NEC Applications Manager Installation Manual

NDA-30025   Revision 4.0Page 35
APM System Installation Manual SCO UNIX SYSTEM V INSTALLATION
SunRiver 
Controller DeviceUse the following steps to install the SunRiver Controller device.
1. At the “#” prompt, type custom and press Enter.
The following menu displays:
2. Select the Install option using the arrow keys and press Enter. (Install is 
highlighted when it is selected.)
The following menu displays:
3ecd_]
C3? E>9H CicdU] F ?`UbQdY^W CicdU]
9^cdQ\\BU]_fU Ug @b_TeSd
C3? E>9H CicdU] F ?`UbQdY^W...

Page 36NDA-30025   Revision 4.0
SCO UNIX SYSTEM V INSTALLATION APM System Installation Manual
3. Select A New Product using the arrow keys and press Enter.
The following menu appears:
4. Select Entire Product using the arrow keys and press Enter.
5. At the prompt, insert the SunRiver Device Driver Floppy diskette and press 
Enter.
6. Press Enter at the prompt to continue the installation.
7. When the installation is complete, press Enter to continue.
The following information displays:
8. Press Enter.
9....

NDA-30025   Revision 4.0Page 37
APM System Installation Manual SCO UNIX SYSTEM V INSTALLATION
11. Enter the number of multiscreens per station and press Enter.
12. At the “Do you wish to relink the kernel now?” prompt, type y and press Enter.
13. When the driver installation completes, press Enter to continue.
14. To exit Custom, press the right arrow key until Quit is selected and press Enter.
15. Press Enter again while Yes is highlighted to exit.
16. Remove the SunRiver Terminal Driver floppy disk....

SCO UNIX SYSTEM V INSTALLATION APM System Installation Manual
Page 38NDA-30025   Revision 4.0
This Page Left Blank. 

NDA-30025   Revision 4.0Page 39
APM System Installation Manual APPLICATION MANAGER INSTALLATION
Chapter 4 APPLICATION MANAGER INSTALLATION
Use the information provided in this chapter to install the Application Manager 
(APM) on your system.
1. To begin the installation, the Application Manager must be installed from single 
user mode. To enter single user mode, you can reboot the system or use the 
shutdown -g0 -y -is command. 
To use the shutdown -g0 -y -is command, use the following steps:
(a) At the...

Page 40NDA-30025   Revision 4.0
APPLICATION MANAGER INSTALLATION APM System Installation Manual
2. Type y and press Enter to indicate that the OAI interface has been installed. The 
OAI interface would be either X.25 or TCP/IP. These interfaces should have 
been installed when the UNIX operating system was loaded.
The following screen appears:
3. Type f and press Enter to continue the installation using floppy disks.
The following screen appears:
4. Do one of the following:
If you need to change the...

NDA-30025   Revision 4.0Page 41
APM System Installation Manual APPLICATION MANAGER INSTALLATION
5. The system displays the current date and the following prompt: “Is this 
information correct? (y/n)”. Do one of the following:
If the system does not display the correct time, type n and press Enter. Type 
the new time in the format [yymmdd]hhmm and press Enter. The system 
displays the new time. If this time is correct, type y and press Enter. If the 
time is incorrect, type n and press Enter and repeat...

Page 42NDA-30025   Revision 4.0
APPLICATION MANAGER INSTALLATION APM System Installation Manual
7. A partition must be allocated to install the OAI system. In most installations the 
partition used is /dev/oai. The partitions are created when the UNIX operating 
system was installed. To use /dev/oai, type /dev/oai and press Enter.
The OAI Filesystem Creation screen appears, as illustrated below:
8. To create a new filesystem, type y and press Enter. The filesystem is where the 
OAI system will load its...

NDA-30025   Revision 4.0Page 43
APM System Installation Manual APPLICATION MANAGER INSTALLATION
If a separate partition was created for the OAI log files, the oailog partition will 
be created. This filesystem will contain the OAI log and debug files.
Next, the installation will update the UNIX operating system files. The OAI 
user will be added to the UNIX password system and groups.
>53 1]UbYSQ 1@= 9^cdQ\\QdY_^ DXe  >_f ! !))&
=Q[Y^W _QY\_W VY\UcicdU] ][Vc TUf_QY\_W ))))( 3ebbU^d Vc^Q]U* ...

Page 44NDA-30025   Revision 4.0
APPLICATION MANAGER INSTALLATION APM System Installation Manual
The APM installation displays a prompt for entry of the first disk of the 
Application Platform Manager, as illustrated below: 
9. Insert the floppy disk into the disk drive and press Enter.
10. At the “Insert Floppy Disk Device APM Release Media 2 of 2” prompt, insert 
the second floppy disk of the Application Platform Manager and press Enter. 
The installation will begin verifying the files that have been...