnecting the AC power plug.
Never connect the central office and station line connectors 
until you have connected the power plug.
Never install telephone wiring during a lightning storm.
Never install telephone...

70 / Testing the ISDN network connection
Compact ICS 6.0 Installer GuideP0992669 03
Testing the ISDN network connection
Before you install a Norstar system which uses BRI Cards, you should test 
your connection to the ISDN network. 
If you are installing a system which connects to the network using BRI-ST 
Cards, the network connection must be equipped with an NT1. See the 
ISDN chapter and the wiring information in this chapter for more 
information about installing an NT1. 
To test the ISDN...