NEC Neax 2400 Ipx Fusion Network System Manual

							CHAPTER 5 NDA-24299
Page 136
Revision 1.0
DATA PROGRAMMING
Office Data Sheets
8.13 Data Sheet for ACAN
FUSION POINT CODE 
(FPC)
1-253FUSION CIC NUMBER 
(FCIC)
1-4095CONNECTION EQUIPMENT 
NUMBER 
(C_LENS)REMARKS 
						

							NDA-24299 CHAPTER 5
Page 137
Revision 1.0
DATA PROGRAMMING
Office Data Sheets
8.14 Data Sheet for AFRT
FCCH NUMBER 
(FCHN)
1-255CONNECTION ROUTE (C_RT) 1-1023
12345678 
						

							CHAPTER 5 NDA-24299
Page 138
Revision 1.0
DATA PROGRAMMING
Office Data Sheets
8.15 Data Sheet for AFRFL 
TN FPC (1-253)ACC 
MAX. 24 digits 
						

							NDA-24299 CHAPTER 5
Page 139
Revision 1.0
DATA PROGRAMMING
Office Data Sheets
8.16 Data Sheet for AETH 
Note:
“USE_GATE” data is automatically set and  this parameter won’t appear on the MAT display.
DESTINATION 
FPC
(FPC)
1-253GATEWAY
USING FLAG
(USE_GATE)
       0/1 NoteFCCH
NUMBER
(FCHN)
1-255CONNECTION 
ROUTE
(C_RT)
1-1023DESTINATION
IP ADDRESS
(DST_IP)NEXT IP
ADDRESS
(NEXT_IP) 
						

							CHAPTER 5 NDA-24299
Page 140
Revision 1.0
DATA PROGRAMMING
Office Data Sheets
8.17 Data Sheet for AGIP
a.) When “KIND=FGH” is selected
KIND OF 
SELECTION
(KIND)LINE
EQUIPMENT 
NUMBER OF
FGH
(FCHEN)FGH IP
ADDRESS
(FGH_IP)IP ADDRESS 
FOR 
DEFAULT
GATEWAY
(DG_IP)FRAME
TYPE
OF
ARP
(ARP)VO I C E
CHANNEL
CONTROL
TYPE
(CONT-
TYP)QSIG-PRIME
LINK NUMBER
(LINK_NUM)
0-32CLIENT/
SERVER
CONNECTION
MAX. NUMBER
(CSLINK_NUM)NET 
MASK
(NETMSK) 
						

							NDA-24299 CHAPTER 5
Page 141
Revision 1.0
DATA PROGRAMMING
Office Data Sheets
b. ) W h e n “KIND=IPTRK (CCIS/FCCS)” is selected (Continued)
KIND OF
SELECTION
(KIND)LINE
EQUIPMENT
NUMBER OF
IPTRK
(IPTEN)IPTRK IP
ADDRESS
(IPTK_IP)IP ADDRESS
FOR DEFAULT
GATEWAY
(DG_IP)FRAME
TYPE OF
ARP
(ARP)THE MAXIMUM
LINK NUMBER
OF CLIENT
(CLINK_NUM)THE MAXIMUM
LINK NUMBER
OF SERVER
(SLINK_NUM) 
						

							CHAPTER 5 NDA-24299
Page 142
Revision 1.0
DATA PROGRAMMING
Office Data Sheets
b. ) W h e n “KIND=IPTRK (CCIS/FCCS)” is selected (Continued)
NET MASK
(NETMSK)KIND OF MULT
CONNECTION
(MULT)IP ADDRESS
OF
DESTINATION
IPTRUK
(DST_IP)QoS DATA FOR
SIGNAL ROUTE
(QoS 1)
0-7QoS DATA FOR
SPEECH PATH
(QoS 2)
0-7NETWORK
ID
(NETID)
0-15 
						

							NDA-24299 CHAPTER 5
Page 143
Revision 1.0
DATA PROGRAMMING
Office Data Sheets
8.18 Data Sheet for AFIP
FCH
NUMBER
(FCHN)LINE EQUIPMENT
NUMBER OF FGH
(FGHEN)LINE EQUIPMENT
NUMBER OF
QSIG-PRIME Bch
(LENS)ROUTER ACCESS NUMBER
(RT_ACC)
Max. 16 digits
MG U G LV MG U G LV 
						

							CHAPTER 5 NDA-24299
Page 144
Revision 1.0
DATA PROGRAMMING
Office Data Sheets
This page is for your notes. 
						

							NDA-24299 CHAPTER 6
Page 145
Revision 1.0
CHAPTER 6 POST INSTALLATION TEST
This chapter covers how to perform installation tests focusing on the Fusion Call Control Signal (denoted in the
remainder of this manual as FCCS) connections, after hardware installation and data assignment. This chapter
describes the following tests:
How to Check Fusion Link by LEDs on an FCH Card
Repair Procedure When LED Indicates Abnormality
FCCS Network Connection Test
FCCS Alternate Routing Test
Fusion and Non-Fusion Connection Test
At the end of this chapter, the Fusion Link Test Sheet is attached. Photocopy the sheet to record the test results. 
Figure 6-1 illustrates the network numbering that is used in this chapter to explain the installation tests.
Figure 6-1   Fusion Network
Note:
The Individual Trunk Access feature is not available for Fusion Trunks. To seize a specific Fusion Trunk,
use the MBCT command to make busy trunks which are not being tested. This command leaves the Fusion
trunk to be tested in an idle state.
1. How to Check Fusion Link by LEDs on FCH Card
Before performing the Fusion link test, be sure to check the Fusion Link LEDs. Refer to Figure 6-2 for the LED
indications. When the Fusion link is established, the LYR lamp lights green on the FCH (PA-FCHA) circuit
card. However, if it remains off, the layer 2 (Link Layer) is not established. If this is the case, follow the repair
procedure listed below.
  
.. . .. . ... ... ..... . .. . ... ... ..... . .. . ... ... ..... . .. . ... ... ...
  
... ... ... ... . ..... ... ... ... . ..... ... ... ... . ..... ... ... ... . ..F
CCS
LSTN: 410000 
STN: 2000 
 FCCS: Fusion Call Control Signal     STN: Physical Station Number     LSTN: Logical Station Number
LSTN: 420000 
STN: 2000
F
usi
on 
Li
nk
FUSION Network NodeA 
(self-Node)STNB NodeB 
(other Node)
STNA