Home > Getnet > Router > Getnet Router GR-534W User Manual

Getnet Router GR-534W User Manual

Here you can view all the pages of manual Getnet Router GR-534W User Manual. The Getnet manuals for Router are available online for free. You can easily download all the documents as PDF.

Page 1

1  

Page 2

2 
CATALOG 
1 Overview ............................................................................................................ 1 
2 Hardware Description and Hardware Installation ............................................... 2 
2.1 Front Panel and LED Status .................................................................. 2 
2.2 Rear Panel and Interface Description ................................................... 3 
2.3 Hardware Installation...

Page 3

3 
5.3.4 DHCP Client ............................................................................. 42 
5.3.5 QoS ........................................................................................... 43 
5.4 Wireless Settings (Gateway Mode) ..................................................... 50 
5.4.1 Basic ......................................................................................... 51 
5.4.2 Advanced Settings .................................................................... 58...

Page 4

 
4 
About User Manual 
This user manual mainly describes how to install and configure the Getnet GR-534W 
wireless router. 
Organization 
The GR-534W User Manual is organized as follows: 
Chapter Description 
Chapter 1 : Overview  Provides a general overview of the 
GETNET GR-534W wireless router, and 
the package list. 
Chapter 2 : Hardware 
Description and Hardware 
Installation  Mainly describes the front panel and the 
rear panel of the GETNET GR-534W and 
the procedure for hardware installation....

Page 5

 
5 
   Support upgrading firmware version via Web page 
   Support restoring factory default settings 
   Support virtual server 
   Support DMZ (demilitarized zone) 
   Support DNS proxy and forwarding 
   Support setting QoS bandwidth, and generating rules based on protocol, 
port, IP, DSCP, or application 
   Support wireless security authentication modes, including Open, Shared, 
WEPAUTO, WPA-Enterprise, WPA-PSK, WPA2-Enterprise, WPA2-PSK, 
WPA-PSK/WPA2-PSK, WPA/WPA2-Enterprise, and Dynamic WEP...

Page 6

 
1 
1   Overview 
Thank you for choosing GETNET GR-534W. 
GETNET GR-534W is fully compatible with 802.11g standard. Meanwhile, it is also 
compatible with 802.11 standards and earlier 802.11b standards. GETNET GR-534W 
supports CCK and OFDM and its data rate is up to 150 Mbps. It is easy to install and 
can be applied to AP and router access. 
GETNET GR-534W provides 64-bit and 128-bit WEP encryption schemes, and WPA 
encryption, associating with IEEE 802.1X authentication, which insures the security...

Page 7

 
2 
2   Hardware Description and Hardware Installation 
2.1   Front Panel and LED Status 
There are 8 LED indicators on the front panel of GR-534W. By observing their 
status, you can judge whether the device runs normally. 
 
 
The following table describes the LED indicators on the front panel. 
LED 
Indicator 
Color StatusDescription 
 
 Red On Power is on. Green  On  The device runs normally. 
-  Off  Power is off or the device is down. 
 
 Green  On  Radio switch is turned on. Green Blink Data is...

Page 8

 
3 
Green  Blink  Negotiation is in progress under Wi-Fi 
Protected Setup. 
-  Off  Wi-Fi Protected Setup is disabled. 
WAN Green On Connection succeeds. 
Green Blink Data is being transmitted. 
- Off No WAN connection. 
LAN 
1/2/3/4 Green On LAN connection succeeds. 
Green Blink Data is being transmitted. 
- Off No LAN connection. 
 
2.2   Rear Panel and Interface Description 
 
 
The following table describes the interfaces or the buttons on the rear panel: 
Interface/Button Description 
RESET  Press...

Page 9

 
4 
accept the negotiation of PBC mode. 
 
Note: 
Do not press the Reset button unless you want to clear the current settings. The 
Reset button is in a small circular hole on the rear panel. If you want to restore the 
default settings, please press the Reset button gently for 3 seconds with a fine 
needle inserted into the hole and then release the button. The system reboots and 
returns to the factory defaults. 
Warning: 
The power specification is 12V, 500 mA. If the power adapter does not match the...

Page 10

 
5 
 
2.4   Operation Range 
The operation range of GR-534W depends on the actual environment. When the 
device is placed in the house or in the office, the overall arrangements are different. 
So the path and effect for the signal transmission are different. For example, the 
outdoor straight transmission distance for some devices in the open air is up to 300 
meters, and the indoor straight transmission distance is up to 100 meters. 
2.5   Roaming 
Suppose that several GR-534Ws run in the same...
Start reading Getnet Router GR-534W User Manual

Related Manuals for Getnet Router GR-534W User Manual

All Getnet manuals