Christie Projector Roadster, Matrix WU, Mirage S+/HD/WU User Manual

Section 5 
Troubleshooting 
 
Roadster, Matrix WU, Mirage S+/HD/WU User Manual 5-1 020-100002-05 Rev. 1 (02-2010)  
If the projector does not appear to be operating properly, note the symptoms present 
and use the following guide to assist you. If you cannot resolve the problems 
yourself, contact your dealer for assistance. 
NOTE: A Christie accredited service technician
 is required when opening the 
projector to diagnose any “probable cause”. 
 
 
 
Blank screen, no display of image… 
1. Confirm all...

Troubleshooting  
5-2 Roadster, Matrix WU, Mirage S+/HD/WU User Manual    020-100002-05 Rev. 1 (02-2010) 
The display is jittery or unstable… 
1. If the display is jittery or blinking erratically, ensure that the source is properly 
connected and of adequate quality for detection. With a poor quality or 
improperly connected source, the projector will repeatedly attempt to display an 
image, however briefly. 
2. The horizontal or vertical scan frequency of the input signal may be out of range 
for the...

 Troubleshooting 
Roadster, Matrix WU, Mirage S+/HD/WU User Manual 5-3 020-100002-05 Rev. 1 (02-2010) 
Values in Color Saturation slidebars vary over time 
1. Once defined, Color Saturation slidebar values fluctuate over time and will likely 
be different upon subsequent visits to this menu. This is normal and should be 
ignored, as these changes do not redefine the x/y coordinates or color gamut. 
The display is not rectangular… 
1. Check leveling of the projector. Ensure the lens surface and the screen...

Troubleshooting  
5-4 Roadster, Matrix WU, Mirage S+/HD/WU User Manual    020-100002-05 Rev. 1 (02-2010) 
1. Ensure the Ethernet settings are valid for your site—all network devices should 
have the same subnet mask and unique IP addresses. 
2. Ensure the projector is connected to a network before you attempt to change its 
IP address, and always cycle power (off-on) to implement the new IP address. 
3. Ensure address changes have been saved, and re-boot to implement.  
4. If you still have trouble...

Section 6 
Specifications 
 
Roadster, Matrix WU, Mirage S+/HD/WU User Manual 6-1 020-100002-05 Rev. 1 (02-2010) 
 
NOTE: 1) Due to continuing research, specifications are subject to change without 
notice. 2) 3D available in Mirage series only. 
Panel Resolution and Refresh Rate 
Pixel format (H x V) on 3 DMDs 
 1400 x 1050 (SXGA+) 
1920 x 1080 (HD) 
1920 x 1200 (WUXGA) 
Refresh rate 
 Roadster HD Series 
 Roadster S+ Series 
 Mirage S+ 14K 
 Mirage HD 
 Matrix WU 
 Mirage WU  
23.97 – 120 Hz...

Specifications  
6-2 Roadster, Matrix WU, Mirage S+/HD/WU User Manual  020-100002-05 Rev. 1 (02-2010)  Blue  0.145 ±0.020  0.065 ±0.025 
 
Lens Offsets   

 
NOTES: 1) 0% offset is equal to half the image above and below lens center OR half the image to the left or right of lens 
center. 2) Offsets are subject to a 
 7% centering tolerance. 
 
Roadster/HD Series 
 
 
Matrix Series 
 
Mirage Series 
 Five standard inputs including a Dual 
SD/HD-SDI 
One input module slot 
Four standard inputs 
Two...

 Specifications 
Roadster, Matrix WU, Mirage S+/HD/WU User Manual 6-3 020-100002-05 Rev. 1 (02-2010) 
 
Analog: Video 
(INPUTS 3 and 4) 
Signal formats  Composite-video (CVBS), S-Video (Y/C) 
Connectors 
• Composite Video 
(INPUT 3) 
• S-Video (INPUT 4)  
BNC 
4-pin miniature DIN 
Video standards  NTSC, NTSC 4.43, PAL, PAL-M, 
PAL-N, PAL-60 & SECAM 
A/D conversion resolution  8-bit 
Input levels 
   Composite 
    S-Video, Luma (Y) 
    S-Video, Chroma ©  
1.0 V
p-p  ± 3dB (including sync tip) 
1.0 Vp-p...

Specifications  
6-4 Roadster, Matrix WU, Mirage S+/HD/WU User Manual  020-100002-05 Rev. 1 (02-2010) 
Remote Keypad 
Keypad Type  IR with cable for converting to wired 
Connector type*  3.5 mm phono jack (2) 
Input levels  • High = 2.2 V – 5.6 V (or open) 
• Low = -0.6V – 0.9V @ 1mA 
Voltage output  +5VDC ±5%  
Current output  100 mA nominal, 250 mA max. 
* The Roadster “Brick” rental staging – Standard IR Remote includes a 3.5mm phono 
jack and a three-pin connector.
 
IR Remote Sensors 
Number of IR...

 Specifications 
Roadster, Matrix WU, Mirage S+/HD/WU User Manual 6-5 020-100002-05 Rev. 1 (02-2010) 
General  
  Voltage rating  200 – 240 VAC ±10%  
  Line frequency rating  50 – 60 Hz 
  Inrush current rating  60 A max. 
 Current rating 
(@ 200VAC) 
Roadster S+12K 
Roadster HD12K 
Matrix WU12 
Mirage HD12 
Mirage WU12 
Roadster S+16K 
Mirage S+14K 
Mirage HD18 
Mirage WU18 
Roadster HD18K 
Roadster S+ 20K  
12 A 
12 A 
12 A 
12 A 
12 A 
16 A 
16 A 
24 A 
24 A 
24 A 
24 A 
  
Max. power consumption...

Specifications  
6-6 Roadster, Matrix WU, Mirage S+/HD/WU User Manual  020-100002-05 Rev. 1 (02-2010)  Line Cords (3 conductors) 
Roadster S+12K 
Roadster HD12K 
Matrix WU12 
Mirage HD12 
Mirage WU12 
Roadster S+16K 
Mirage S+14K 
Mirage HD18 
Mirage WU18 
Roadster HD18K 
Roadster S+ 20K  
Heavy duty, 14 AWG 
Heavy duty, 14 AWG 
Heavy duty, 14 AWG 
Heavy duty, 14 AWG 
Heavy duty, 14 AWG 
Heavy duty, 12 AWG 
Heavy duty, 12 AWG 
Heavy duty, 12 AWG 
Heavy duty, 12 AWG 
Heavy duty, 12 AWG 
Heavy duty, 12 AWG...