Christie Projector Roadster, Matrix WU, Mirage S+/HD/WU User Manual

 Operation 
Roadster, Matrix WU, Mirage S+/HD/WU User Manual 3-77 020-100002-05 Rev. 1 (02-2010) 
3.   Working with one projector at a time, use the center brightness slide bar to adjust 
the center brightness (brightness of the non-blended region) so that the center 
intensity matches that of the brightest blended region (the center of all images 
when blending a 2 x 2 display is the target area). 
4.   Use the following three color slide bars, Black Red Level, Black Green Level 
and Black Blue Level,...

Operation  
3-78 Roadster, Matrix WU, Mirage S+/HD/WU User Manual  020-100002-05 Rev. 1 (02-2010) 
The default login provides access to security settings, where you can define other 
users with the same or fewer rights. Use “unlimited” rights for most applications. For 
all logins, the Service menu is still protected with its own password. 
NOTES: 1) Any proxy server settings that interfere with this type of link should be 
disabled for using ChristieNET. Disable through Internet Explorer’s < Tools> 
  ....

 Operation 
Roadster, Matrix WU, Mirage S+/HD/WU User Manual 3-79 020-100002-05 Rev. 1 (02-2010) 
Bad Sync 
The message “Bad Sync” occurs when HSYNC or VSYNC are active but the signal 
cannot be displayed. Such a condition occurs when only one of the two sync signals 
is present, or when either sync signal is unstable or of the wrong frequency. Correct 
the signal or select another input. 
Other Signal Error Messages 
In addition to the common “Bad Sync” and “No Signal” errors, you may encounter a...

Operation  
3-80 Roadster, Matrix WU, Mirage S+/HD/WU User Manual  020-100002-05 Rev. 1 (02-2010) 
Table 3.4. System Error Codes 
Code DescriptionGENERAL 12  Software error. Contact dealer/factory.13  CRC error in flash ROM. Download new software.14  Engineering-only programming is complete. Call Christie, replace TIPM. 15 Attempting to download s/w code without being in boot mode16  Invalid interrupt. Power off/on. If persists, contact dealer/factory.17  User has forced system to stay in boot mode18...

Section 4 
Maintenance 
 
Roadster, Matrix WU, Mirage S+/HD/WU User Manual 4-1 020-100002-05 Rev. 1 (02-2010) 
 
This projector is safety agency approved and is designed for safe and reliable 
operation. However, safe operation cannot be assured by design alone; installers, 
maintainers, and users must maintain a safe operating environment for the system. 
Please read through and understand the following warnings and guidelines promoting 
safe usage of the projector. 
 WARNING  
Always power down the...

Maintenance  
4-2 Roadster, Matrix WU, Mirage S+/HD/WU User Manual  020-100002-05 Rev. 1 (02-2010) 
Refer to your model and part number below for the specified replacement item and 
the recommended time to replace the item. NOTE: Refer to the Service Manual for 
replacement item part numbers. 
 
Replacement Item Time Interval (hrs) 
Air Filter 
2.0 kW lamp module 
3.0 kW lamp module 
All DC fans 
AC blower fan
 
1,000 
1,000 – 1, 200 
1,000 – 1, 200 
500 - 750 
10,000 
 
 
HD Projectors >10,000 lumens...

 Maintenance 
Roadster, Matrix WU, Mirage S+/HD/WU User Manual 4-3 020-100002-05 Rev. 1 (02-2010) 
 
Projectors that are positioned too closely to one another, too close to a wall or other 
structures are restricted from the amount of cool air needed to operate without 
overheating. Without proper airflow, the hot exhaust air can circulate the projector 
and be sucked back in through the intake vents causing it to overheat. See the 
illustration below to ensure your projector installation meets the...

Maintenance  
4-4 Roadster, Matrix WU, Mirage S+/HD/WU User Manual  020-100002-05 Rev. 1 (02-2010) 
 WARNING  
Use only lamps supplied by Christie. Use lamps of the correct 
wattage for your projector model when replacing. 
 WARNING  
Use Christie approved filters ONLY. 
FILTER:  Replace the filter when you replace the lamp or sooner if required. It is 
important the filter be replaced regularly to ensure sufficient airflow through the 
projector, otherwise it could cause the projector to overheat. 
See...

 Maintenance 
Roadster, Matrix WU, Mirage S+/HD/WU User Manual 4-5 020-100002-05 Rev. 1 (02-2010)  
If any of the following conditions exist, immediately unplug the projector from the 
power outlet and contact your Christie dealer. 
 The power cord has been damaged. 
 The internal cooling fans do not turn on within two minutes when the projector is 
first powered up.  
 Liquid has been spilled into the projector. 
 The projector has been exposed to excessive moisture. 
 The projector is not...

Maintenance  
4-6 Roadster, Matrix WU, Mirage S+/HD/WU User Manual  020-100002-05 Rev. 1 (02-2010) 
Part Description Frequency Action 
Lamp  
 
 
 
 
 
 
 
 
 
 
   
 As required CLEAN (GLASS ONLY): Clean if 
absolutely necessary. Never touch the glass 
surface of the lamp. Fingerprints left on the 
glass will seriously degrade lamp 
performance or cause “hotspots” which can 
lead to an accumulation of intense heat in 
the touched area and cause the lamp to 
shatter. 
To clean:
 Wait until lamp is cool....