Epson AcuLaser C4200DN User Manual

Replacing Consumable Products311
9
9
9
9
9
9
9
9
9
9
9
9
Chapter 9 
Replacing Consumable Products
Replacement Messages
New
 :with
 LCD panel/quote
 the i
nformation f
rom t
he
 s
imilar
 productWhen you see the following messages on the LCD panel or the 
window of EPSON Status Monitor, replace the appropriate 
consumable products. You can continue to print for a short time 
after a message appears, but Epson recommends early 
replacement to maintain print quality and extend the life of your 
printer....

312Replacing Consumable Products
* T h e  l e t t e r s  C ,  M ,  Y ,  o r  K  a p p e a r  i n  t h i s  p o s i t i o n ,  i n d i c a t i n g  t h e  c o l o r  o f  t h e  t o n e r  to be replaced. For example, the message  Y Toner Low means that the 
amount of toner remaining in the yellow toner cartridge is low.
Note:
Messages appear for one consumable product at a time. After replacing 
a consumable product, check the LCD panel for replacement messages 
for other consumable products.
Toner...

Replacing Consumable Products313
9
9
9
9
9
9
9
9
9
9
9
9
❏Do not remove a toner cartridge until the  Replace Toner uuuu 
message appears on the LCD panel. Otherwise, the toner may 
spill.
❏ If you have moved a toner cartridge from a cool to a warm 
environment, wait for at least one hour before installing it to 
prevent damage from condensation.
w
Warning:
❏Do not touch the toner. Keep the toner away from your 
eyes. If toner gets on your skin  or clothes, wash it off with 
soap and water immediately.
❏...

314Replacing Consumable Products
2. Remove the top cover.
3. Turn the toner cartridge knobs to the unlocked position.
Note:
Hold the knobs with both hands.
 

Replacing Consumable Products315
9
9
9
9
9
9
9
9
9
9
9
9
4. Lift the toner cartridge out of the slot.Note:
❏A small amount of the toner ma y adhere to the bottom of the 
cartridge. Be careful not to spill this toner or get it on your skin 
or clothes.
❏ Put the used cartridge on a flat surface with the toner spout 
facing up to avoid spilling the toner.
❏ Dispose of the used toner cartridge  by putting it into its disposal 
bag.
 

316Replacing Consumable Products
5. Take the new toner cartridge out of its package, and gently 
shake it from side to side and front to back to distribute the 
toner evenly.
w
Warning:
Do not remove the protective tape yet.
6. Hold the new toner cartridge as shown below, and lower it  into the slot.
 

Replacing Consumable Products317
9
9
9
9
9
9
9
9
9
9
9
9
7. Turn the toner cartridge knob to the locked position.Note:
Hold the knobs with both hands  and turn them until they click.
c
Caution:
Be sure to turn the knob all the way to the locked position. 
Otherwise, you may have toner problems or leakage.
 

318Replacing Consumable Products
8. Remove the protective tape, pulling straight up from the toner 
cartridge. Make sure to pull the tape up slowly to avoid 
tearing it.
9. Replace the top cover.
Photoconductor Unit
Handling precautions
N ew :quote  t
he
 information
 from
 the s
imilar
 product
 

Replacing Consumable Products319
9
9
9
9
9
9
9
9
9
9
9
9
Always observe the following handling precautions when 
replacing the consumable products:
❏The photoconductor unit weighs 3.2 kg (7.1 lb). Be sure to hold 
it firmly by the handle when carrying it.
❏ When replacing the photoconductor unit, avoid exposing it 
to room light any longer than necessary. 
❏ Be careful not to scratch the surface of the drum (green roller) 
and rollers (black rollers), Also, avoid touching the drum, 
since oil from your...

320Replacing Consumable Products
2. Press the latch on cover A and open the cover.
3. Raise cover D.