Land Rover Range Rover Classic Workshop 1995 Rover Manual

MAINTENANCE
7
MAINTENANCE
CLEAN ENGINE BREATHER FILTER - V8
1.Release hose clamp and pull hose off canister.
2.Unscrew canister and remove it from rocker
cover.
3.Remove large O ring from threaded end of
canister.
4.Visually inspect condition of wire screen within
canister, if in poor condition fit new assembly, if
in acceptable condition clean screen as follows:
5.Immerse canister in small amount of solvent and
allow solvent to dissolve and loosen any debris.
6.Remove canister from solvent and dry in...

10MAINTENANCE
8
MAINTENANCE 6.Use a compressed air line with a slim bent
nozzle to enable passageway to be cleaned out
from within throttle butterfly bore.
7.Any remaining matter can be dislodged using
soft bent wire or pipe cleaner. Finally blow out
passageway again to remove remaining debris.
8.Remove small T piece between crankcase
ventilation hoses and check it is free from
blockages, clean as necessary.
9.Refit T piece and hoses, tighten hose clamps
securely.
RENEW CHARCOAL CANISTER - V8
Charcoal...

MAINTENANCE
9
MAINTENANCE
CHECK THROTTLE AND AUTOMATIC
TRANSMISSION CABLE OPERATION
CHECK/TOP UP AUTOMATIC TRANSMISSION
FLUID LEVEL
NOTE: Transmission fluid level is checked
when fluid is cold with engine idling in
neutral.
1.Ensure vehicle is on level ground.
2.Check fluid level registers between MAX and
MIN marking on dipstick.
CHECK SECURITY OF JACK, BRACE AND
CHOCKS
CHECK ENGINE EMISSION CONTROL SYSTEM V8
CHECK OPERATION OF ELECTRONIC CONTROL
UNIT/SYSTEMS - V8CHECK/TOP UP COOLING SYSTEM
1.To prevent...

10MAINTENANCE
10
MAINTENANCE
CHECK/TOP UP POWER STEERING FLUID
RESERVOIR
1.Remove fluid reservoir cap. Check that fluid is
up to high mark on dipstick.
CHECK/ TOP UP CLUTCH AND BRAKE FLUID
RESERVOIRS
CAUTION: Brake fluid can damage
paintwork. If spillage occurs, wash
affected area IMMEDIATELY with a large
quantity of water.
CHECK/TOP UP WASHER RESERVOIR
Top up washer reservoir to within 25 mm of filler neck.
Use a screen washer solvent/anti-freeze solution to
assist removing mud, flies and road film and...

MAINTENANCE
11
MAINTENANCE
CHECK/ADJUST ENGINE IDLE SPEED - Tdi
For idle speed.See ENGINE TUNING DATA,
Information, Engine - 300Tdi
CHECK/ADJUST STEERING BOX
Check steering box for fluid leaks.
Check that there is no backlash in steering box in
straight ahead position. Adjust steering box if
necessary.
See STEERING, Adjustment, Power
Steering Box
CLEAN BATTERY CONNECTIONS
Remove battery terminals, clean and coat with
petroleum jelly.
A low maintenance battery is installed in vehicle.
Dependent upon...

10MAINTENANCE
12
MAINTENANCE
EXTERNALLY CHECK INTERCOOLER FOR
OBSTRUCTION - Tdi
Clear any trapped dirt or flies from veins of intercooler
CLEAN INTERCOOLER ELEMENT - Tdi
Remove
1.Remove intercooler element.
2.Flush intercooler with ICI GENKLENE or
D-SOLVE propriety cleaner, following the
manufacturers instructions.
3.Dry the intercooler completely ensuring that no
liquid remains in the element.
Refit
4.Refit intercooler element.
CHECK TURBO CHARGER BOOST PRESSURE -
Tdi
For boost pressure.See ENGINE...

MAINTENANCE
13
MAINTENANCE UNDER VEHICLE MAINTENANCE
Vehicles operating under severe conditions of dust,
sand, mud and water should have oils changed and
lubrication carried out at more frequent intervals than
is recommended in maintenance schedules.
RENEW ENGINE OIL AND FILTER - Tdi
CAUTION: Serious damage to the
turbocharger will result is engine is run
above idling speed before oil pressure is
restored.
RENEW ENGINE OIL AND FILTER - V8
CAUTION: To prevent an airlock occuring
after removing filter,...

10MAINTENANCE
14
MAINTENANCE 6.Reconnect battery negative lead. Start and run
engine, apply footbrake, select Position 1, revert
to park position, release footbrake. Check fluid
level, this must be between two markings on
dipstick.
Oil screen replacement ZF automatic gearbox.
See AUTOMATIC GEARBOX, Repair, Oil screenRENEW TRANSFER GEARBOX OIL
1.Before renewing oil ensure that vehicle is level,
either on a ramp or on ground.
2.Disconnect battery negative lead.
3.Clean immediate area around filler/level...

MAINTENANCE
15
MAINTENANCE
CHECK/TOP UP TRANSFER GEARBOX OIL
1.Before topping up oil ensure that vehicle is level,
either on a ramp or on ground.
2.Disconnect battery negative lead.
3.Clean immediate area around filler/level plug.
4.Remove plug and fill gearbox with recommended
grade of oil, until oil starts to seep from filler/level
hole.
5.Clean any previously applied sealant from
filler/level plug.
6.Apply Hylomar sealant to threads of plug and
refit plug. Tighten to
25 Nm.
7.Wipe away any surplus...

10MAINTENANCE
16
MAINTENANCE
RENEW SWIVEL PIN HOUSING OIL
1.Vehicle must be level. Place container under
swivel to be drained.
2.Remove drain and level plugs, allow oil to drain
completely, clean and refit drain plug.
3.Remove filler plug and inject recommended
make and grade of oil it reaches level hole.
4.Clean and refit level and filler plugs, wipe away
any surplus oil.
LUBRICATE PROPELLER SHAFT SLIDING, AND
UNIVERSAL JOINTS
1.Clean all grease nipples on front and rear
propeller shafts.
2.Using a low...