Konica Minolta magicolor 4690MF User Manual

Scanning With the Machine 149
2Press the + or , key to select the job to be deleted, and then press the 
Select key.
To check the information for the selected job, press the ) key.
If no jobs are queued for transmission, NONE appears.
3Press the + or , key to select YES, and then press the Select key.
The main screen appears again.
Downloaded From ManualsPrinter.com Manuals 

Scanning With the Machine 150
Downloaded From ManualsPrinter.com Manuals 

7Replacing
Consumables
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables 152
Replacing Consumables
Note
Failure to follow instructions as outlined in this manual could result in 
voiding your warranty.
Note
If an error message (Toner Empty, Trans.Belt Life, etc.) appears, 
print out the configuration page, and then check the status of the other 
consumables. For details on the error messages, refer to “Error Messages” 
on page 243. For details on printing the configuration page, refer to 
“Printing a Configuration Page” on page 201.
About Toner...

Replacing Consumables 153
Note
Do not use refilled toner cartridges or unapproved toner cartridges. Any 
damage to the machine or quality problems caused by a refilled toner 
cartridge or an unapproved toner cartridge will void your warranty. No 
technical support is provided to recover from these problems.
When replacing a toner cartridge, refer to the following table. For optimum 
print quality and performance, use only approved KONICA MINOLTA toner 
cartridges for your specific machine type, as listed...

Replacing Consumables 154
For optimum print quality and performance, use only the corre-
sponded TYPE genuine KONICA MINOLTA toner cartridges.
Keep toner cartridges: 
„In their packaging until you’re ready to install them.
„In a cool, dry location away from sunlight (due to heat). 
„The maximum storage temperature is 35°C (95°F) and the maximum stor-
age humidity is 85% (noncondensing). If the toner cartridge is moved from 
a cold place to a warm, humid place, condensation may occur, degrading 
print...

Replacing Consumables 155 Replacing a Toner Cartridge
Note
Be careful not to spill toner while replacing a toner cartridge. If toner 
spills, immediately wipe it off with a soft, dry cloth.
If 
MACHINE SETTING/TONER EMPTY in the UTILITY menu is set to 
STOP, the message TONER EMPTY/CHANGE X TONER (where “X” indi-
cates the color of the toner) appears when the toner cartridge is nearly empty. 
Follow the steps below to replace the toner cartridge.
1Open the machine’s front cover.
2Pull the front lever of...

Replacing Consumables 156
3Lower the lever to release the 
lock.
4Grab the handle of the toner car-
tridge to be replaced, and then 
pull out the cartridge. 
The following instructions show 
the procedure to replace the 
toner cartridge(Y).
Note
Dispose of the used toner cartridge according to your local regulations. 
Do not burn the toner cartridge.
For details, refer to “About Toner Cartridges” on page 152.
5Check the color of the new toner cartridge to be installed.
6Remove the toner cartridge from...

Replacing Consumables 157
7Shake the cartridge to distribute 
the toner.
8Make sure that the toner car-
tridge is the same color as the 
machine compartment, and then 
insert the toner cartridge into the 
machine.
9Make sure that the toner car-
tridge is securely installed, and 
then peel off the protective film.
Y
3 ×
YY
Y
Y
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables 158
10Raise the front lever to its origi-
nal position.
11Pull the lever to the left to lock it 
in place.
The front lever should be 
securely returned to its 
original position; other-
wise, the front cover of 
the machine cannot be 
closed.
12Close the front cover.
Y
Y
Y
Downloaded From ManualsPrinter.com Manuals