Nokia 6800 User Guide
Have a look at the manual Nokia 6800 User Guide online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 96 Nokia manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
Copyright 2003 Nokia. All rights reserved.31 Charging the battery1. Connect the lead from the charger to the socket on the bottom of your phone. 2. Connect the charger to an AC wall socket. The text Charging is displayed briefly if the phone is switched on. If the battery is completely flat, it may take a few minutes before the charging indicator appears on the display or before any calls can be made. You can use the phone while the charger is connected. The charging time depends on the charger and the battery used. For example, charging a BLC-2 battery with the ACP-12 charger takes about 1 hour and 30 minutes while the phone is in standby mode.Switching the phone on and offTo switch the phone on or off, when the flip is closed, press and hold the power key . To switch the phone off when the messaging keyboard is open, press and hold the profile key on the top right corner of the display. To switch the power on, when the phone’s messaging keyboard is open and the phone is switched off, press the power key (left selection key) .
Copyright 2003 Nokia. All rights reserved.32 Note that if the phone displays Insert SIM card even though the SIM card is properly inserted, or SIM card not supported, contact your network operator or service provider. Your phone does not support 5-Volt SIM cards and the card may need to be changed. If the phone asks for a PIN code, key in the PIN code (displayed as ****), and press OK. See also PIN code request in Security settings on page 104 and on page 104. If the phone asks for a security code, key in the security code (displayed as *****), and press OK. See also Access codes on page 14. Warning: Do not switch the phone on when wireless phone use is prohibited or when it may cause interference or danger. TIPS ON EFFICIENT OPERATION: Your phone has a built-in antenna. As with any other radio transmitting device, do not touch the antenna unnecessarily when the phone is switched on. Contact with the antenna affects call quality and may cause the phone to operate at a higher power level than otherwise needed. Not touching the antenna area during a phone call optimises the antenna performance and the talktime of your phone.
Copyright 2003 Nokia. All rights reserved.33 Opening the flip1. Hold the phone with both hands and open the flip as shown in picture (1).
Copyright 2003 Nokia. All rights reserved.34 2. Turn the flip until you hear it click into place (2). Make sure that the golden contacts of the flip and the phone touch each other. 3. Turn the phone to a horizontal position and hold it as shown in picture (3). The loudspeaker function automatically activates when the flip is open.
Copyright 2003 Nokia. All rights reserved.36 Switching the keyboard lights on or offThe keyboard lights are not lit automatically, when you open the flip. To turn on the lights, press the light key on the top left corner of the keyboard. The keyboard lights are switched off after a certain time, but they are turned on again as soon as you press any key. To switch the keyboard lights off, press the keyboard light key or close the flip. Keypad lock (Keyguard)You can lock the keypad to prevent the keys being accidentally pressed, for example, when your phone is in your handbag. You can lock the keypad only when the flip is closed. Locking the keypad In standby mode, press Menu and then within 1.5 seconds. Unlocking the keypad Press Unlock and then within 1.5 seconds or open the flip. Note that the keyguard will not be activated, if you close the flip. To answer a call when the keyguard is on, press . During a call, the phone can be operated normally. When you end or reject the call, the keypad will be locked automatically.
Copyright 2003 Nokia. All rights reserved.37 For locking the keypad during a call, see Options during a call on page 42 and for setting the security keyguard, see Security keyguard on page 98. Note: When Keyguard is on, calls may be possible to the emergency number programmed into your phone (e.g. 112 or other official emergency number). Key in the emergency number and press . The number is displayed only after you have keyed in its last digit.
Copyright 2003 Nokia. All rights reserved.38 3. Call functionsMaking a call1. Key in the phone number, including the area code. If you key in an incorrect character, press Clear to delete it. With the flip open in standby mode, pressing any number key starts a call procedure. For international calls, press twice for the international prefix or + if the flip is open, (the + character replaces the international access code) and then key in the country code, the area code without the leading 0, if necessary, and finally the phone number. 2. Press to call the number. 3. Press to end the call or to cancel the call attempt. See also Options during a call on page 42. Making a call using contacts See Searching for a name in contacts on page 53. Press to call the number on the display. Last number redialling In standby mode, press once to access the list of the last 20 numbers you called or attempted to call. Scroll to the number or name that you want, and press to call the number.
Copyright 2003 Nokia. All rights reserved.39 Calling your voice mailbox In standby mode when the flip is closed, press and hold , or press and When the flip is open, press and hold the corresponding number key on the keyboard. If the phone asks for the voice mailbox number, key it in and press OK. See also Voice messages on page 85.Speed dialling a phone numberBefore you can use speed dialling, do as follows: 1. Press Menu, select Settings, Call settings and Speed dialling. Set the setting to On. See also Speed dialling on page 96. 2. Assign a phone number to one of the speed dialling keys from to , see Speed dialling on page 56. 3. Call the number in either of the followin g ways: Press the speed dialling key you want and then press . You can also activate speed dialling by pressing the corresponding number key, when the flip is open. If Speed dialling is set to on, press and hold a speed dialling key until the call is started.
Copyright 2003 Nokia. All rights reserved.40 Making a conference callConference calling is a network service that allows up to six people to take part in a conference call. 1. Make a call to the first participant. 2. To make a call to a new participant, press Options and select New call. 3. Key in the phone number of the new participant, or retrieve it from the memory, and press Call. The first call is put on hold. 4. When the new call has been answered, join the first participant in the conference call. Press Options and select Conference. 5. To add a new participant to the call, repeat steps 2 to 4. 6. To have a private conversation with one of the participants: Press Options and select Private and select the desired participant. Rejoin the conference call as described in step 4. 7. To end the conference call, press .