NEC EliteMail Vms/Elitemail Limited Technician Guide




 	
 



 
 

 

	



 

Contents of this manual are subject to change without prior notice at the discretion of
NEC America, Inc.  This document has been prepared for the use of employees and
customers of NEC America, Inc. and may not be reproduced without prior written
approval of NEC America, Inc.
EliteMail and Electra Elite are trademarks of NEC America, Inc.  
Copyright 1999
 
NEC America, Inc.
1555 Walnut Hill Lane
Irving, TX  75038
Business Terminals Division 

SECTION 1 
G
ENERAL 
I
NFORMATIONThe  EliteMail VMS/EliteMail Limited system is people oriented, and speeds
communication between people using the very latest technology.
This system has a set of manuals that provide all the information necessary to
install and support the system.  The manuals are described in this preface.
SECTION 2 
T
HIS MANUALThis manual provides general information about the system features,
configuration, and standards.    Sections of this manual include:

Hardware Specifications...

Hardware Specificationsi
Table of Contents
Chapter  1 Hardware Description
Chapter  2 Installation
Section 1 Precautions .......................................................................................... 2-1
Section 2 Environmental Conditions .................................................................. 2-1
Section 3 Installing the  DSP-F-21 Unit on the VMS(4)-U10 ETU ..................... 2-1
Section 4 Upgrade EliteMail Limited to 4-Ports ....................................................

Hardware Specificationsiii
List of Figures
Figure 2-1  DSP-F-21 Unit Installation .............................................................................................  2-2
Figure 2-2  FMS(  )-U10 ETU ..........................................................................................................  2-4
Figure 2-3  Install Modem Kit Unit ...................................................................................................  2-6 

Hardware Specifications1 - 1
Hardware Description
 	
The EliteMail VMS, VMS(  )-U10 ETU, is a 2-port, 4-port, or 8-port
interface that can be installed in any interface slot in the Electra Elite
system.  The 2-port or 4-port configuration includes one digital signal
processor (DSP); the 8-port configuration requires an additional DSP-F-21
Unit.
The EliteMail Limited, FMS(  )-U10 ETU, is a 2- or 4-port interface that can
be installed in any interface slot in the Electra Elite system.  
This...

Hardware Specifications2 - 1
Installation 
 

SECTION 1     
P
RECAUTIONSThe ETUs used in this system make extensive use of CMOS technology
that is very susceptible to static electricity.  Static discharge must be
avoided
 when handling ETUs.  Always use the following precautions:

Wear a grounded wrist strap anytime you handle an ETU.

Make all ETU DIP switch setting changes before inserting the ETU in
the KSU.  

Carry ETU in a conductive polyethylene bag to prevent static
electricity damage....

Issue 3 EliteMail VMS/EliteMail Limited
2 - 2Installation To upgrade a VMS(2)-U10 ETU to VMS(4)-U10 ETU
1. Connect the PC to the VMS( )-U10 ETU.
2. Shut down the Voice Mail Application.
3. From the C:\VMAIL prompt, enter ACTIVATE.
4. Enter the Activation Code. (Call NEC customer service for this code).  
5. Restart Voice Mail system. 
Figure 2-1   DSP-F-21 Unit Installation
Piggyback on ETU
(DSP-F-21 Unit)
Auxiliary DSP 

EliteMail VMS/EliteMail Limited Issue 3
Hardware Specifications2 - 3 To upgrade VMS(4)-U10 ETU to VMS(8)-U10 ETU 
1. Verify that the HDD LED on the VMS(4)-U10 ETU is off.
2. Verify that the BCLR LED is green.
3. Turn off the MB (Make Busy) switch and verify that the MB LED is
on.
4. Wear a grounding strap when removing the VMS(4)-U10 ETU from
the Electra Elite KSU.
5. Locate connectors J10 and J8 on the left side of the ETU, and press
down on the DSP-F-21 Unit until a secure connection is made.
6. Return...

Issue 3 EliteMail VMS/EliteMail Limited
2 - 4Installation  
Figure 2-2   FMS(  )-U10 ETU