Lucent Technologies DEFINITY Enterprise Communication Server Release 8.2 Installation And Test For Multi-Carrier Cabinets Manual

DEFINITY ECS Release 8.2 Installation and Test
for Multi-Carrier Cabinets  555-233-114  Issue 1
April 2000
Option Switch Settings 
B-7 Call Detail Recording Option Settings 
B
Call Detail Recording Option Settings
The interfac e between the system and  CDR eq uip ment may b e 1 of the following :
nData Module — rec ommend ed  op tion setting s are shown in Ta b l e  B - 3.
nMod em — rec ommend ed op tion setting s are in mod em vend or d oc ument
nTN726 Data Line c irc uit p ac k and  an Async hronous...

DEFINITY ECS Release 8.2 Installation and Test
for Multi-Carrier Cabinets  555-233-114  Issue 1
April 2000
Option Switch Settings 
B-8 Call Detail Recording Option Settings 
B
Ad ministration p roc ed ures for CDR eq uip ment are p rovid ed  in DEFINITY 
Enterp rise Communic ations Server Release 8 Ad ministrator’s Guid e.
Table B-4. 572 Printer Used with Management Terminal, CDR,
or Journal Printer
Function Function Name Menu  Menu Status
01 FORM LENGTH 09 11
02 LPI 01 6
03 CPI 01 10
04 LQ or NLQ 01 LQ...

DEFINITY ECS Release 8.2 Installation and Test
for Multi-Carrier Cabinets  555-233-114  Issue 1
April 2000
Option Switch Settings 
B-9 TN760D Tie Trunk Option Settings 
B
TN760D Tie Trunk Option Settings
The TN760D Tie Trunk c irc uit p ac k interfac es b etween four tie trunks and  the 
TDM b us. Two tip  and  ring p airs form a 4-wire analog transmission line. An E and  
M p air are DC sig naling  lead s used  for c all setup . The E-lead  rec eives signals 
from the tie trunk and  the M-lead...

DEFINITY ECS Release 8.2 Installation and Test
for Multi-Carrier Cabinets  555-233-114  Issue 1
April 2000
Option Switch Settings 
B-10 TN760D Tie Trunk Option Settings 
B
Figure B-2. TN760D Tie Trunk Circuit Pack (Component Side)
Table B-6. Signaling Type Summary
Signaling Type Transmit (M-Lead) Receive (E-Lead)
On-Hook Off-Hook On-Hook Off-Hook
Type I Standard ground battery open
1/battery
1. An op en c irc uit is p referred  instead  of b attery voltag e.
ground
Type I Compatible open
1/b attery g...

DEFINITY ECS Release 8.2 Installation and Test
for Multi-Carrier Cabinets  555-233-114  Issue 1
April 2000
Option Switch Settings 
B-11 TN464E/F Option Settings 
B
TN464E/F Option Settings 
The TN464E/F DS1/E1 Interfac e - T1/E1 c irc uit p ac k interfac es b etween a 24 or 
32 c hannel Central Offic e/ISDN or tie trunk and  the TDM b us. 
Set the switc hes on the c irc uit p ac k to selec t b it rate and imp edanc e matc h. See 
Ta b l e  B - 8
 and  Fig ure B -3.
Table B-7. TN760D Option Switch...

DEFINITY ECS Release 8.2 Installation and Test
for Multi-Carrier Cabinets  555-233-114  Issue 1
April 2000
Option Switch Settings 
B-12 TN464E/F Option Settings 
B
Figure B-3. TN464E/F Option Settings Figure Notes
1. Bac kp lane Connec tors
2. 24/32 Channel Selec tor
3. 75/120 Ohm Selec tor
4. Fac ep late
5. 32 Channel6. 120 Ohm (shown selec ted )
7. 24 Channel (shown selec ted )
8. 75 Ohm
9. Connec tor
10. TN464E/F DS1/E1 Interfac e Circ uit Pac k
3
8
4
9
5
10
1
6
2
7 

Cable Ductwork 
C-1  
C
DEFINITY ECS Release 8.2 Installation and Test
for Multi-Carrier Cabinets  555-233-114  Issue 1
April 2000
C
Cable Ductwork
The c ab le d uc twork is assembled  from various g roup  numb ers from ED-1E465 
(fac ia p aneling  to c over the I/O d uc ts is assemb led  from ED-1E464). The 
assemb ly, installed  after the c ab inets have b een installed , p rovid es d uc ts for 
three typ es of c ab les: interc ab inet c ab les, I/O c ables (tip  and  ring ), and  AC 
power cables. DC...

DEFINITY ECS Release 8.2 Installation and Test
for Multi-Carrier Cabinets  555-233-114  Issue 1
April 2000
Cable Ductwork 
C-2  
C
Eq uip ment room layout and  exp ec ted  g rowth d etermines whic h method to use. 
Installation of an overhead  rac k is c overed  b y Cab le Rac ks (800-614-157).
NOTE:
Install all sc rews in all ap p rop riate p lac es to c omply with elec tromag netic  
interferenc e (EMI) req uirements for shield ing .
Figure C-1. Typical Layout of Assembled Ductwork
Installation
This d...

DEFINITY ECS Release 8.2 Installation and Test
for Multi-Carrier Cabinets  555-233-114  Issue 1
April 2000
Cable Ductwork 
C-3  
C
Inventory the materials rec eived and  mark a c opy of the floor p lan with the 
loc ation of eac h g roup  numb er to b e installed . Hard ware used  to assemb le eac h 
item is pac kag ed  with the ind ivid ual g roup s.
Ta b l e  C - 1
 shows the availab le g roup numb ers and  a brief d esc rip tion of eac h 
g roup. Some d uc ts are equip p ed  with c overs whic h should...

DEFINITY ECS Release 8.2 Installation and Test
for Multi-Carrier Cabinets  555-233-114  Issue 1
April 2000
Cable Ductwork 
C-4  
C
Install the various c able d uc ts in the order shown in Ta b l e  C - 2. Fi g u re  C - 2 shows 
an overhead  view of a typ ic al d uc twork installation. 
!WA R N I N G :
To prevent d amag e to the c ab inet c irc uitry or c ab les, plac e c ard b oard or 
eq uivalent in the c ab le d uc ts to c atc h any metal filing s that may fall from the 
self-threading sc rews.
31...