Mitel Sx 50 Dpabx Instructions Guide

Features Description 
Voice Mail Port - 
Description 
The VX Voice Processing system can be integrated with the SX-50 
Digital PABX through a Control Over Voice (COV) line circuit. Depending 
on the number of lines available on the VX.Voice Server, two, four, six or 
eight lines are connected from the VX Voice Processing system to the 
SX-50 Digital PABX. Each line assigned with a VX Voice Processing 
application is connected to a PABX port. These ports are called Voice 
Mail Ports. 
Refer to Section...

Features 
l Set Executive Busy Override Security (Register 4, field h) to 1 
(Enable). This prevents an override from occurring on the device. 
l Set Last Number Redial Enable (Register 5, field k) to 0 (Disable). This 
ensures that the REDIAL prompt is not displayed on Voice Mail ports. 
l Set SUPERSET Auxiliary Attendant Position (Register 7, field d) to 1 
(Enable). This COS option allows sub-attendant features on the device. 
. Set Directed Call Pickup Security (Register 7, field 
9 to 1 (Enable)....

Features Description 
Commands 361 + 366, Hunt Groups 1 - 6, Extension Hunt Group 
Programming, Register 1: 
l Assign a Hunt Group (1 - 6) to Voice Mail. 
Commands 361 - 366, Hunt Groups 1 - 6, Extension Hunt Group 
Programming, Registers 2 
- 9: 
l Assign the Voice Mail Port extension numbers (fields.b, c, d, e) in 
Registers 2 - 9 to the Voice Mail Hunt Group. 
Command 110, Registers 19 - 24 (where 19 corresponds to the hunt group 
defined in Command 361): . 1,’ 
l Assign required l-, 2-, 3- or 4-digit...

Features 
Wait For Dial Tone 
Description 
This option selects the maximum period of time the system waits to 
receive dial tone from a trunk. Digitsdialed before dial tone is received, or 
before the time-out period specified, are not outpulsed by the system. 
Conditions l Refer to Section 9104-091-220-NA, Automatic Route Selection and 
Toll Control Description. 
l In most cases, the dial tone provided by the Centraf Office can be 
detected by the Dial Tone Detectors within the system. In this case,...

Features Description 
105 3-234 Revision 0 9104-091-105-NA Issue 5  

SX-50@ DIGITAL PRIVATE 
AUTOMATIC BRANCH EXCHANGE. 
(DPABX) 
Ordering 
Information 
TM, 8 -Trademark of Mite1 Corporation. 
@ Copyright 1993, Mite1 Corporation. 
All rights reserved. 
Printed in Canada. 
m MITEL?  

Ordering Information 
NOTICE 
The information contained in this document is believed to be accurate in all 
respects but is not warranted by Mite1 Corporation (MITEL@). The informa- 
tion is subject to change without notice and should not be construed in any 
way as a commitment by Mite1 or any of its affiliates or subsidiaries. Mite1 
and its affiliates and subsidiaries assume no responsibility for any errors or 
omissions in this document. Revisions of this document or new editions of it 
may be issued...

Table of Contents 
1. INTRODUCTION 
General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 150 l-l 
ReasonforReissue . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 150 l-l 
2. ORDERING INFORMATION 
General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 150 2-l 
Warranty . . . . . . . . . ....

Ordering Information 
iv Revision 0 
. 
9104-091-l 50-NA Issue 3  

1 
’ INTndDUCTlON 
General 
1.1 This Practice contains the part numbers of all orderable parts of the SX-508 System 
for provisioning or sparing purposes. 
Reason for Reissue 
I 
1.2 This is the third issue of Practice 9104-091-I 50-NA. Changes to orderable part 
numbers have been incorporated. Changes from Issue 2 are indicated by change 
bars at the left hand side of the page. 
9104-091-150-NA Issue 3 
Revision 0 150 l-l