Epson Projector BrightLink Pro 1430Wi User Manual

17. Place the markers at the bottom marker positions [2]. When angle adjustment is performed correctly,
the bottom pointers become solid colors. If the bottom pointers do not become solid colors, start
again from step 9.
18. When you have finished checking the marker positions, remove the markets and press the button on the remote control.
51   

The following confirmation screen is displayed:
52  

19. Trace the dots with your finger as shown. When angle adjustment is performed correctly, the traced
dots disappear.
Note: Finger touch operations may not function correctly if you are wearing bandages, artificial nails,
nail polish, or anything else that may obstruct your fingers.
20. When all of the dots have disappeared, press the press the button on the remote control and go to the next step.
If any dots remain (as shown below), do the following:
• Remove any obstacles from around the projected...

• If the dots still remain or there are obstacles that cannot be removed, such as whiteboard trays or
frames, go to step 21.
54  

21. If there is an obstacle that cannot be removed such as a whiteboard tray or frame, remove the tape
from the back of the supplied infrared deflectors and stick them to the screen so that the laser is not
reflected by the obstacle.
Make sure to stick the deflectors between the dots and the obstacle and adjust the number of
deflectors according to the number of dots.
Note: Do not remove an infrared deflector once is has been stuck in place. Do not stick tape or place
anything on the infrared deflectors....

23. Perform touch calibration by pressing the
Menubutton on the remote control. On the Extended
menu, select Easy Interactive Function, then select Touch Unit Setup. SelectTouch Calibration
and follow the instructions.
56 

24. After you have finished touch calibration, store the markers inside the Touch Unit.
57  

25. Attach the supplied labels to the tabs on either side of the Touch Unit. Match the center of the labels
with the tabs on the Touch Unit.
If the Touch Unit moves out of position, use the position of the labels to determine where to
reposition the Touch Unit.
58 

26. Attach the dial cover. Make sure to tighten the screw at the bottom of the cover.
Parent topic:
Setting Up the Projector
Related references
Touch Unit Safety Instructions
Related tasks
Calibrating for Finger Touch Interactivity
Using Finger Touch Operations
Installing the Projector Feet To use the projector on a table or cart, you first need to install the feet (BrightLink Pro 1420Wi). You can
then use the feet to adjust the image position.
1. Turn the projector upside down.
59  

2. Insert the larger front foot into the hole at the front of the projector.
1 Front foot (larger)
2 Rear feet
3. Insert the two smaller rear feet into the holes at the back of the projector.
Parent topic: Setting Up the Projector
Projector Connections You can connect the projector to a variety of computer, video, and audio sources to display
presentations, movies, or other images, with or without sound.
• Connect any type of computer that has a USB port, standard video output (monitor) port, or HDMI...