Land Rover Defender 1999 2002my Workshop Supplement Body Repair 3rd Edition Rover Manual

84WIPERS AND WASHERS
2
REPAIR
4.Remove 4 trim studs securing upper rear finisher
to body.
5.Release and remove upper rear finisher.
6.Position drain tin to collect any fluid spillage.
7.Disconnect washer tube from jet.
8.Remove nut securing washer jet to body.
9.Remove washer jet.
Refit
10.Fit washer jet to body and secure with nut.
11.Connect washer tube to jet.
12.Remove drain tin.
13.Fit upper rear finisher and secure with trim studs.
14.Fit both rear grab handles and secure with
screws.
15.Fit both...

WIPERS AND WASHERS
3
REPAIR WIPER MOTOR AND DRIVE RACK - FROM 02MY
Service repair no - 84.15.09
Remove
1.Disconnect battery negative lead.See
ELECTRICAL, Repair.
2.Remove wiper arms.See this Section.
3.Remove fascia console.See CHASSIS AND
BODY, Repair.
4.Remove air vent control knobs.
5.Remove 6 screws, remove fascia closing panel
and collect nut plate.
6.Move cover aside and loosen wiper motor drive
tube nut.
7.Remove 2 screws securing wiper motor, remove
retaining strap and mounting pad.
8.Disconnect...

84WIPERS AND WASHERS
4
REPAIR 15.Fit nut plate and fit screws to secure nut plate
and closing panel.
16.Fit knobs to air vent control levers.
17.Fit fascia console.See CHASSIS AND BODY,
Repair.
18.Fit wiper arms.See this Section.
19.Connect battery negative lead.See
ELECTRICAL, Repair.WHEELBOX/DRIVE PIVOT - FROM 02MY
Service repair no - 84.15.25
Remove
1.Disconnect battery negative lead.See
ELECTRICAL, Repair.
2.Remove steering column nacelle.See
STEERING, Repair.
3.Remove wiper motor and drive rack.See...

WIPERS AND WASHERS
5
REPAIR
9.Remove cable ties securing washer tube to
windscreen wiper rack tube.
10.Loosen fully 4 nuts securing backplates to wheel
boxes and remove windscreen wiper rack tubes.
11.Remove seals from wheel box spindles.
12.Remove 2 nuts securing wheel boxes and
remove sealing washers.
13.Carefully pull fascia support rail from bulkhead
sufficiently to remove wheel boxes.
Refit
14.Loosen fully but do not remove nuts securing
wheel box back plates.
15.Grease wheel boxes.
16.Fit wheel...

84WIPERS AND WASHERS
6
REPAIR
6.Identify and remove relay.
Refit
7.Fit relay.
8.Position instrument pack and connect multiplugs.
9.Fit instrument pack to fascia and secure with
screws.
10.Connect battery negative lead.See
ELECTRICAL, Repair.MOTOR - WIPER - TAIL DOOR - FROM 02MY
Service repair no - 84.35.12
Remove
1.Remove spare wheel from tail door.
2.Raise nut cover, remove nut and release wiper
arm.
3.Remove nut and collect washer securing wiper
motor to tail door.
4.Open tail door.
5.Remove tail door...

WIPERS AND WASHERS
7
REPAIR
NOTE: Do not carry out further
dismantling if component is removed for
access only.
10.Remove 2 bolts securing wiper motor to
mounting bracket, remove bracket.
Refit
11.Fit mounting bracket to motor and tighten bolts
to10 Nm (7 lbf.ft).
12.Fit motor spindle to rear door, connect multiplugs
and push motor fully home. Align motor
mounting bracket with solenoid mounting
bracket, fit bolt and tighten to10 Nm ( 7 lbf.ft ).
13.Fit rear door trim casing.See CHASSIS AND
BODY, Repair....

84WIPERS AND WASHERS
8
REPAIR 

86 - ELECTRICAL
CONTENTS
Page
DESCRIPTION AND OPERATION
SECURITY AND CENTRAL DOOR LOCKING 1....................................................
SECURITY AND CENTRAL DOOR LOCKING 2....................................................
ANTI-THEFT ALARM - FROM 02MY 3...................................................................
IMMOBILISATION SYSTEM - FROM 02MY 12......................................................
CENTRAL DOOR LOCKING (CDL) - FROM 02MY 15..............................................

86 - ELECTRICAL
CONTENTS
Page
LAMP ASSEMBLY - CENTRE HIGH MOUNTED STOP LIGHT (CHMSL) -
FROM 02MY 16......................................................................................................
FLASHER UNIT - HAZARD WARNING - FROM 02MY 16.....................................
RELAY - HEATED FRONT SCREEN - FROM 02MY 17........................................
RELAY - REAR FOG GUARD - FROM 02MY 18...................................................
RELAY - STARTER - FROM 02MY...

ELECTRICAL
1
DESCRIPTION AND OPERATION SECURITY AND CENTRAL DOOR LOCKING
SYSTEM - FROM 02MY
The following description details the functionality and operation of the 10AS Security and Central Door Locking
(CDL) System fitted to 2002MY Defender. The system contains some new features and also retains some
features from previous Defender models. The alarm system and CDL system are controlled by the 10AS anti-theft
alarm ECU.
New door lock barrels are introduced and use the same key as the ignition switch...