Land Rover Body And Paint Air Bag And Safety Belt Rover Manual

The A/C compressor circulates the refrigerant around
the system by compressing low pressure, low
temperature vapor from the evaporator and discharging
the resultant high pressure, high temperature vapor to
the condenser. The A/C compressors for the different
engine types differ due to their individual installation
requirements, but are otherwise the same.
The A/C compressor is a permanently engaged, variable
displacement unit which is driven by the engine
accessory drive belt. To protect the refrigerant...

The condenser is classified as a sub-cooling condenser
and consists of a fin and tube heat exchanger core
installed between two end tanks. Divisions in the end
tanks separate the heat exchanger into a four pass upper
(condenser) section and a two pass lower (sub-cooler)
section. A connector block on the left end tank of the
condenser provides connections for the high pressure
lines from the A/C compressor and the evaporator. Two
pipes at the bottom of the right end tank of the condenser
provide...

ports of the receiver drier are the same size, so care must
be taken to install the receiver drier the correct way
round on the stub pipes; to assist with installation, the
inlet port is identified with the word IN etched into the
receiver drier.
Refrigerant entering the receiver drier passes through a
filter and a desiccant pack, then collects in the base of
the unit before flowing through the outlet stub pipe back
to the condenser. The desiccant and the filter are
non-serviceable; the complete unit...

The evaporator is installed in the heater assembly
between the blower and the heater matrix, to absorb
heat from the exterior or recirculated air. Low pressure,
low temperature refrigerant changes from liquid to vapor
in the evaporator, absorbing large quantities of heat as
it changes state.
Most of the moisture in the air passing through the
evaporator condenses into water, which drains out of
the heater and through the floorpan, to the underside of
the vehicle, through two drain tubes.
REFRIGERANT...

A/C SYSTEM SCHEMATIC
NOTE: A = Refrigerant liquid; B = Refrigerant vapor; C = Air flow
Evaporator1
Thermostatic expansion valve2
High pressure connection with auxiliary climate
control (where fitted)
3
High pressure servicing connection4
Refrigerant pressure sensor5
Cooling fan6
Condenser7
Receiver drier8
A/C compressor9
Low pressure servicing connection10
Air ConditioningLesson 2 – Electrical
19Technical Training (G421234) 

Low pressure connection with auxiliary climate
control (where fitted)
11Blower12
(G421234) Technical Training20
Lesson 2 – ElectricalAir Conditioning 

Lesson 2 – Electrical
1. c
2. Make sure unit is correctly orientated, i.e in to in.
3. b
4. Improved thermal comfort. High reliability.; Low
fuel consumption.; Light weight.; Improved
driveability.; Engine torque management.;
5. e
6. c
7. b
8. It is cooled by the Peltier Effect. This occurs when a
direct current is passed through a circuit of two
dissimilar conductors, which are connected together at
two junctions; this causes one junction to become cold
and one junction to become hot.
9. An in-vehicle...

Antenna Amplifier Component Location
FM Antenna1
Suppressor2
TV antenna amplifier3
FM diversity antenna amplifier4
TV antenna amplifier5
FM antenna amplifier6
GPS antenna7
Rear screen mounted antennas8
Telephone and SDARS antennas9
VICS/ TMC antenna amplifier10
TV antenna amplifier11
Suppressor12
VICS antenna amplifier13
Side screen television antennas14
(G421266) Technical Training142
Lesson 2 – ElectricalAntenna 

TV antenna amplifier15
Screen Antenna Layout
NOTE: A=Hardwired
TV antenna amplifier1
LH Side screen antennas2
RH Side screen antennas3
TV antenna amplifier4
TV tuner module5
Integrated Head Unit (IHU)6
AM/FM diversity antenna amplifier7
TV antenna amplifier8
TV tune module9
FM Diversity tuning amplifier10
Rear screen antennas11
VICS/TMC tuner12
VICS/TMC antenna amplifier13
TV antenna amplifier14
VICS antenna amplifier15
VICS tuner16
The antenna systems fitted to the vehicle comprise:
•AM (glass mounted)...

•SDARS (roof mounted NAS only)
•VICS antenna and beacon antenna (Japan only where
fitted)
FM ANTENNAS
FM Antenna Amplifier
The AM/FM antennas are located in the side and rear
widow. ON vehicles with the low line audio system the
AM/FM antenna is located in the RH rear side screen.
On vehicles with a high line audio systems the system
will be equipped with FM diversity tuning. This system
ensures that the strongest of two signals is used by the
radio system to ensure the best possible FM reception.
The...