Epson Projector EH-TW5650 User Manual

Introduction
10
ButtonFunction
nTurns the video and audio on or off. s  p.33
oSets the strength for Frame Interpolation.
s  p.36
pRegisters and loads a memory. s  p.41
qThe adjustment value returns to its default value
when pressed while the menu's adjustment
screen is displayed. 
s   p.64
rWhen a menu is displayed, it accepts and enters
the current selection and moves to the next lev-
el. 
s   p.64
sReturns to the previous menu level when a menu
is displayed. 
s  p.64
tAdjusts the volume. s  p.33...

Introduction
11
Rear
NameFunction
aPower inletConnect the power cord. s  p.25
bSpeakerThe projector's built-in  speaker. Outputs audio.
cRemote receiverReceives signals from the remote control. s  p.24
dAudio Out portOutputs audio during playback to the external speakers. s  p.19
eHDMI2 portConnects HDMI compatible video equipment and computers. s  p.18
fHDMI1/MHL portConnects HDMI compatible video equipment and computers. s  p.18
Also, connects MHL compatible  smartphones and tablets. 
s  p.18
gPC...

Introduction
12
Base
NameFunction
aCeiling mount fixing
points (three points)Attaches the optional ceiling mount here when suspending the projector from a
ceiling. 
s   p.98
bSecurity cable fittingThread a commercially available theft-prevention wire lock through this opening
to secure and lock the projector. 
cRear footWhen set up on a surface such as a table, extend the foot to adjust horizontal tilt.
s  p.29
dFront adjustable footWhen set up on a surface such as a table,  extend the foot to adjust the...

Preparing
13
Installing
Projected Image and Position of Projector
Install the projector as follows.
Installing in parallel with the screen
If the projector is installed at an angle to the scr een, keystone distortion occurs in the projected image.
Adjust the projector's position  so that it is installed in parallel with the screen.
c
If the projector cannot be installed in parallel, use one of the following methods to adjust the
projected image.
•Correct distortion in the image using the hori zontal...

Preparing
14
Various Setting Methods
Warning
•A special method of installation is required when suspending the projecto r from a ceiling (ceiling mount). If
it is not installed  correctly, it could  fall causing an accident and injury.
•If you use adhesives, lubricants, or oil on the ceiling mount fixing points to prevent screws from loosening,
or if you use things such as lubricants or oils on th e projector, the projector case may crack causing it to fall
from its ceiling mount. This could cause...

Preparing
15
Suspending from the ceiling and projecting
You can suspend the projector from the ceiling with the optional ceiling mount to project images.
c
When suspending from the ceiling and projecting, set  Projection to Front/Ceiling  or Rear/
Ceiling . 
s Extended - Projection   p.71
Projection Distance
The size of the projection increases as th e projector is moved away from the screen.
Use the table below to setup the projector at the opti mum position from the screen. The values given here
are...

Preparing
16
EH-TW5650/EH-TW5600Unit: cm
16:9 Screen SizeAB
Minimum (Wide) to Maximum (Tele) Vertical Lens Shift Highest to
Lowest
60" 133 x 75 176 to 286 -4 to +7
80" 177 x 100 235 to 382 -5 to +10
100" 221 x 125 295 to 478 -6 to +12
150" 332 x 187 443 to 719 -9 to +19
200" 443 x 249 591 to 959 -12 to +25
250" 553 x 311 740 to 1200 -16 to +31
300" 664 x 374 888 to 1441 -19 to +37
EH-TW5400Unit: cm
16:9 Screen SizeAB*
Minimum (Wide) to Maximum
(Tele)
60" 133 x 75 162 to...

Preparing
17
Installation example for EH-TW5650/EH-TW5600 (with 16:9 screen size and 100")
Side view
Overhead view 

Preparing
18
Connecting a Device
Attention
•Make cable connections before connecting to a power outlet.
•Check the shape of the cable's connector and the shape of the port,  and connect. If you force a connector of
a different shape into the port, it could cause damage and a malfunction to occur.
Connecting Video Equipment
To project images from DVD players and so on, connect to the projector using one of the following methods.
c
•Some types of video equipment are capable of output ting different...

Preparing
19
The connected smartphone or tablet begins charging when images are projected.
Attention
•Be sure to use an MHL compatible cable for making connections. If a cable that does not meet the MHL
standards is connected, the smartphone or tablet could  generate heat, cause a liquid leak, explode or generate
other conditions that could result in a fire.
•If you connect using a commercially available MHL-HDMI conversion adapter, charging the smartphone or
tablet may not work or you may not be able to...