Land Rover Defender Accessory Fitting Rover Manual

STC 50255DEFENDER
6 6/
/8
8
15
12
x2
M16x40
14
16
x1
13
Ø13mmX2
M12x70
x2
810
11
x2
9
M16x40
x2
M16x40
M10x25
x1
x2
7STC 50255DEFENDER
5 5/
/8
8
5
6
M10x25
x2
x1
? 

2925244Nm
244Nm
244Nm
40-50Nm
2830
STC 50255DEFENDER
8 8/
/8
8
24
x2
M10x45
26
56Nm
244Nm
75Nm
27
56Nm
75Nm
244Nm
x2
M10x45
STC 50255DEFENDER
7 7/
/8
8
23
2220
19
18
x1
M16x40
17
x1
M12
M12
x1
M12x70
21
x1
M16x40 

DEFENDER
WARNING
Accessories which are not properly fitted can be dangerous. Read the
instructions carefully prior to fitting. Whilst fitting, comply with the
instructions at all times.  If in doubt, contact your nearest Land Rover
Dealer.
ACHTUNG!
Nicht sachgemäß montiertes Zubehör kann gefährlich sein.  Lesen Sie die
Montageanleitung sorgfältig, bevor Sie das Teil montieren. Halten Sie sich
bei der Montage an die Anleitung. Bei Unsicherheiten wenden Sie sich
bitte an Ihren Land Rover Händler....

STC 7764 AUDIO SYSTEM DEFENDER
3
LAND ROVER ACCESSORIES
2
LAND ROVER ACCESSORIES
STC 7764 AUDIO SYSTEM DEFENDER
X2
X2X2
Ø 13mm
Ø 100mm
13mm
IMPORTANT INFORMATIONThis installation manual is divided into 7 language sections.  
ENGLISH ..............................................................................................................................Page 4IMPORTANT INFORMATIONCe manuel dinstallation est divisé en 7 sections de langues différentes...

STC 7764 AUDIO SYSTEM DEFENDER
5
LAND ROVER ACCESSORIES
DOOR SPEAKERS - Both sides15 Remove door check strap cover - 1 screw.
16 Measure and mark A post as shown and drill a
ø3mm pilot hole.
17 Measure and mark lower the A post cover as
shown and drill a ø3mm pilot hole through the
lower A post cover, insulation and into the A
post.
18 Drill out top hole on the A post to ø13mm.
19 Drill out the bottom the hole to ø16mm
20 Remove swarf, de-bur and paint exposed
metal with LR touch-up paint.
21 Remove 3...

STC 7764 AUDIO SYSTEM DEFENDER
7
LAND ROVER ACCESSORIES
DASH SPEAKERS 
Passenger side12 Position speaker  spacer on the wiper motor
cover so the narrowest part of the taper is
uppermost and central.
13 Mark the fixing holes and speaker aperture.
14 Remove speaker spacer and drill 4 screw
holes ø 2mm
15 For the speaker aperture use ø100mm  hole
cutter.
16 Remove swarf, de-bur and paint exposed
metal work with LR touch-up paint.DASH SPEAKERS
Drivers side17 Position the speaker spacer centrally on the
lower...

`STC 7764/65- AUDIO STSTEM DEFENDER
9
LAND ROVER ACCESSORIES
POWER HARNESS1 Position the 8 way Power Harness connector
(supplied in kit) above the centre instrument
panel.
2 Locate orange/white wire with bullet connec-
tor on the Power Harness and connect the to
the orange/white wire (ignition feed) taped
back to the main vehicle harness at the centre
of the dash.
3 Locate the red wire (permanent feed) and
black wire (earth) on the Power Harness and
route through lower dash to the fuse box area.
4...

10
LAND ROVER ACCESSORIES
STC 7764 AUDIO SYSTEM DEFENDER
15 Cut an access hole in the centre instrument
cowel as shown.
16 Refit cowel to the dash with existing fixings.
and route the two 8 way connectors and aerial
through the aperture.
17 Fit the radio cage to the housing (supplied in
kit) and bend the tabs on each side to secure.
18 Reposition the radio housing and route the
two 8 way connectors and aerial through the
apertute.
19 Insert radio mounting bung (supplied in kit)
to the rear of the radio...

SYSTEME AUTORADIO-STEREO STC 7764 DEFENDER
13
ACCESSOIRES LAND ROVER
HAUT-PARLEURS DE PORTE - Les deux côtés15 Retirer le couvercle de la bride de retenue de porte
(1 vis).
16 Mesurer et marquer le montant A comme indiqué
sur le schéma, puis percer un trou pilote à un ø de
3mm.
17 Mesurer et marquer le recouvrement  du montant
A inférieur comme indiqué sur le schéma, puis
percer un trou pilote à un ø de 3mm dans le recou-
vrement du montant A inférieur, l’isolation et dans
le montant A.
18 Percer le trou...