IBM Thinkpad Transnote Manual

							(continued)
Removing and replacing a FRU
ThinkPad TransNote11 7 
						

							Step Screw (quantity) Torque

5M2.5×4.0 mm, nylon-coated (1) 39.2 Ncm
(4 kgfcm) Removing and replacing a FRU
11 8ThinkPad TransNote 
						

							When installing, do as follows:
1. Attach the connector on the bottom side of the inverter
card to the LCD cable connector (
1).
(continued)
Removing and replacing a FRU
ThinkPad TransNote11 9 
						

							2. Attach the LCD cable connector to the connector on
the bottom side of the LCD panel (
2), and then lay
the LCD panel on the rear cover (
3).
3. Align the upper left corner of the LCD panel with the
upper left corner of the rear cover (
4).
(continued)
Removing and replacing a FRU
120ThinkPad TransNote 
						

							4. Lift the side of the inverter card (
5) a little and plug
the cable into the connector on the bottom side of the
inverter card (
6). Make sure that the other connector,
which was connected in the installing procedure
1,is
not disconnected when you lift the inverter card.
When routing the cable, do as following figure.
Removing and replacing a FRU
ThinkPad TransNote121 
						

							5. Tighten the screws
7and
8.
Removing and replacing a FRU
122ThinkPad TransNote 
						

							2040 LCD cable
vBattery pack(1010)
vMini PCI adapter(1030)
vHard-disk drive and hard-disk drive cover(1050)
vDigital-pen holder kit(1080)
vComputer side(1090)
vVideo card(1130)
vLCD assembly(2010)
vLCD front bezel(2020)
vLCD panel and Inverter card(2030)
Removing and replacing a FRU
ThinkPad TransNote123 
						

							3010 Digital pen
4010 Changing the orientation of a left-
or right-handed model
This section contains the procedure for converting a
right-handed model to a left-handed model, or vice versa,
by replacing the Endurimer or leather cover.
To replace the Endurimer or leather cover, do the following;
1. Keep the required replacing kit.
(For the content of the kit and the P/Ns, see
“Endurimer/leather cover replacing kit”on page 140.)
2. Remove the digital-pen holder kit.
(See“1070 Digital-pen holder kit”on page 75.)
3. Remove the computer side.
(See“1080 Computer side”on page 79.)
4. Remove the ThinkScribe digital notepad.
(See“1090 ThinkScribe digital notepad assembly”on
page 82.)
(continued)
Removing and replacing a FRU
124ThinkPad TransNote 
						

							5. Paste new velcro tapes
1on the bottom side of the
computer side and remove the old tapes
2as
shown in the following figures.
Right-handed model to left-handed model
Left-handed model to right-handed model
(continued)
Removing and replacing a FRU
ThinkPad TransNote125 
						

							6. Paste new base plate tape
1on the bottom side of
the computer side, and then remove the other one
2.
Right-handed model to left-handed model
Left-handed model to right-handed model
(continued)
Removing and replacing a FRU
126ThinkPad TransNote