HP Officejet J6413 User Manual

Other equipment/services
sharing your fax lineRecommended fax setup
for parallel-type phone
systemsRecommended fax setup
for serial-type phone
systems
Voice calls, computer dial-up
modem, and voice mail service
(You answered Yes to
questions 4, 5, and 7 only.)Case K: Shared voice/fax linewith computer dial-up modemand voice mail
Not applicable.
Case A: Separate fax line (no voice calls received)
If you have a separate phone line on which you receive no voice calls, and you have
no other equipment...

Case B: Set up the device with DSL
If you have a DSL service through your telephone company, and do not connect any
equipment to the device, use the instructions in this section to connect a DSL filter
between the telephone wall jack and the device. The DSL filter removes the digital
signal that can interfere with the device, so the device can communicate properly with
the phone line. (DSL might be called ADSL in your country/region.)
NOTE:If you have a DSL line and you do not connect the DSL filter, you...

Case C: Set up the device with a PBX phone system or an ISDN line
If you are using either a PBX phone system or an ISDN converter/terminal adapter,
make sure you do the following:
• If you are using either a PBX or an ISDN converter/terminal adaptor, connect the
device to the port that is designated for fax and phone use. Also, make sure that
the terminal adapter is set to the correct switch type for your country/region, if
possible.
NOTE:Some ISDN systems allow you to configure the ports for specific...

1Telephone wall jack
2Use the phone cord supplied in the box with the device to connect to
the 1-LINE port
To set up the device with a distinctive ring service
1.Using the phone cord supplied in the box with the device, connect one end to your
telephone wall jack, then connect the other end to the port labeled 1-LINE on the
back of the device.
NOTE:If you do not use the supplied cord to connect from the telephone wall
jack to the device, you might not be able to fax successfully. This special
phone cord...

1Telephone wall jack
2Use the phone cord supplied in the box with the device to connect to
the 1-LINE port
3Telephone (optional)
To set up the device with a shared voice/fax line
1.Using the phone cord supplied in the box with the device, connect one end to your
telephone wall jack, then connect the other end to the port labeled 1-LINE on the
back of the device.
NOTE:If you do not use the supplied cord to connect from the telephone wall
jack to the device, you might not be able to fax successfully. This...

Figure 8-5  Back view of the device
1Telephone wall jack
2Use the phone cord supplied in the box with the device to connect to
the 1-LINE port
To set up the device with voice mail
1.Using the phone cord supplied in the box with the device, connect one end to your
telephone wall jack, then connect the other end to the port labeled 1-LINE on the
back of the device.
NOTE:If you do not use the supplied cord to connect from the telephone wall
jack to the device, you might not be able to fax successfully. This...

Set up the device with a computer dial-up modem
If you are using the same phone line for sending faxes and for a computer dial-up
modem, follow these directions for setting up the device.
Figure 8-6  Back view of the device
1Telephone wall jack
2Use the phone cord supplied in the box with the device to connect to
the 1-LINE port
3Computer with modem
To set up the device with a computer dial-up modem
1.Remove the white plug from the port labeled 2-EXT on the back of the device.
2.Find the phone cord that...

Set up the device with a computer DSL/ADSL modem
If you have a DSL line and use that phone line to send faxes, follow these instructions
to set up your fax.
1Telephone wall jack
2Parallel splitter
3DSL/ADSL filter
Connect one end of the phone jack that was supplied with the device
to connect to the 1-LINE port on the back of the device. Connect the
other end of the cord to the DSL/ADSL filter.
4Computer
5Computer DSL/ADSL modem
NOTE:You will need to purchase a parallel splitter. A parallel splitter has...

5.Connect the parallel splitter to the wall jack.
6.Run a fax test.
When the phone rings, the device automatically answers after the number of rings you
set in the Rings to Answer setting. The device begins emitting fax reception tones to
the sending fax machine and receives the fax.
Case H: Shared voice/fax line with computer modem
If you receive both voice calls and fax calls at the same phone number, and you also
have a computer modem connected on this phone line, set up the device as described
in...

• If your computer has one phone port, set up the device as described below.
Figure 8-8  Back view of the device
1Telephone wall jack
2Phone cord provided with the device plugged into the 1-LINE port on
the back of the device
3Parallel splitter
4Computer
5Telephone
To set up the device on the same phone line as a computer with one phone port
1.Remove the white plug from the port labeled 2-EXT on the back of the device.
2.Find the phone cord that connects from the back of your computer (your computer...