Miele Kfn 14827 Sdeed Operating And Installation Instructions

~This appliance must not be used in
a non-stationary location (e.g. on a
ship).
~In countries where there are areas
which may be subject to infestation by
cockroaches or other vermin, pay
particular attention to keeping the
appliance and its surroundings in a
clean condition at all times. Any
damage which may be caused by
cockroaches or other vermin will not be
covered by the guarantee.
Correct use
~Never handle frozen food with wet
hands. Your hands may freeze to the
frozen food. Danger of frost burn....

~Do not use defrosting sprays or
de-icers, as they might contain
substances which could damage the
plastic parts or which could cause a
build-up of gases and pose a danger to
health.
~Do not use any oils or grease on the
door seals, as these will cause the
seals to deteriorate and become
porous with time.
~If storing food which contains a lot of
fat or oil, make sure that it does not
come into contact with plastic
components as this could cause stress
cracks.
~Do not block the ventilation gaps in
the...

Normal energy
consumptionIncreased energy
consumption
Installation siteIn a ventilated room. In an enclosed, unventilated room.
Protected from direct sunlight. In direct sunlight.
Not near to a heat source (radiator,
oven).Near to a heat source (radiator,
oven).
Where the ideal ambient room
temperature is approx. 20°C.Where there is a high ambient room
temperature.
Do not cover the ventilation gaps
and dust them regularly.
Temperature setting
with a thermostat
which is approximate
(set in stages).With a...

Before using for the first time
Protective foil
On stainless steel appliances, the outer
surfaces are also covered with
protective foil.
^Do not remove the foil until the
appliance has been positioned in its
final location.
Cleaning and care
^On stainless steel appliances also
treat the side panels with the Miele
stainless steel conditioning agent
supplied as soon as you have
removed the protective foil.
The appliance doors have a special
finish which is resistant to soiling.Do
not useMiele stainless...

To enable the temperature to get
sufficiently cold inside the
appliance, allow the appliance to
run for a few hours before placing
food in it.
Do not place food in the freezer
section until the temperature is at
least -18°C.
To switch between the PerfectFresh
zone and freezer section touch the
relevant sensor.
If you want to select the freezer section
(to check the temperature, for
example),
^
touch the freezer sensor. It will light
up yellow.
Depending on which zone/section you
have selected, you can
–...

^Touch the On/Off sensor until the
PerfectFresh symbol goes out.
The interior lighting will not come on
when you open the door and the
PerfectFresh zone is switched off.
The freezer section remains switched
on and the Freezer symbol is lit up.
To switch the PerfectFresh zone
back on again
^Select the PerfectFresh zone. The
PerfectFresh sensor lights up
yellow, then touch the On/Off sensor
until the temperature display lights
up, or
^
Switch the appliance off and then
back on again.
The appliance will...

Settings mode
Certain settings on the appliance can
only be selected in the settings mode.
How to select the settings mode and
how to change the settings is
described in the relevant section of
these instructions.
Overview of functions that can be
selected in the settings mode:
To enter or leave the settings
modec
To switch the sensor tones
on/off
(see Switching on and off)b
To confirm that the active
charcoal filters have been
changed (see Active charcoal
filters)^
To switch the safety lock on/off
(see...

Activating or deactivating the safety
lock
The safety lock can be activated to
prevent the appliance being switched
off inadvertently.
^Touch and leave your finger on the
sensor.
^At the same time, briefly touch the
On/Off sensor (without letting go of
thesensor).
^Leave your finger on thesensor for
another 5 seconds untilcappears in
the display.
^Touch thesensor repeatedly until
uappears in the display.
^
Touch the On/Off sensor.
^
By touching thesensor, you can
now select whether the safety lock...

It is very important to set the correct
temperature for storing food in the
appliance. Micro-organisms will cause
food which is not stored at the correct
temperature to deteriorate rapidly.
Temperature influences the growth rate
of these micro-organisms. Reducing
the temperature reduces their growth
rate.
The temperature in the appliance will
rise:
–the more often the door is opened
and the longer it is kept open,
– the more food that is stored in it,
– the warmer the food is which is being
put into it,...

–Each subsequent touch of a sensor:
changes the setting incrementally.
–Leaving a finger on the sensor:
changes the setting continuously.
Approx. 5 seconds after taking your
finger off a sensor, the current setting of
the PerfectFresh zone is automatically
shown.
The settings,b1tob9have specific
temperature ranges allocated to
them. The temperature itself will not
appear in the display.
b5is the default setting for the
PerfectFresh zone. If a setting ofb1
tob4is selected, the temperature
can fall below...