Digital Projection Titan Sx+ 3d, Dual 3d, Titan Sx+ 3d, Dual 3d Ultra Contrast User Manual

Rev C  April 2011 Page 6.1
6. Maintenance
Contents
Changing the lamp module ........................................................................\
......................................6.2
Changing the air filters ........................................................................\
..............................................6.2
Cleaning ........................................................................\
........................................................................\
6.3...

Page 6.2 Rev C  April 2011
6. Maintenance Digital Projection TITAN sx+ 3D, Dual 3D, Ultra Contrast User Manual
Changing the air filters
The air filters should be changed only by authorised service personnel.
Contact your Digital Projection Dealer.
•
•
Changing the lamp module
The lamp module should be changed only by authorised service personnel.
Contact your Digital Projection Dealer.
•
•
Notes
 
Always allow the lamp to cool 
for 5 minutes before: 
- disconnecting the power  
- moving the projector....

Rev C  April 2011 Page 6.3
Digital Projection TITAN sx+ 3D, Dual 3D, Ultra Contrast User Manual 6. Maintenance
Notes
 Always allow the lamp to cool 
for 5 minutes before:
 - disconnecting the power  
- moving the projector.
  Never use strong detergents 
or solvents such as alcohol 
or thinners to clean the 
projector and lens.
Cleaning
Turn the projector off before cleaning.
Projector
Clean the cabinet periodically with a damp cloth. If heavily soiled, use\
 a mild 
detergent.
Lens
Use a blower or lens...

Page 6.4 Rev C  April 2011
6. Maintenance Digital Projection TITAN sx+ 3D, Dual 3D, Ultra Contrast User Manual 

Rev C  April 2011 Page 7.1
7. Appendix
Contents
Troubleshooting ........................................................................\
..........................................................7.2
Specifications ........................................................................\
..............................................................7.4
Part numbers ........................................................................\
............................................................7.4...

Page 7.2 Rev C  April 2011
7. Appendix Digital Projection TITAN sx+ 3D, Dual 3D, Ultra Contrast User Manual
Troubleshooting
problempossible solutions
The projector will not power up. Check that the mains plug is plugged in and that the mains supply is swi\
tched on.
Check any external fuses or breakers.
The projector shuts down after it has 
been in use for some time. The projector may be overheating. Check that the air inlets and outlets \
are clear 
of any obstruction. Check that the air filter is...

Rev C  April 2011 Page 7.3
Digital Projection TITAN sx+ 3D, Dual 3D, Ultra Contrast User Manual 7. Appendix
problempossible solutions
Severe flicker or motion artifacts If not using a 3D signal, check that 3D Enable is turned Off,
See section 4. Controlling the projector, Setup menu
3D images swapped Check that Left/Right swap is selected correctly in the 3D server.
Check the Frame Dominance and Sync Delay settings in the 3D menu.
Check the Sync Source setting in the 3D menu.
See Section 4. Controlling...

Page 7.4 Rev C  April 2011
7. Appendix Digital Projection TITAN sx+ 3D, Dual 3D, Ultra Contrast User Manual
Specifications
Part numbers
Projector
sx+ 3D  109-340
sx+ 3D Ultra Contrast 109-341
sx+ Dual 3D 109-334
sx+ Dual 3D Ultra Contrast 109-335
Rigging frame 107-956
Power cable 10A, Europe 102-163
Power cable 13A, North America 102-165
Power cable 10A, United Kingdom 102-180
Remote control 105-023
4x AAA batteries 105-922
3D Sync cable 109-697
Lens clamp 111-256
User manual on CD 105-923
Important...

Rev C  April 2011 Page 7.5
Digital Projection TITAN sx+ 3D, Dual 3D, Ultra Contrast User Manual 7. Appendix
Electrical
Inputs RGB1, RGB2, DVI-Single, SDI, Composite Video, S-Video, Component 
DVI-Single/Dual/Twin/3D
Pixel clock
  up to 165MHz
Control inputs 1 x 3D
  1 x LAN
 1 x wifi LAN
 1 x RS232 serial: 19200 baud, 8 bits, 1 stop bit, no parity
 1 x remote control
Indicators Input, 3D sync, Power, Shutter, Error, IR, Lamp 1, Lamp 2
Mains supply
Single  600W, 100-240VAC ±10%, 48-62Hz (single phase)...

Page 7.6 Rev C  April 2011
7. Appendix Digital Projection TITAN sx+ 3D, Dual 3D, Ultra Contrast User Manual
Lens Data
Optical105-607 ~ 107-195105-608105-609109-236 ~ 109-359 105-610 ~ 107-196
throw ratio 0.73 : 1 fixed1.2 : 1 fixed1.2 : 1 fixed1.26 - 1.61 : 1 zoom 1.5 - 2.02 : 1 zoom
full DMD image width 0.73 : 1
1.51 - 4.38m
(5 - 14.4ft)1.2 : 1 
2.5 - 12.5m
(8.2 - 41ft)1.2 : 1
1 - 1.67m
(3.3 - 5.5ft)1.26 : 1
2.38 - 11.9m
(7.8 - 39ft)
2.02 : 1
1.86 - 9.32m
(6.1 - 30.6ft) 1.5 : 1
2.67 - 16m
(8.8 -...