Getnet Router GR-534W User Manual

 
116 
 
 
- Registrar Mode 
Step1 Enter the Wi-Fi Protected Setup (STA) page of STA. On this page, Select 
the Registrar mode and set its parameters. You may apply the default 
registrar settings. After finishing setting, click the Submit button. 
Step2 On the Wi-Fi Protected Setup (STA) page of STA, enter the AP’s PIN 
code (31668569), and then click the PIN Start button.  

 
117 
 
 
Step3 On the Wi-Fi Protected Setup page of AP, click the Apply button under 
WPS Progress to make AP start to negotiate with STA.  

 
118 
 
 
Step4 After finish the negotiation process, system displays the Wi-Fi Protected 
Setup (STA) page as follows:  

 
119 
 
 
You may check whether WPS connection is successful by viewing the following 
pages. 
(1)  On the Station Link Status page of STA, you can view the current AP status. 
See the following figure:  

 
120 
 
 
(2)  On the Station List page of AP, you can view the STA in the Wireless Network 
list. 
 
 
 
 
5.5.9  About 
Click Wireless > About to display the Station About page.  

 
121 
 
 
On this page, you can view the AP’s driver version and MAC address. 
5.6   Firewall 
The following figure shows the navigation menu of Firewall: 
 
 
Firewall is an advanced setting, which is used to block or allow the data packets that 
pass through the AP. The sub-menus of the Firewall include Filtering, Forward, 
DMZ, System Security, and Content Filtering. 
5.6.1   Filtering 
Click Firewall > Filtering to display the MAC/IP/Port Filtering Settings page.  

 
122 
 
 
  Basic Settings 
 
 
The parameters of Basic Settings are described as follows: 
Field Description  

 
123 
Field Description 
MAC/IP/Port 
Filtering Enable or disable MAC/IP/Port filtering. The 
default setting is Disable. 
Default Policy  By default, AP will accept all the packets that do 
not match any rule. 
 
  MAC/IP/Port Filter Settings 
 
 
The filter modes of MAC/IP/Port Filter Settings are described as follows: 
Filter Mode Description 
MAC Filter  MAC filter can block the hosts on the local 
network to access the Internet. 
IP Filter  IP filter can block a user on the LAN to access the...

 
124 
When the data packets match the following parameters, the data packets will be 
discarded. 
The parameters of MAC/IP/Port Filter Settings are described as follows: 
Field Description 
MAC Address  The MAC addresses included in the data packets. 
It can be a destination MAC address or a source 
MAC address. 
Dest IP Address  The destination IP address. 
Source IP Address  The source IP address. 
Protocol The protocol types of data packets, includes TCP, 
UDP, and ICMP. 
Dest Port Range  The...

 
125 
Click Firewall > Forward to display the Virtual Server Settings page. 
 
 
 
 
 
 
 
 
 
 
 
  Virtual Server Settings