Miele Kfn 14827 Sdeed Operating And Installation Instructions

^The length of the water intake time for
the ice cube maker can now be
adjusted by touching thesensor:
E1: Shortest water intake time,
E8: Longest water intake time,
E– : Return to menu.
The old setting lights up, and your
newly selected setting flashes.
^Touch the On/Off sensor to confirm
the new setting.
^Touch thesensor repeatedly until
e– appears in the display.
^Touch the On/Off sensor.
^Touch thesensor repeatedly until
cappears in the display.
^Touch the On/Off sensor.
You have now left the...

PerfectFresh zone
Condensate and frost can build up on
the back wall of the PerfectFresh zone
whilst in use. These are automatically
removed and defrosted by the
appliance.
The condensate is drained away via a
channel and drain hole into an
evaporation system at the back of the
appliance.
Ensure that the condensate channel
and drain hole are kept clean and
are never blocked so that
condensate can flow away without
hindrance.
Freezer section
This freezer is equipped with a Frost
free system. The freezer...

Make sure that no water can
penetrate into the electronic unit or
into the light.
Do not let water get into the
drainage channel and drain hole
when cleaning.
Do not use steam cleaning
apparatus to clean the appliance.
Steam could reach the electrical
components and cause a short
circuit.
The data plate located inside the
appliance must not be removed. It
contains information which is required
in the event of a service call.
The stainless steel doors have a
special finish which is resistant to
soiling....

Cleaning the interior and
accessories
^Clean the appliance at least once a
month using lukewarm water and a
little washing-up liquid.
^Clean the interior shelves and
drawers by hand. These arenot
suitable for cleaning in a dishwasher.
^Clean the condensate channel and
drain hole frequently, so that
condensate can drain away
unhindered. Use a straw or similar to
clear the drain hole, if necessary.
^After cleaning, wipe the interior and
accessories with a damp cloth and
dry with a soft cloth.
Leave the...

Cleaning the ice cube tray
Ice cubes freeze in the ice cube tray
and then drop into the ice cube drawer
below.
Clean the ice cube tray regularly with
warm water and a little washing-up
liquid to remove residual ice and water.
The ice cube tray cannot be removed
and must be cleaned in situ.
You should also clean the ice cube
maker before switching off the
appliance for a long time (e.g. when
going on holiday).
^Switch the appliance on.
^
Pull out the ice cube drawer a little
way.
^
Press the On/Off...

If you have used a solution of water
and washing-up liquid to clean it,
discard the ice cubes from the first
three ice cube making processes,
as they are not suitable for
consumption.
Ventilation gaps
^The ventilation gaps should be
cleaned regularly with a brush or
vacuum cleaner. A build-up of dust
will increase the energy consumption
of the appliance.
Door seals
Do not use any oils or grease on the
door seals as these will cause the
seals to deteriorate and become
porous over time.
The door seals...

The active charcoal filters should be
changed approx. every 6 months.
When the Change active charcoal filter
indicator lights up red, the active
charcoal filters need to be changed.
To change the active charcoal
filters
^Pull the active charcoal filter holder
upwards to remove it from the shelf.
^
Take out the two filters and fit the new
filters into the holder with the
protruding cloth edge facing
downwards.
^
Place the holder in the middle of the
raised edge at the back of the shelf,
so that it clicks...

If you have delayed changing the
active charcoal filters and the indicator
is not lit up, you will need to reset the
counter when you replace the active
charcoal filters via the settings mode.
^Touch and leave your finger on the
sensor.
^At the same time, briefly touch the
On/Off sensor (without letting go of
thesensor).
^Leave your finger on thesensor for
another 5 seconds untilcappears in
the display.
^Touch thesensor repeatedly until
^appears in the display.
^
Touch the On/Off sensor.
^
Touch...

Repairs to electrical appliances
should only be carried out by a
suitably qualified and competent
person in strict accordance with
current local and national safety
regulations. Repairs and other work
by unqualified persons could be
dangerous. The manufacturer
cannot be held liable for
unauthorised work.
What to do if...
. . . the PerfectFresh zone or freezer
section does not get cool.
^Check whether the relevant section is
switched on. The temperature display
must be lit up.
^Check that the plug is...

. . . the frozen food is thawing
because the freezer section is too
warm.
Is the room temperature lower than the
ambient temperature for which the
appliance is designed?
^If so, raise the temperature of the
room.
Operating in a room which is too cold
will cause the cooling system to switch
off for too long, causing the freezer
section to become too warm.
. . . food has frozen together.
Use a blunt instrument, e.g. a spoon
handle or plastic scraper, to prise it
apart carefully.
. . . the alarm sounds and...