Home > Lucent Technologies > Communications System > Lucent Technologies DEFINITY Enterprise Communications Server Release 8.2 Administration For Network Connectivity Manual

Lucent Technologies DEFINITY Enterprise Communications Server Release 8.2 Administration For Network Connectivity Manual

Here you can view all the pages of manual Lucent Technologies DEFINITY Enterprise Communications Server Release 8.2 Administration For Network Connectivity Manual. The Lucent Technologies manuals for Communications System are available online for free. You can easily download all the documents as PDF.

Page 51

31Administration for Network Connectivity555-233-504 — Issue 1 — April 2000  CID: 77730
2  H.323 Trunks
This chapter describes how to set up and perform initial administration of IP Trunks between 
DEFINITY ECS switches and between DEFINITY and non-DEFINITY switches that support the 
H.323 V2 signaling protocols. The IP trunk connections described in this chapter use the TN802B 
circuit pack in the MEDPRO mode. See Appendix F for administration of trunk connections that 
use the TN802 or TN802B in the IP...

Page 52

Overview 2  H.323 Trunks
Administration for Network Connectivity
CID: 77730 555-233-504 — Issue 1 — April 2000
32
IP-Connected Trunks
IP-connected trunks allow trunk groups to be defined as ISDN-PRI-equivalent tie 
lines between switches over an IP network.
Trunks using IP connectivity provide cost-reduction and simplified management. 
Benefits include a reduction in long distance voice and fax expenses, facilitation of 
global communications, full-function networks with data and voice convergence, and...

Page 53

H.323 Trunk Administration 
33
Administration for Network Connectivity
555-233-504— Issue 1 — April 2000 CID: 77730
2  H.323 Trunks
H.323 Trunk Administration
This section describes the administration steps needed to setup H.323 trunks. The first subsection covers the 
enabling administration that needs to be in place before the trunk administration can be done. The second 
subsection gives a summary of the H.323 trunk administration and the last subsection gives the detailed steps. 
The screens used for...

Page 54

H.323 Trunk Administration 2  H.323 Trunks
Administration for Network Connectivity
CID: 77730 555-233-504 — Issue 1 — April 2000
34
Maintenance-Related 
System ParametersFour parameters on the Maintenance-Related System Parameters screen set threshold 
values for network performance: 
page 4
•
Roundtrip Propagation Delay (sec)  High: 800_  Low: 400_
•Packet Loss (%)  High: 40__ Low: 15__
•Ping Test Interval (sec): 20 
•Pings per Measurement Interval: 10 
These parameters have no effect unless the bypass...

Page 55

H.323 Trunk Administration 
35
Administration for Network Connectivity
555-233-504— Issue 1 — April 2000 CID: 77730
2  H.323 Trunks
You can also use the Audio IP port number range field to specify a block of port 
numbers to be used for audio connections. Then, if your network is equipped with the 
appropriate data filtering devices, audio data can be segregated from other data traffic 
to improve quality of service.
Open the screen with the change command (ch ip-p) and set the following fields:
•Codec...

Page 56

H.323 Trunk Administration 2  H.323 Trunks
Administration for Network Connectivity
CID: 77730 555-233-504 — Issue 1 — April 2000
36
H.323 Trunk Administration — Task Summary
After the enabling administration is complete, you can administer the H.323 IP trunks. The screens and fields 
that need to be administered are listed below. 
NOTE:  This is only a list of screens and the fields that need to be 
administered. The values that need to be entered in these fields are 
described in the next section.
Node...

Page 57

H.323 Trunk Administration 
37
Administration for Network Connectivity
555-233-504— Issue 1 — April 2000 CID: 77730
2  H.323 Trunks
Signaling GroupEach H.323 trunk must be assigned to a signaling group. Enter values in these fields:
page 1
~
Group Type
~Trunk Group for Channel Selection 
~Near-end Node Name
~Near-end Listen Port 
~Far-end Node Name (Optional)
~Far-end Listen Port (Optional
~LRQ Required?
~Calls Share IP Signaling Connection?
~Bypass If IP Threshold Exceeded?
Page 2 — Administered NCA TSC...

Page 58

H.323 Trunk Administration 2  H.323 Trunks
Administration for Network Connectivity
CID: 77730 555-233-504 — Issue 1 — April 2000
38
IP Media ParametersEach DEFINITY switch in an IP network has one IP Media Parameters screen. Use 
this screen to enter:
~the types of codecs (for audio processing) available on this switch
~the preferred order of use of the codec types
~the range of port numbers available for audio connections
Network RegionsThe Region field on the IP Interfaces screen allows you to set up...

Page 59

H.323 Trunk Administration 
39
Administration for Network Connectivity
555-233-504— Issue 1 — April 2000 CID: 77730
2  H.323 Trunks
Begin
Task 1 Steps
> Open Node Names screen — enter ch node-n
> Go to page 2 of the screen
> Enter values.
> Submit the screen
End
change node-names  Page 2 of 6 
NODE NAMES 
Name  IP Address  Name  IP Address
clan-a1
______ 192.168.10_.31_ ___________ ___.___.___.___
clan-a2
______ 192.168.20_.31_ ___________ ___.___.___.___
default 0 .0 .0 .0  ___________ ___.___.___.___...

Page 60

H.323 Trunk Administration 2  H.323 Trunks
Administration for Network Connectivity
CID: 77730 555-233-504 — Issue 1 — April 2000
40
Task 2 — Define IP Interfaces
The IP interface for each C-LAN and MedPro board on the switch must be defined on 
the IP Interfaces form. Each DEFINITY switch in an IP network has one IP Interfaces 
form.
Begin
Task 2 Steps
> Open IP Interfaces form — enter  ch ip-i
> Enter values
change ip-interfaces  Page   1 of   2 
IP Interfaces
Inter-region IP connectivity allowed?  n...
Start reading Lucent Technologies DEFINITY Enterprise Communications Server Release 8.2 Administration For Network Connectivity Manual

Related Manuals for Lucent Technologies DEFINITY Enterprise Communications Server Release 8.2 Administration For Network Connectivity Manual

All Lucent Technologies manuals