NEC Applications Manager Installation Manual

NDA-30025   Revision 4.0Page 55
APM System Installation Manual BACKUP AND RESTORATION PROCEDURES
15. Type n and press Enter.
The following message displays: “Do you wish to make any manual 
adjustments to the sizes or names of the  filesystems or swap area before they 
are created on the hard disk? (y/n)”. 
16. Type y and press Enter.
17. The the divvy table will displayed. The table will list the divisions (0 thru 7) on 
the hard disk and the names of each partition.  The root, swap, recover, and hd0a...

Page 56NDA-30025   Revision 4.0
BACKUP AND RESTORATION PROCEDURES APM System Installation Manual
Step 3: Restore the UAP
1. Insert a tape into the tape drive.
2. To restore the different filesystem, the root filesystem must be mounted first and 
restored. Type the following commands at the “#” prompt, pressing Enter after 
each:
(a)mount /dev/hd0root   /mnt 
(b)cd /mnt 
(c)cpio -icvmadu “[!o]*” < /dev/rStp0 
3. Once the root partition has been restored, the OAI and OAILOG filesystem will 
be restored. To...

NDA-30025   Revision 4.0Page 57
APM System Installation Manual TROUBLESHOOTING ISSUES
Chapter 6 TROUBLESHOOTING ISSUES
This chapter addresses some general-system issues that may cause an installation 
attempt to fail or to produce unpredictable results. If problems occur during 
installation, review the relevant chapter in this manual and verify that you have 
performed the procedures accurately, making sure that you have conducted the 
recommended testing procedures successfully. Then, review the...

Page 58NDA-30025   Revision 4.0
TROUBLESHOOTING ISSUES APM System Installation Manual
Step 2:“netstat”
At the “#” prompt, issue the netstat command, as illustrated below. This command 
shows the state of the interfaces that have been configured into the system.
Step 3:“ping” for Remote Host Connectivity
After successfully testing the “localhost” communications, use the “ping” 
command to verify that the connectivity of other network hosts is available. 
1. At the “#” prompt, type the ping command using...

NDA-30025   Revision 4.0Page 59
APM System Installation Manual TROUBLESHOOTING ISSUES
COM Port Usage
The typical UAP does not require use of the COM1 and COM2 serial I/O ports for 
OAI-related input. Generally the COM2 port which is assigned to Interrupt 
Request (IRQ) 3 will be disabled so that other communication devices to be 
installed later can use this address. Consult the CPU technical documentation to 
isolate the location of the correct switch settings often found on the mother board 
itself.
A...

TROUBLESHOOTING ISSUES APM System Installation Manual
Page 60NDA-30025   Revision 4.0
This Page Left Blank.