Home > Mitel > Communications System > Mitel SX 200 ML PABX Instructions Guide

Mitel SX 200 ML PABX Instructions Guide

Here you can view all the pages of manual Mitel SX 200 ML PABX Instructions Guide. The Mitel manuals for Communications System are available online for free. You can easily download all the documents as PDF.

Page 461

Engineering Information 
IMPORTANT SAFETY INSTRUCTIONS 
These instructions are intended to be used as a general guide to provide basic instal- 
lation information which is necessary for the proper and safe functioning of this equip- 
ment. 
WARNING: Failure to follow all instructions may result in improper equipment 
operation and/or the risk of electric shock. 
General 
. 
. 
Read and understand all instructions. Keep these instructions with the equipment. 
Do not attempt to install or service this...

Page 462

Engineering Information 
Installation of Telecommunication Wiring 
Telecommunication wiring to this product shall conform to all applicable safety and 
electrical wiring regulations. Installation of telecommunication wiring shall be per- 
formed by following precautions in accordance with standard industry practice. The 
precautions to be followed include: 
l Never install telephone wiring during a lightning storm. 
l Never install telephone jacks in wet locations unless the jack is specifically de-...

Page 463

Table of Contents 
I. Introduction 
........................................................ ..I- 1 
General 
.............................................................. ..l- 1 
Reasonforlssue 
....................................................... ..l- 1 
Disclaimer 
............................................................ ..l- 1 
2. Features ...................................... 
General ........................................ 
3. System Overview 
............................. 
General...

Page 464

Engineering Information 
LWGSTrunkCarcf ...................................................... ..5-11 
BriefDescription.. ................................................... ..5-11 
Facilities ........................................................... ..5-12 
Electrical Description .................................................. .5-12 
Operation - Loop Start ................................................. .5-12 
Operation - Ground Start ............................................... .5-12...

Page 465

Table of Contents 
Envelope Delay Distortion ................................................. .7-3 
Longitudinal Balance ..................................................... .7-4 
System Impedances .................................................... ..7- 4 
Idle Channel Noise - C Message ............................................ .7-4 
Idle Channel Noise - 3 kHz Flat ............................................. .7-5 
8. Loss and Level Plan ...................................... 
General...

Page 466

Engineering Information 
13. Reserve Power Supply. 
.............................................. .13-l 
14. System Fail Transfer. 
................................................ .14-l 
SFTOperation 
......................................................... ..14- 1 
Figure 4-l 
Figure 5-l 
Figure 5-2 
Figure 5-3 
Figure 5-4 
Figure 5-5 
Figure 5-6 
Figure 8-l 
Figure 8-2 
Figure 8-3 
Figure 8-4 
Figure 12-l 
Table 2-l 
Table 4-l 
Table 5-l 
Table 6-l 
Table 6-2 
Table 7-l 
Table 7-2 
Table 7-3 
Table...

Page 467

Table of Contents 
Table 9-9 Malaysia Digital Bay Ringer Cadencing ............................. 9-5 
Table 10-l Grade Of Service (GOS) ......................................... 10-2 
Table 10-2 HeavyTraffic.. 
................................................ lo- 3 
Table IO-3 Medium Traffic ................................................. 1 O-3 
Table 10-4 Light Traffic ................................................... 1 O-3 
Table 1 l-l System Environmental Operating Conditions...

Page 468

Engineering Information 
. 
X Issue 1 Revision 0 
March 1997  

Page 469

1 Introduction 
General 
1.1 This Practice provides basic engineering information for the SX-200@ ML PABX. It 
describes: 
9 physical aspects of the system 
l onfigurations 
l technical characteristics. 
Reason for Issue 
I .2 This section is issued to provide basic engineering information. 
Disclaimer 
The following products have been manufacture-discontinued by Mitel. These products 
are supported but not described in SX-200 ML Practices: 
. SUPERSET 3TM and SUPERSET 4@ telephone sets 
l SUPERSET 3DNTM...

Page 470

Engineering Information 
l-2 
Issue 1 Revision 0 
March 1997  
Start reading Mitel SX 200 ML PABX Instructions Guide

Related Manuals for Mitel SX 200 ML PABX Instructions Guide

All Mitel manuals