Land Rover Defender 90 110 Workshop Book 8 Bulletins Rover

,.... :, . h ,:. ..: .:- 1: ..I :,?; . .... 

LAND ROVER9OSTATION WAGON 
Rear side window trim. 
The  rear side trim on the  Land  Rover 90 is 
secured  in a similar  manner  to that of the 110 
station wagonSince the  fixings  are common, 
removal 
of the  inward  facing seats will release  the 
lower  attachment 
of the trim  to the  side  rail. The 
squab  frames 
of the individual  inward  facing seats 
are  each  attached  at  two points  to the side 
rail.The 
bench  type  seat  squabs  are also  secured  at two 
points. 
Rear quarter  light...

__ 
Grab handles. 
To  remove. 
1. Lift  the  plastic  finishers  to expose  the securing 
2. Remove  the four  screws to release  the grab 
screws. 
handle. 
I i STZ113M 
2 
Note:- In 
order  to remove  the trim  above 
the  door  between  the 
B and C post,on 
110 station wagons,  the B post trim  as 
well  as the  grab  handle  must 
be 
removed.The trim above  the door is held  by 
clips,the same  as used  for the  side  trim. 
To refit. 
4. Reverse instructions 1 and 2. 
HEADLAMPS. 
To remove  or...

f--- . Li .. - --s  

TABLE OF CONTENTS 
SECTION BOOK 
19fJ 
m 
Introduction ........................................................................\
.............................. 
General Specification  Data ........................................................................\
........... L1 
........................... m Engine Tuning  Data ..\>. ............................................................. U 
........................................................................\
............. Torque  Wrench...

Section 
Number 
BOOK ONE CONTENTS 
Page 
- Repairs and replacement  parts 
-Poisonous substances 
-Fuel handling precautions 
-Fuel tank draining  and repair 
- Service  tools 
- Location  of vehicle  identification  numbers 
1041 GENERAL SPECIFICATION DATA 
3 
- V8 engine data 
- 2.25 litre petrol  engine  data 
-2.25 litre diesel cngine data 
- 2.50 litre  diesel  engine  data 
- General  data - all models 
-Tyre pressures 
-Replacement bulbs and units 
- Vehicle wcights 
* -2.25 litre petrol  engine...

Book One Contents (contd) 
07 GENERAL FITTING INSTRUCTIONS 
-Precautions  against damage 
- Safety precautions 
091 RECOMMENDED  LUBRICANTS, FLUIDS AND CAPACITIES i 
1 
1 
. 
10 
-Preparation  and dismantling 1 
MAINTENANCE 
- Inspection  of components 
-Ball  and roller  bearings 
- Oil seals 
-Joints  and joint  faces 
-Flexible  hydraulic  pipes and hoses 
- Metric  bolt identification 
-Metric  nut identification 
- Hydraulic  fittings 
- Keys and keyways 
-Tab washers,  split pins,  nuts and locking...